Acer V70MA Istruzioni per l'installazione

90$6\VWHP%RDUG

User’s Guide

&RS\ULJKW

this publication may be reproduced, transmitted, transcribed, stored in

a retrieval system, or translated into any language or computer

language, in any form or by any means, electronic, mechanical,

magnetic, optical, chemical, manual or otherwise, without the prior

written permission of this company.

'LVFODLPHU

This company makes no representations or warranties, either

expressed or implied, with respect to the contents hereof and

specifically disclaims any warranties, merchantability or fitness for any

particular purpose. Any software described in this manual is sold or

licensed "as is". Should the programs prove defective following their

purchase, the buyer (and not this company, its distributor, or its dealer)

assumes the entire cost of all necessary servicing, repair, and any

incidental or consequential damages resulting from any defect in the

software. Further, this company reserves the right to revise this

publication and to make changes from time to time in the contents

hereof without obligation to notify any person of such revision or

changes.

All brand and product names mentioned in this manual are trademarks and/or

registered trademarks of their respective holders.

iii

,03257$176$)(7<

,16758&7,216

1. Read these instructions carefully. Save these instructions for

future reference.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the wall outlet before cleaning. Do not

use liquid cleaners or aerosol cleaners. Use a damp cloth for

cleaning.

4. Do not use this product near water.

5. Do not place this product on an unstable cart, stand, or table.

The product may fall, causing serious damage to the product.

6. Slots and openings in the cabinet and the back or bottom are

provided for ventilation; to ensure reliable operation of the product

and to protect it from overheating, these openings must not be

blocked or covered. The openings should never be blocked by

placing the product on a bed, sofa, rug, or other similar surface.

This product should never be placed near or over a radiator or

heat register, or in a built-in installation unless proper ventilation is

provided.

7. This product should be operated from the type of power indicated

on the marking label. If you are not sure of the type of power

available, consult your dealer or local power company.

8. This product is equipped with a 3-wire grounding-type plug, a plug

having a third (grounding) pin. This plug will only fit into a

grounding-type power outlet. This is a safety feature. If you are

unable to insert the plug into the outlet, contact your electrician to

replace your obsolete outlet. Do not defeat the purpose of the

grounding-type plug.

9. Do not allow anything to rest on the power cord. Do not locate

this product where persons will walk on the cord.

10. If an extension cord is used with this product, make sure that the

total ampere rating of the equipment plugged into the extension

cord does not exceed the extension cord ampere rating. Also,

make sure that the total rating of all products plugged into the wall

outlet does not exceed 15 amperes.

11. Never push objects of any kind into this product through cabinet

slots as they may touch dangerous voltage points or short out

parts that could result in a fire or electric shock. Never spill liquid

of any kind on the product.

12. Do not attempt to service this product yourself, as opening or

removing covers may expose you to dangerous voltage points or

other risks. Refer all servicing to qualified service personnel.

13. Unplug this product from the wall outlet and refer servicing to

qualified service personnel under the following conditions:

a. When the power cord or plug is damaged or frayed

b. If liquid has been spilled into the product

c. If the product has been exposed to rain or water

d. If the product does not operate normally when the operating

instructions are followed. Adjust only those controls that are

covered by the operating instructions since improper

adjustment of other controls may result in damage and will

often require extensive work by a qualified technician to

restore the product to normal condition.

e. If the product has been dropped or the cabinet has been

damaged

f. If the product exhibits a distinct change in performance,

indicating a need for service

14. Replace the battery with the same type as the product's battery

we recommend. Use of another battery may present a risk of fire

or explosion. Refer battery replacement to a qualified

serviceman.

15. Warning! The battery may explode if not handled properly. Do

not recharge, disassemble, or dispose of it in fire. Keep away

from children and dispose of any used battery promptly.

16. Use only the proper type of power supply cord set (provided in

your keyboard/manual accessories box) for this unit. It should be

a detachable type: UL listed/CSA certified, type SVT/SJT, rated

6A 125V minimum, VDE approved or its equivalent. Maximum

length is 15 feet (4.6 meters).

&'5206DIHW\:DUQLQJ

DANGER

INVISIBLE RADIATION WHEN OPEN.

AVOID EXPOSURE TO BEAM.

VORSICHT

UNSICHTBARE LASERSTRAHLUNG WENN GEÖFFNET.

NICHT IN DEN STRAHL SEHEN.

ATTENTION

RADIATION DU FAISCEAU LASER INVISIBLE. EN CAS

D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYONS.

VARO

AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE

LASERSÄTEILYLLE ÄLÄ KATSO SÄTEESEEN.

VARNING!

OSYNLING LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD.

BETRAKTA EJ STRÄLEN.

VARNING

OSYNLING LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD.

STIRRA EJ IN I STRÄLEN.

