AntMiner Manual
Last updated: 8/30/2016
Page 7 of 10
Page 7 / 10
5Miner Configuration
5.1 General Settings
You can configure your miner through ‘Miner Configuration->General Settings’.
Pool URL- Enter the URL of your desired pool in this column.
Worker- This is your worker ID on the selected pool.
Password- This is the password for your selected worker.
Comment:
5.1.1 The AntMiner R4 can be set up with three mining pools, with decreasing priority from the
first pool (pool 1) to the third pool (pool 3). The pools with low priority will only be used if all
higher priority pools have gone offline.
5.1.2 When ‘Stop running when temperature is over 80℃’ is checked, the miner will stop mining
when the temperature(PCB) exceeds 90℃ to protect the miner. If it is unchecked, the miner will
still mine even at high temperatures. Note that while the interface says 80℃ the PCB temperature
will actually go to 90℃ before the machine stops mining.
5.1.3 When “Customize the fan speed percentage” is checked, the fan speed can be controlled by
the user. If it is unchecked, the fan speed will depend on the temperature of the hash boards.
Click ‘Save & Apply’ to save and restart miner.
Kindly reminder: Please set the fan speed above 80% to keep the temp(PCB) below 90 degrees
and the temp(chip) below 115 degrees.
