A2Z Ozone Aquatic 2 Manuale utente
Aquatic 2
Operating Manual
*Register your product at a2zozone.com/pages/warranty
Produced for and
Distributed by:
A2Z Ozone, Inc.
Louisville, KY 40299 USA
EPA Est.: 95432-KY-1
Phone: 1+502-499-4977
Active Ingredient: Ozone.
Warning: Do Not Inhale
Ozone. Keep Out of Reach
of Children.
Produced by:
Bluegrass Water
Technology
Shenzhen Co., Ltd
EPA Est.: 95432-CHN-1
Made in China
Version 1.2.3
1
Table of Contents
Important Safety Information .................................................................. 2
Technical Specifications ............................................................................ 3
Aquatic 2 Features ..................................................................................... 5
Installation Instructions ........................................................................... 6
Wiring Diagram ........................................................................................ 8
Operating Instructions .............................................................................9
Maintenance ............................................................................................ 10
Troubleshooting ...................................................................................... 11
Warranty .................................................................................................. 12
IMPORTANT:
WARNING: Do Not Inhale Ozone. Ozone Can Damage Lungs if Inhaled. Remove
Immediately to Fresh Air if exposed. Keep Out of Reach of Children. Hazards
to Humans and Domestic Animals--Do Not Expose Children, People, Pets, Plants
or Valuables to Ozone. Ozone Health lnformation -- If exposed to ozone, get to
fresh air immediately. Seek doctor’s advice if exposed to ozone. HIGH VOLTAGE!
Perform service on ozone generator by certied technicians only! For your safety,
do not store or use gasoline, chemicals or other ammable liquids or vapors near
this or any other appliance. NOTE: Use Only As Directed. Follow All Instructions
Provided in the Manual. Buyer will assume all responsibility for installation, running
and use not in accordance with direction.
2
Important Safety Information
Read and follow this owner’s manual carefully for
important installation, operation and safety information.
Always follow basic safety precautions, including but not limited to the
following:
• All electrical connections should be made by a qualified electrician.
• Follow all applicable electrical codes.
• Be sure the electrical power is shut OFF at the main circuit breaker
before installing the ozone generator.
• If the ozone generator electrical connection is to be attached to
spa controls, be sure the spa controls are protected by a Ground
Fault Circuit Interrupter (GFCI). If the Aquatic 2 is connected to an
independent electrical supply, have a qualified electrician install a
GFCI between the ozone generator and the electrical supply.
• Do not bury the cord.
WARNING – To reduce the risk of electrical shock, replace damaged
cord immediately.
• Per UL spa requirements, the Aquatic 2 must be mounted indoors or
under a cover sheltered from the elements (rain, sun, sprinklers).
• Never attempt servicing when you are wet.
• To reduce the risk of injury, mount the unit where it is inaccessible
to children.
• Plastic ozone supply tubing is available with the Aquatic 2. Never
replace this tubing with metal tubing.
• Do not operate the Aquatic 2 unless sufficient air flow is accessible
to the unit.
• The use of ozone test strips or dissolved ozone monitor is required.
•
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Caution: In case of accidental leakage, install the ozone generator in a
well-ventilated area.
3
Technical Specications
Model Aquatic 2
Electric 85-250 VAC, 50/60 Hz
Power 6 W
Ozone Output 300 mg/hour*
Size 3.6 x 2.5 x 5.7 inches
92 x 62 x 146 millimeters
Weight .74 lbs
330 grams
Connection AMP Model
Cable 5.5 feet
Check Valve ¼ inch
Tube 5 feet
*Aquatic 2 ozone output is standardized with 1 LPM oxygen ow rate. Because this
unit is run by air, actual ozone concentration is 0.6 mg/L only. Note, the Aquatic 2 does
not have an oxygen hookup.
4
1
2
3
4
Figure 1
(bottom of Unit)
Aquatic 2 Features
1Air Intake Allows air that is needed for producing ozone to pass over
the ozone cell. DO NOT BLOCK
2Power LED Indicates when there is power to the unit. If the power is
supplied, the light will remain a solid red.
3O3Output Ozone leaves the unit through this port.
4Power Cable This cable supplies power to the ozone generator.
5
6
Installation Instructions
Installation Parts
• Aquatic 2 Ozone Generator
• Aquatic 2 user manual
• 1 check valve
• 5 feet of tubing
• 4 hose ties
• 2 screws and plastic anchor for mounting
Required Installation Tools and Materials
• Phillips screwdriver
• Pliers
Unit Assembly
• The Aquatic 2 is pre-assembled and ready to install.
Mounting
• Mount the ozone generator as high as possible.
• Screws are provided for mounting but may not be appropriate for all
surfaces. Substitute proper mounting hardware as required.
Electrical
• Test the GFCI breaker.
• Connect the Aquatic 2 cord to the mating connector(s) on the control
box according to the provided A2Z OzoneTM wiring diagram in Figure
2.
• Where possible, route the power cord away from other electrical
lines. Do not run the power cord parallel to any low voltage signal
wires. Secure the power cord to prevent damage.
7
Operation
• Verify that the ozone generator turns on and off as required by the
controller.
• The red LED light will be visible from the viewing window on the
bottom left.
• Verify that the gas is flowing into the injector.
• Verify that water does not push passed the check valve.
• Check for and correct any leaks.
Installation Complete
• Once properly installed, the ozone generator requires no further user
operation.
• It will operate automatically with the spa system.
8
Wiring Diagram
The unit ships with the wiring as shown. The voltage for either 110V or
240V can be applied to the black and white wires. Match the alignment
of the white wire of the ozone generator connector with the controller
box connector. Keep in mind, the white wire can be moved. Mount the
unit so that the tube, light and wires are toward the ground. Disregard
the front label.
Figure 2
9
Please make sure water will not back into the Aquatic 2 Ozone Generator.
Water will damage the unit and void the warranty.
Please check these:
• Install the Aquatic 2 above water level and as high as possible.
• Mount the unit so the tube, light and wires are toward the ground.
Disregard front label.
• Install the check valve according to the arrow on the check valve.
The arrow is toward the injector.
• You need an injector for injecting ozone into the spa’s water line.
• If you do not have a venturi injector, please contact us to purchase
one.
• This unit does not work without a venturi injector.
• There should be a vacuum at ozone injector suction location.
• This can be felt with your finger when installing.
• Ozone generator should be on only when the spa pump is on.
• If your spa did not have an ozonator, then connect ozone electric
wire to pump wires.
Operating Instructions
Indice
Altri manuali A2Z Ozone Generatore portatile
