Remove the power source from the system that controls the passerelle.
Install the receiver/adaptor far away from heat sources
and electromagnetic disturbances.
Connect the connector cable of the Besenzoni Unit Control to the electronic
control unit of the retractable gangway:
Option 1: In the case in which the electronic control unit is already equipped
with double input (from 2018 onwards):
- Leave the electronic board connected fi g . Con the 6-key control panel
of the retracting gangway fi g . D.
- Connect the receiver/adapter fi g . Adirectly to the gangway electronic board
shown in
fi g . Cin the free socket on the electronic board.
Option 2: In the event that the electronic control unit does not have a double input:
- Use the cable fi g . Bto connect both the and the 6-key panel fi g . D.
Take note of the password on the label attached to the front of the .
Power the circuit board with the electronic junction box line
stabilised at 12/24 volts.
Restore power to the system.
Activate the device’s bluetooth.
Open the App on your device.
Click Settings from the dropdown menu in the top left-hand corner.
Choose and set an unlock code which you will also use in the future.
Deactivate the Demo mode and tick “Start in Command View”.
Click “Set Device Code” and insert the 5 digit security code
shown on the label
Click “Select device” and select the device that corresponds
to the name shown on the label: e.g. Name: Besenzoni1010.
Click the Dropdown menu button.
Click Command and then the screen to start the App.
The commands to control the passerelle will appear in the next screen.
In order to correctly control the passerelle, you must press and hold
the selected command, otherwise an Error message will show up
on the device’s screen. To restart the controlling operation,
press and hold the command again.
INSTALLATION PROCEDURE ACTIVATION PROCEDURE
NOTA
Settings: by selecting Launch Commands when you next open the App, once you have
inserted your unlock code, you will have immediate access to the commands section.
Controlling the passerelle via the App still allows you to use the remote control
that you have been supplied with.
PROCEDURA AZZERAMENTO DEVICES MEMORIZZATI:
1) Open the lid of the by removing the 2 screws.
2) Press the S1 button indicated in the image for 2 seconds
until the blue LED goes out.
3) Close the receiver cover. S1
Led blu
