ZyXEL Communications GS-105A Manuale utente
GS-105/GS-108
Gigabit Switch
User’s Guide
Version 1.0
April 2003
GS-105/GS-108 Gigabit Switch
iii
Interference Statements and Warnings
FCC Interference Statement
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operations.
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
CE Mark Warning
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
Taiwanese BSMI (Bureau of Standards,
Metrology and Inspection) A Warning
Certifications
Refer to the product
page at
www.zyxel.com.
GS-105/GS-108 Gigabit Switch
iv
ZyXEL Limited Warranty
ZyXEL warrants to the original end user (purchaser) that this product is
free from any defects in materials or workmanship for a period of up to
two (2) years from the date of purchase. During the warranty period and
upon proof of purchase, should the product have indications of failure due
to faulty workmanship and/or materials, ZyXEL will, at its discretion,
repair or replace the defective products or components without charge for
either parts or labor and to whatever extent it shall deem necessary to
restore the product or components to proper operating condition. Any
replacement will consist of a new or re-manufactured functionally
equivalent product of equal value, and will be solely at the discretion of
ZyXEL. This warranty shall not apply if the product is modified, misused,
tampered with, damaged by an act of God, or subjected to abnormal
working conditions.
Note
Repair or replacement, as provided under this warranty, is the exclusive
remedy of the purchaser. This warranty is in lieu of all other warranties,
express or implied, including any implied warranty of merchantability or
fitness for a particular use or purpose. ZyXEL shall in no event be held
liable for indirect or consequential damages of any kind of character to the
purchaser.
To obtain the services of this warranty, contact ZyXEL's Service Center
for your Return Material Authorization number (RMA). Products must be
returned Postage Prepaid. It is recommended that the unit be insured when
shipped. Any returned products without proof of purchase or those with an
out-dated warranty will be repaired or replaced (at the discretion of
ZyXEL) and the customer will be billed for parts and labor. All repaired
or replaced products will be shipped by ZyXEL to the corresponding
return address, Postage Paid. This warranty gives you specific legal rights,
and you may also have other rights that vary from country to country.
GS-105/GS-108 Gigabit Switch
1
Getting to Know Your Switch
Introduction
The switch is a multi-port switch that can be used to build high-
performance switched networks. The switch is a store-and-forward device
that offers low latency for high-speed networking. The switch is designed
for SOHO (Small Office Home Office) businesses.
Standalone Workgroup Application
The switch can be used as a standalone switch to which computers, servers
and print server are directly connected to form a small workgroup.
Standalone Workgroup Example
Hardware Installation and Connection
The switch is suitable for an office environment where it can be placed on
a desktop.
GS-105/GS-108 Gigabit Switch
2
Desktop Installation
Step 1. Make sure the switch is clean and dry.
Step 2. Set the switch on a smooth, level flat space strong enough to
support the weight of the switch and the connected cables.
Make sure there is a power outlet nearby.
Step 3. Use the supplied power adapter to connect your switch to a
power source. Refer to the label on the power adapter for more
information.
Do not block the ventilation holes.
Rear Panel Power Connection
Connect one end of the supplied power adaptor to the power port on the
rear panel of the switch and the other end to the appropriate power source.
The PWR LED turns on.
Port Connection
For GS-105, the Ethernet ports are located on the rear panel. For GS-108,
the Ethernet ports are located on the front panel.
Figure 1 Rear Panel: GS-108
Figure 2 Rear Panel: GS-105
GS-105/GS-108 Gigabit Switch
3
RJ-45 Auto-negotiating Ports
Your switch comes with 5 or 8 10/100/1000M RJ-45 ports depending on
the model of your switch. The auto-negotiation feature allows the switch
to detect the speed of incoming transmission and adjust appropriately
without manual intervention. It allows data transfers of 10 Mbps, 100
Mbps or 1000 Mbps in either half-duplex or full-duplex mode depending
on your Ethernet network.
Auto-sensing (MDI/MDIX) Ethernet Ports
Each Ethernet port allows you to connect to a computer or to a hub using
either a straight-through or a crossover Ethernet cable.
The following table describes the types of network cable used for the
different connection speeds.
Table 1 Ethernet Cable Type
SPEED NETWORK CABLE TYPE
10 Base-T 100Ω2-pair UTP/STP Category 3, 4 or 5
100 Base-TX 100Ω2-pair UTP/STP Category 5
1000 Base-T 100Ω4-pair UTP/STP Category 5
Cable length between connections must not
exceed 100 meters (328 feet).
Front Panel LEDs
The LEDs on the front panel indicate the real-time status of the switch.
Figure 3 Front Panel LED: GS-108
The following table gives descriptions of the LEDs.
GS-105/GS-108 Gigabit Switch
4
Table 2 Front Panel LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR Green On The switch is on and receiving power.
Off The switch is not receiving power.
100/1000 Green On The port is operating at 1000Mbps.
Off The port is operating at 10Mbps or no device is attached.
Orange On The port is operating at 100Mbps.
Off The port is operating at 10Mbps or no device is attached.
LNK/ACT Green On The port is connected to an Ethernet network.
Off The port is not connected to an Ethernet network.
Blinking The port is receiving or transmitting data.
Orange On The port is operating in full-duplex mode.
Blinking Packet collision occurred on this port.
FDX/COL
Off The port is operating in half-duplex mode or no Ethernet
device is connected to this port.
Altri manuali per GS-105A
4
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali ZyXEL Communications Interruttore
ZyXEL Communications
ZyXEL Communications VES-1616F-34 Manuale utente
ZyXEL Communications
ZyXEL Communications XGS-4728F Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension ES-3148 Manuale di istruzioni
ZyXEL Communications
ZyXEL Communications VDSL SWITCH VES-1616F-3X Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension ES-2008 Manuale utente
ZyXEL Communications
ZyXEL Communications ES1100-16 Manuale utente
ZyXEL Communications
ZyXEL Communications GS1200-5HP v2 Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension ES-4124 Manuale di istruzioni
ZyXEL Communications
ZyXEL Communications GS2210-8 Manuale utente
ZyXEL Communications
ZyXEL Communications IES-5000 Series Manuale
ZyXEL Communications
ZyXEL Communications Dimension ES-4124 Manuale utente
ZyXEL Communications
ZyXEL Communications ES-2048 Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension GS-1116 Manuale utente
ZyXEL Communications
ZyXEL Communications BPS-120 Manuale
ZyXEL Communications
ZyXEL Communications GS-105A Manuale utente
ZyXEL Communications
ZyXEL Communications GS1100 Series Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension GS-2024 Manuale utente
ZyXEL Communications
ZyXEL Communications XS3800-28 Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension Ethernet Switches Manuale utente
ZyXEL Communications
ZyXEL Communications Dimension GS-2024 Guida di riferimento
