Black Box LB8408A-R2 Manuale utente

Installation

This installation guide gives step-by-step instructions about how to install the Express Entry Ethernet Switches:

LB8408A-R2

Selecting a Site for the Express Ethernet Switch: LB8408A-R2

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures, humidity,

or electromagnetic interference. Specifically, the site you select should meet the following requirements:

- The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

- The relative humidity should be less than 90 percent, non-condensing.

- Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC

801-3, Level 2 (3V/M) field strength.

- Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of

the switch or the fan exhaust port on the rear of the switch.

- The power outlet should be within 1.8 meters of the switch.

Connecting to Power

External power:

Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into a

standard AC outlet with a voltage range from 100 to 260 VAC.

1. 8-port LED Panel

2. Power LED

3. Uplink LED

4. 5V, DC power plug

Figure 1: Rear view

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com yE-mail: [email protected]

Connecting to Your Network

Cable Type & Length

It is necessary to follow the cable specifications below when connecting the switch to your network. Use

appropriate cables that meet your speed and cabling requirements.

Table 3: Cable Specifications

Speed Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-T RJ-45 10/20

Mbps

2-pair UTP/STP

Cat. 3, 4, 5

100 m

100BASE-TX RJ-45 100/200

Mbps

2-pair UTP/STP

Cat. 5

100 m

100BASE-FX ST, SC, MT-RJ,

VF-45

100/200

Mbps

MMF (50 or

62.5µm)

2 km

100BASE-FX SC 100/200

Mbps

SMF (9 or

10µm)

15, 40, or

75 km

Cabling

Step 1: First, ensure the power of the switch and end devices is turned off.

<Note> Always ensure that the power is off before any installation.

Step 2: Prepare cable with corresponding connectors for each type of port in use.

<Note> To connect two regular RJ-45 ports between switches or hubs, you need a cross-over cable.

Step 3: Consult Cable Specifications Table on previous page for cabling requirements based on connectors and speed.

Step 4: Connect one end of the cable to the switch and the other end to a desired device.

Step 5: Once the connections between two end devices are made successfully, turn on the power and the switch is operational.

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com yE-mail: [email protected]

Indice

Altri manuali Black Box Interruttore

Black Box

Black Box IC1020A Manuale utente

Black Box

Black Box ServSwitch Manuale utente

Black Box

Black Box LB5953A Manuale utente

Black Box

Black Box VSW-HDMI2-3X1 Manuale utente

Black Box

Black Box SW1023A Manuale utente

Black Box

Black Box IC1027A Manuale utente

Black Box

Black Box LPH008A-R2 Manuale utente

Black Box

Black Box KV7012A Manuale utente

Black Box

Black Box LBG1000A-R2 Manuale utente

Black Box

Black Box ServSwitch DT Pro II KV7020A Manuale utente

Black Box

Black Box SW1000A Manuale utente

Black Box

Black Box AVSW-HDMI2X1A Manuale utente

Black Box

Black Box LB9002A-SC-R3 Manuale utente

Black Box

Black Box ServSelect III KV21008A Manuale utente

Black Box

Black Box LGB624A Manuale utente

Black Box

Black Box ServSwitch Manuale utente

Black Box

Black Box SW930A-R2 Manuale utente

Black Box

Black Box LPB1305A Manuale utente

Black Box

Black Box SW1033A Manuale utente

Black Box

Black Box LE2425A Manuale utente

Black Box

Black Box 26592 Manuale utente

Black Box

Black Box KV9604A Manuale utente

Black Box

Black Box ServSwitch KV1510A Manuale utente

Black Box

Black Box KVS4-1002VM Manuale utente

Manuali Interruttore popolari di altre marche

URC

URC Total Control MFS-8 Manuale utente

Azbil

Azbil HPQ-D11 Manuale utente

Sony

Sony DFS-900M Manuale utente

SICK

SICK i17S Manuale utente

F&F

F&F SZR-277 Manuale utente

Shure

Shure UAMS/BK Manuale utente

Dräger

Dräger X-zone Switch Off Manuale utente

Asco

Asco Joucomatic 349 Series Manuale utente

BT Mini Hub Manuale utente

D-Link

D-Link DES-1226G Manuale utente

Johnson Controls

Johnson Controls FS80-C Manuale utente

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuale utente

MicroNet

MicroNet SP1200A Manuale utente

Ruijie

Ruijie RG-PF2920 Series Manuale di installazione e funzionamento

Altinex

Altinex DA1914SX Manuale utente

MiLAN

MiLAN MIL-SM2401M Manuale utente

RJM

RJM MASTERMIND PBC/6X Manuale utente

Atlas

Atlas MMK-KVM8 Manuale utente