10 (800) 449-8691
Installaon Instrucons
Tip Over Hazard
Product ps easily when not completely installed. Use two or
more people to move and install product. Failure to follow
these instrucons can result in death or serious injury.
Risque de renversement
Le produit pointe facilement lorsqu'il n'est pas complètement
installé. Deux personnes ou plus doivent déplacer et installer
le produit. Le non-respect de ces instrucons peut entraîner la
mort ou des blessures graves.
Tools and Materials
• Mounng kit (included)
• An-pping kit (included)
• Lateral connecon kit (included)
• 1/8” hex key (included)
• Rivet tool
• Phillips screwdriver
• Screws to aach brackets (customer supplied)
• Power drill
• 1/8” drill bit (for wood stud wall)
• 5/16” drill bit (for masonry walls)
• Stud nder
• Tubing cuer (for water line)
• 3’ of 1/4” OD copper or PEX tubing (for water line)
• Saddle valve (for water line)
• 11/16” (17mm) open end wrench
• 3/4” (19mm) open end wrench
• 1/2” (13 mm) socket
• Level
• Gloves
• Safety glasses
• Before transporng the appliance, check access to the
locaon where it will be installed (door size, maneuvering
space in stairwells, etc).
• Use a pallet-jack or appliance cart to move the appliance
to the installaon site before removing the appliance
from the pallet. The appliance should always be
transported in an upright posion. If this is not possible,
transport the appliance on its back.
Step 1 — Uncrate and Inspect Product
• Before starng the installaon, uncrate and inspect the
product. Remove the packing materials but do not discard
the mounng kit, an-pping kit, lateral connecon kit,
joining kit on back of freezer, venng grille, handle pack
(if ordered) and associated hardware.
Step 2 — Remove Wood Pallet
Important: Delicate oors should be protected with plywood,
hard-board or similar material panels.
• Remove the wood pallet by removing the four shipping
bolts (1) with an appropriately-sized wrench or socket.
Discard the shipping bolts.
• Remove the front and rear shipping brackets (3, 4). For
the front bracket (3), the rear wheel adjusng bolt (2)
may need to be loosened with a 1/2” (13 mm) socket or
wrench. Avoid over-torqueing this bolt at its stop points
so as to not damage the rear leveling system.
• Retract the front leveling feet with a 11/16” (17 mm)
open end wrench.
• From the back of the appliance using a suitable, heavy-
duty appliance dolly, take the appliance o the pallet and
place it on the oor.
WARNING
AVERTISSEMENT
CAUTION
The appliance should always be transported in an upright
posion. Avoid pping it onto its front side.
MISE EN GARDE
L'appareil doit toujours être transporté en posion vercale.
Évitez de le faire basculer sur sa face avant.
