Black Box LB9020A Manuale utente

Installation

This installation guide gives step-by-step instructions about how to install the Express Plus Ethernet Switches:

LB9020A

Selecting a Site for the Express Plus Ethernet Switch: LB9020A

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures, humidity,

or electromagnetic interference. Specifically, the site you select should meet the following requirements:

-The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

-The relative humidity should be less than 90 percent, non-condensing.

-Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC

801-3, Level 2 (3V/M) field strength.

-Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of

the switch or the fan exhaust port on the rear of the switch.

-The power outlet should be within 1.8 meters of the switch.

Connecting to Power

Internal power:

Step 1:Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into a standard AC outlet with a

voltage range from 100 to 260 Vac.

Step 2:Turn on the switch by flipping the ON/OFF switch on the rear of the unit to I (ON) position.

Step 3:The Oposition is OFF.

Figure 1: Rear view

CUSTOMER

SUPPORT

INFORMATION

Order toll

free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday

: 877

877

BBOX

FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-

746-0746

Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site:

www.blackbox.com • E-mail: [email protected]

Connecting to Your Network

Cable Type & Length

It is necessary to follow the cable specifications below when connecting the switch to your network. Use

appropriate cables that meet your speed and cabling requirements.

Table 3: Cable Specifications

Speed Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-TRJ-45 10/20

Mbps 2-pair UTP/STP

Cat. 3, 4, 5 100 m

100BASE-TX RJ-45 100/200

Mbps 2-pair UTP/STP

Cat. 5 100 m

100BASE-FX ST, SC, MT-RJ,

VF-45 100/200

Mbps MMF (50 or

62.5µm) 2 km

100BASE-FX SC 100/200

Mbps SMF (9 or

10µm) 15, 40, or

75 km

Cabling

Step 1: First, ensure the power of the switch and end devices is turned off.

<Note> Always ensure that the power is off before any installation.

Step 2: Prepare cable with corresponding connectors for each type of port in use.

<Note> To connect two regular RJ-45 ports between switches or hubs, you need a cross-over cable.

Step 3:Consult Cable Specifications Table on previous page for cabling requirements based on connectors and speed.

Step 4:Connect one end of the cable to the switch and the other end to a desired device.

Step 5:Once the connections between two end devices are made successfully, turn on the power and the switch is operational.

CUSTOMER

SUPPORT

INFORMATION

Order toll

free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday

: 877

877

BBOX

FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-

746-0746

Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site:

www.blackbox.com • E-mail: [email protected]

Indice

Altri manuali Black Box Interruttore

Black Box

Black Box IC254A-US Manuale utente

Black Box

Black Box SWI035A Manuale utente

Black Box

Black Box ServSwitch Duo IP ACR6208A Manuale utente

Black Box

Black Box LGB5124A Manuale utente

Black Box

Black Box AVSW-DP2X1 Manuale utente

Black Box

Black Box LGB5028A Manuale utente

Black Box

Black Box SERVSWITCH PANTHER KV1108A Manuale utente

Black Box

Black Box ServSwitch CX Quad IP Manuale utente

Black Box

Black Box KVP4004A Manuale utente

Black Box

Black Box AC815A Manuale utente

Black Box

Black Box LB9032A Manuale utente

Black Box

Black Box Remote Management Switch SW555A Manuale utente

Black Box

Black Box KV0216A Manuale utente

Black Box

Black Box LB9801A Manuale utente

Black Box

Black Box LGB1152A Manuale utente

Black Box

Black Box BandwidthManager LE1028C Manuale utente

Black Box

Black Box AVSW-HDMI2X1A Manuale utente

Black Box

Black Box KVM2016A Manuale utente

Black Box

Black Box ServSwitch Secure SW2006A-USB-EAL Manuale utente

Black Box

Black Box KV6108SA-R2 Manuale utente

Black Box

Black Box LPD100A Manuale utente

Black Box

Black Box ClassWork Junior Manuale utente

Black Box

Black Box KVMC4K-2P Manuale utente

Black Box

Black Box LBH100A-PD-ST-24 Manuale utente

Manuali Interruttore popolari di altre marche

URC

URC Total Control MFS-8 Manuale utente

Azbil

Azbil HPQ-D11 Manuale utente

Sony

Sony DFS-900M Manuale utente

SICK

SICK i17S Manuale utente

F&F

F&F SZR-277 Manuale utente

Shure

Shure UAMS/BK Manuale utente

Dräger

Dräger X-zone Switch Off Manuale utente

Asco

Asco Joucomatic 349 Series Manuale utente

BT Mini Hub Manuale utente

D-Link

D-Link DES-1226G Manuale utente

Johnson Controls

Johnson Controls FS80-C Manuale utente

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuale utente

MicroNet

MicroNet SP1200A Manuale utente

Ruijie

Ruijie RG-PF2920 Series Manuale di installazione e funzionamento

Altinex

Altinex DA1914SX Manuale utente

MiLAN

MiLAN MIL-SM2401M Manuale utente

RJM

RJM MASTERMIND PBC/6X Manuale utente

Atlas

Atlas MMK-KVM8 Manuale utente