- 6 -
ALFA IN a.s. © www.alfain.eu
ACL-10 coolant is designed for ambient temperatures up to -10˚C.
Notice
Persons with implanted pacemakers must not work with the machines or move
close to them! There is a risk of impaired pacemaker function!
OPERATING CONDITIONS
1. aXe 500 IN PULSE welding machine is designed for welding steel,
aluminium, and alloys for commercial and industrial applications.
2. Use only the designated transport equipment to transport the welder. Do
not use a forklift or single crates for transport.
3. The device may only be operated by trained personnel within the
technical regulations. The manufacturer is not liable for damage caused
by improper use and operation. Only use original spare parts from ALFA
IN for maintenance and repairs.
4. The device complies with IEC 61000-3-12.
5. The welding machine is tested according to the standard for degree of
protection IP 23S, which protects against the intrusion of solids with a
diameter greater than 12 mm and protection against the intrusion of water
falling in a vertical to the oblique direction to a slope of 60˚.
6. Operating ambient temperature between -10 to +40 °C.
7. Relative humidity below 90% at +20 °C.
8. Altitudes of up to 3000 meters above sea level.
9. The machine must be located so the cooling air can enter and exit through
the cooling vents without restriction. Care must be taken to ensure that no
mechanical particles, especially metal particles, are sucked into the
machine (e.g. during grinding).
10. The handling handle is intended for travel only and is not designed
for lifting machines.
11. All interventions in the el. Equipment and repairs (disassembly of the
mains plug, replacement of fuses) may only be carried out by an
authorised person.
12. It is essential to conduct a regular inspection on the welding machine
every 6 to 12 months, as per the regulations for the revision of electrical
equipment in your country and the regulations for welding and safety
provisions for metal arc welding. It is recommended that an authorised
employee performs the inspection. – See paragraph Maintenance and
service tests.
13. From the point of view of interference suppression, the welding
machine is designed primarily for industrial premises. Special measures
may be required if other premises are used (see EN 60974-10).
14. The machine must be protected against the following:
a. Moisture and rain
b. Mechanical damage
c. Drafts and possible ventilation of neighbouring machines