ADVARSEL

LASERSTRÄLING VED ÄBNING. SE IKKE IND I STRÄLEN.

CLASS 1 LASER PRODUCT

APPAREIL A LASER DE CLASSE 1

LASER KLASSE 1

LOUKAN 1 LASERLAITE

PRODUIT LASER

CATEGORIE 1

vii

&DXWLRQRQ/LWKLXP%DWWHULHV

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only

with the same or equivalent type recommended by the manufacturer.

Discard used batteries according to the manufacturer’s instructions.

ADVARSEL!

Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering.

Udskiftning må kun ske med batteri af samme fabrikat og type.

Léver det brugte batteri tilbage til leverandøren.

ADVARSEL

Eksplosjonsfare ved feilaktig skifte av batteri.

Benytt samme batteritype eller en tilsvarende

type anbefalt av apparatfabrikanten.

Brukte batterier kasseres i henhold til fabrikantens instruksjoner.

VARNING

Explosionsfara vid felaktigt batteribyte.

Anvãnd samma batterityp eller en ekvivalent typ som

rekommenderas av apparattillverkaren.

Kassera anvãnt batteri enligt fabrikantens instruktion.

VAROITUS

Päristo voi räjähtää, jos se on virheellisesti asennettu.

Vaihda paristo ainoastaan laitevalmistajan suosittelemaan tyyppiin.

Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.

VORSICHT!

Explosionsgefahr bei unsachgemäßen Austausch der Batterie Ersatz

nur durch denselben oder einem vom Hersteller empfohlenem

ähnlichen Typ. Entsorgung gebrauchter Batterien nach Angaben des

Herstellers.

viii

)&&&ODVV%5DGLR)UHTXHQF\

,QWHUIHUHQFH6WDWHPHQW

Note:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

4. Consult the dealer or an experienced radio/television technician

for help.

Notice 1:

The changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

Notice 2:

Shielded interface cables, if any, must be used in order to comply with

the emission limits.

$ERXWWKLV0DQXDO

Purpose

This user’s guide aims to give you all the necessary information about

the system board, such as system board layout, onboard components,

jumper settings, cache and memory configurations, and other internal

devices.

Conventions

The following are the conventions used in this manual:

NOTE

Gives bits and pieces of additional

information related to the current

topic.

WARNING

Alerts you to any damage that

might result from doing or not doing

specific actions.

CAUTION

Gives precautionary measures to

avoid possible hardware or

software problems.

IMPORTANT

Reminds you to do specific actions

relevant to the accomplishment of

procedures.

TIP

Tells how to accomplish a

procedure with fewer steps through

little shortcuts.

7DEOHRI&RQWHQWV

1 Major Components.........................................................2

2 System Board Layout.....................................................4

3 Jumpers and Connectors...............................................5

3.1 Jumper and Connector Locations...................5

3.2 Jumper Settings..............................................6

3.3 Onboard Connector Functions........................8

4 Installation Precautions..................................................9

4.1 ESD Precautions.............................................9

4.2 Pre-installation Instructions.............................9

4.3 Post-installation Instructions.........................10

5 Memory Configurations................................................11

5.1 Installing a DIMM..........................................11

5.2 Removing a DIMM........................................12

5.3 Reconfiguring the System.............................13

6 Second-level Cache.....................................................14

7 Upgrading the CPU......................................................14

7.1 Removing the CPU.......................................14

7.2 Installing the Upgrade CPU ..........................15

8 IDE Hard Disk Sup port................................................17

9 Video Function.............................................................18

10 Audio Function.............................................................20

11 Expansion Cards..........................................................21

11.1 Installing a PCI Card.....................................21

11.2 Installing ISA Cards ......................................22

12 USB..............................................................................23

13 Wireless Communication Feature ...............................24

Altri manuali per V70MA

Manuali Scheda madre popolari di altre marche

DFI

DFI SD170 Manuale utente

ASROCK

ASROCK ROMED8-2T Manuale utente

Asus

Asus P2L97A Manuale utente

Winmate

Winmate IC70 Manuale utente

Asus

Asus MES-B Manuale utente

Grantech

Grantech SYS8F377VGGA-3OMN Manuale utente

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuale utente

Gigabyte

Gigabyte GA-9IVDT Manuale utente

Texas Instruments

Texas Instruments ADS8372EVM Manuale utente

Commell

Commell MS-C73 Manuale utente

IBT Technologies

IBT Technologies MB860 Manuale utente

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuale utente

Biostar

Biostar M7VIT Bravo Istruzioni per l'uso e l'installazione

Intel

Intel D33217CK Manuale utente

Asus

Asus F1A55-M LX PLUS R2.0 Manuale utente

EPC

EPC EPC9147C Manuale utente

Asus

Asus EX-B760M-V5 D4 Manuale utente

EPOX

EPOX MU-8KHA0010 Manuale utente