Bosch PAVIRO PVA-1WEOL Manuale utente
PAVIRO End‑of‑line supervision module
PVA‑1WEOL
en User manual
4en | Short information PAVIRO End-of-line supervision
module
2019-01 | V2 | F01U350870 Bosch Security Systems B.V.
1 Short information
The End-of-line (EOL) supervision module monitors the integrity of a
loudspeaker line and can be used in applications where continuous
business music is requested.
In combination with the EOL master, integrated in every Controller and
Router of the PAVIRO system, the loudspeaker line can be monitored
for short and open circuits.
The status LED on the module can be used to check the installation. For
more information, refer to the user documentation for the IRIS-Net,
Controller or Router.
Parts included
Quantity Component
1 End-of-line supervision module
1 Set of screws
1 User manual
PAVIRO End-of-line supervision
module Installation | en 5
Bosch Security Systems B.V. 2019-01 | V2 | F01U350870
2 Installation
To install the End-of-line supervision module you have to:
– Mount the module.
– Set the module address.
– Connect the module to the speaker line.
– Connect the module to earth or ground.
– Check the installation.
2
4
3
2
1
Figure2.1: End-of-line supervision module
Item Description
1 DIP switch S1
2 DIP switch S2
3 Status LED
4 Connector (Speaker line + / Speaker line - / Earth)
6en | Installation PAVIRO End-of-line supervision
module
2019-01 | V2 | F01U350870 Bosch Security Systems B.V.
Mount the module
!
Caution!
Make sure all safety regulations are observed. Mounting the
module on spacers is strongly recommended.
Set the module address
Before connecting the module, a module address must be set with the
DIP switches S2 and S1 (see previous figure and following table). The
module address allows for identification of the affected loudspeaker
line in case an error occurred, such as an open-circuit.
6 5 4 3 2 1 Module
address
DIP switch S2 DIP switch S1
43214 321
OFF OFF OFF OFF OFF OFF 0 (not
connected)
OFF OFF OFF OFF OFF ON 1
OFF OFF OFF OFF ON OFF 2
OFF OFF OFF OFF ON ON 3
OFF OFF OFF ON OFF OFF 4
OFF OFF OFF ON OFF ON 5
OFF OFF OFF ON ON OFF 6
OFF OFF OFF ON ON ON 7
PAVIRO End-of-line supervision
module Installation | en 7
Bosch Security Systems B.V. 2019-01 | V2 | F01U350870
6 5 4 3 2 1 Module
address
DIP switch S2 DIP switch S1
43214 321
OFF OFF ON OFF OFF OFF 8
OFF OFF ON OFF OFF ON 9
OFF OFF ON OFF ON OFF 10
OFF OFF ON OFF ON ON 11
OFF OFF ON ON OFF OFF 12
OFF OFF ON ON OFF ON 13
OFF OFF ON ON ON OFF 14
OFF OFF ON ON ON ON 15
OFF ON OFF OFF OFF OFF 16
OFF ON OFF OFF OFF ON 17
: : : : : :
ON ON ON ON OFF OFF 60
OFF Reserved
ON
OFF To activate the
status LED for
five minutes,
ON
8en | Installation PAVIRO End-of-line supervision
module
2019-01 | V2 | F01U350870 Bosch Security Systems B.V.
6 5 4 3 2 1 Module
address
DIP switch S2 DIP switch S1
43214 321
set the switch
to OFF and
back to ON.
Tab.2.1: DIP switch settings on the module (the settings on delivery are
shown in bold)
Notice!
The module address must be unique within each zone
topology (each controller, router, or amplifier).
Connect the module to the speaker line
Connect the speaker line wires to the plus (+) and minus (-) contacts of
the connector. Make sure the capacitance limit of parallel connected
speaker lines is not exceeded, as described in Technical data, page 10.
Connect the module to earth or ground
Use the earth contact on the connector to connect the module to earth
or ground. To make this connection, you can use:
– a short wire to earth or ground near the installed module,
– the cable shield, or
– any free wire on the cable.
PAVIRO End-of-line supervision
module Installation | en 9
Bosch Security Systems B.V. 2019-01 | V2 | F01U350870
Notice!
The connection to earth or ground should be
below 1kOhm to enable good communication
between the module and the EOL-Master.
Check the installation
Use the LED on the module to check the connection to the speaker line
and earth:
1. Activate the LED for five minutes, by setting switch 4 on DIP switch
S2 to OFF and back to ON.
2. Use the following table to check the status of the installation.
Status LED Description
OFF No voltage supply (for example,
pilot tone is deactivated).
Slow flashing (2Hz) Correct power supply (pilot tone
is on the speaker line). Module is
ready.
Rapid flashing (10Hz), every 40
seconds
A valid command is being
received from the EOL Master.
This indicates a good ground
connection.
Tab.2.2: Status LED for checking installation
10 en | Technical data PAVIRO End-of-line supervision
module
2019-01 | V2 | F01U350870 Bosch Security Systems B.V.
3 Technical data
The technical data in this section is valid for PVA-1WEOL hardware
version 1.2 and firmware version 1.3 in combination with PVA-4CR12 or
PVA-4R24 hardware version 02/00. For information on previous
versions, see Compatibility with older EOL modules, page 14.
Electrical
Power supply 18-22kHz, 8 Veff, 20mW
Wire limits
Minimum RG3MΩ
Maximum Cg 2500nF
Number of modules 60
Mechanical
Product dimensions (Height x Width x
Depth)
15 mm x 78 mm x 60mm
Net weight 30g
Environmental
Operating temperature -5°C to +45°C
Altri manuali per PAVIRO PVA-1WEOL
1
Indice
Altri manuali Bosch Unità di controllo
Bosch
Bosch POPEX B299 Manuale utente
Bosch
Bosch FLM-320-EOL4W-S Manuale utente
Bosch
Bosch D8128D Manuale utente
Bosch
Bosch Rexroth IndraControl L10 Manuale tecnico
Bosch
Bosch TouchOne Manuale utente
Bosch
Bosch Rexroth FMS Manuale utente
Bosch
Bosch Professional GCY 42 Manuale utente
Bosch
Bosch FLM-420-O2-E Manuale utente
Bosch
Bosch FLM-420-NAC-D Manuale utente
Bosch
Bosch CM255B Come usare
Bosch
Bosch rexroth IH04E Manuale utente
Bosch
Bosch CRR 220 Manuale utente
Bosch
Bosch Rexroth IndraDrive CSB02 Manuale tecnico
Bosch
Bosch D8125 Guida rapida
Bosch
Bosch MP 100 Manuale utente
Bosch
Bosch B444 Manuale utente
Bosch
Bosch D9127U Manuale utente
Bosch
Bosch Sensortec Application Board 3.0 Manuale utente
Bosch
Bosch B426 Manuale utente
Bosch
Bosch Rexroth IndraControl Manuale utente
Manuali Unità di controllo popolari di altre marche
Festo
Festo Compact Performance CP-FB6-E Manuale elenco delle parti
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manuale utente
JS Automation
JS Automation MPC3034A Manuale utente
JAUDT
JAUDT SW GII 6406 Series Guida rapida
Spektrum
Spektrum Air Module System Manuale utente
BOC Edwards
BOC Edwards Q Series Manuale utente
