Aegis CZ20350 Manuale utente
Congratulations on the purchase of your new LAN cable tester. This tester
consists of a main unit and a remote unit. The tester will automatically test
for:Continuity, Opens, Shorts, Crosses, and Splits. Auto scanning
enables fast cable testing.
Faults displayed by LED indicators.
Check each pair individually
FEATURES:
Connect the main unit and the remote unit to each end of the cable to
be tested. Press the ON/TEST button on the main unit toturn it unit on.
Press the ON/TEST button again to perform a test. To test pairs
individually, press the FAULT CHECK/TONE button tocycle through the
pairs. To initiate tone sending, press and hold the FAULT
CHECK/TONE button for approximately 5 seconds.
Push the remote unit out from
the main unit.
Connect one end of cable to be
tested tothe main unit and the
other tothe terminator unit.
Press "ON/TEST" twice to
initiate test.
User's Guide
CZ20350
Tone mode can be accessed by pressing the FAULT CHECK/TONE
button for approximately 5seconds. The tone can be applied to all pairs
or to an individual pair by pressing the FAULT CHECK/TONE button to
cycle through the options.
DO NOT USE ON LIVE CIRCUITS!
DO NOT USE ON LIVE CIRCUITS!
CZ20350
DO NOT USE ON LIVE CIRCUITS!
CZ20350
DO NOT USE ON LIVE CIRCUITS!
CZ20350
DO NOT USE ON LIVE CIRCUITS!
CZ20350
Fail Indication Examples
Australia
Aegis
Toll Free: 1300 723 447
www.aegis.net.au
Information published in this brochure is subject to change without notice.
New Zealand
Aegis Instruments
Toll Free: 0508 423 447
www.aegis.net.nz
United Kingdom
Aegis Instruments
Toll Free: 0800 6123447
www.aegisinstruments.co.uk
Indice
Altri manuali Aegis Tester per cavi
