TS150/TS300 Loud Speakers
ASM-TS150/TS300 Installation and Operation Manual
Nov 13, 2019 Rev: 1.00 Page 2-3
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
2.3.5 Post-Installation Checks
Ensure all connectors are tight and the mechanical installation is sound.
When the PA system installation is complete, carry out a full performance test to ensure that all components
of the system (including the speaker) are functioning correctly. For full post-installation check information,
refer to Section 2 of the ASM-LSA400 Loud Speaker Amplifier Service manual.
2.3.5.1 Bonding
If required, bonding is normally achievable through the mounting points during installation of the product
using conductive hardware. If the hardware and/or mounting location/surface is non-conductive, then the
use of a bonding strap to an airframe ground point is required. The bonding strap should be as short as
possible. If the product finish is non-conductive, recommend removing the finish around one of the
mounting points. Treat the exposed metal areas with a protective, conductive coating.
The use of a milli-ohmmeter is recommended to verify bonding. Reference AC 43.13-1B Change 1, Section
15 for additional information.
2.4 Continued Airworthiness
Maintenance of the TS150/TS300 Loud Speakers is ‘on condition’ only. Periodic maintenance of this
product is not required.
2.5 Installation Drawings
Loud Speaker, Compact, 150W
Loud Speaker, Compact, 150W
Loud Speaker, Compact, 150W
Loud Speaker, Compact, 150W
Loud Speaker, Compact, 300W
Loud Speaker, Compact, 300W
Loud Speaker, Compact, 300W
Loud Speaker, Compact, 300W
Loud Speaker, Compact, 300W
Loud Speaker, Compact, 300W
Section 2.0 ends following the above documents
