Bushnell Stableview 18-1035 Manuale utente

Model: 18-1035

LIT. #: 98-0495/10-04

CONTENTS

ENGLISH .................................................................................... 1

FRANÇAIS .................................................................................. 11

ESPAÑOL ................................................................................... 24

DEUTSCH ................................................................................... 37

ITALIANO .................................................................................. 50

PORTUGUÊS .............................................................................. 63

QUICK REFERENCE GUIDE

1) Load two AA alkaline batteries into the compartment on the handstrap.

2) Press the Power button (a) to turn on. The electronic system will start up, and the binoculars will go

to Standby mode after about five seconds. (LED indicator stops blinking

3) Adjust the eyepiece spacing (b) to match the distance between your two eyes.

4) Use your left eye as you adjust the focus control knob (c). When the image becomes sharp, use your

right eye and turn the diopter adjustment ring (d) to focus for the right eye. Once you have performed

the diopter correction, use only the control knob (c) to check focus again.

5) Turn the stabilization lever (e) to the ACTIVE position to activate the stabilization feature.

6) Press the power button briefly to change to fine mode, which is more effective at countering hand

shake. Tap the power button again to return to normal mode.

7) When finished, turn the stabilization lever (e) to the HOLD position and press the Power button (a)

to turn off.

LED Status

Lit in orange Standby (stabilization off)

Lit in green Stabilization active (normal)

Flashing in orange/green Fine mode

Lit in red Batteries should be replaced

Flashing in red System problem

Off Power Off

(b) Eyepieces adjust for

interpupillary distance

LED Indicator

(a) Power button/Mode

switch

Interpupillary scale

(e) Stabilization lever

Large light-gathering

35mm objective lenses

Handstrap

Battery

compartment

Battery compartment

release knob Stabilizer lever

(d) Diopter

adjustment ring

Eyepiece lenses

Eyecup

QUICK REFERENCE GUIDE

(d) Diopter

adjustment ring

Eyepiece lenses

Eyecup

CONTENTS

Bushnell StableView

Soft case

Cleaning cloth

Neckstrap

Eyepiece cap

Instruction manual (this handbook)

CONGRATULATIONS

Thank you for purchasing Bushnell StableView binoculars. Be sure to read this manual thoroughly for

proper use.

Bushnell StableView binoculars use advanced technology in optics, electronics, and ergonomics.

The stabilization feature built into these binoculars cancels out vibration from the outside and the

shake that occurs with hand-held use, offering stabilized viewing without a tripod, even at high

magnifications.

Your Bushnell StableView has an exclusive feature, providing two different stabilization modes in one

binocular for the first time. “Normal” mode is designed to counteract the long, slow motion encountered

in a boat, plane or car, and is also ideal for tracking moving subjects such as a bird in flight. “Fine” mode

compensates for short, rapid external vibration, designed to be very effective against the visible effect of

hand held shake (tremor) that many experience with high power binoculars. The modes are easily set,

and you can quickly switch between them.

The newly designed lenses are multi-coated, provide a wide field of view and reduced eye fatigue. The

prisms are phase-coated to offer sharp contrast and bright images.

Bushnell StableView binoculars are waterproof and airtight, allowing worry-free usage in a boat or rainy weather.

DIGITAL STABILIZING

HOW IT WORKS

• AZ (azimuth) and EL (elevation) piezo gyro

vibration sensors and direct-drive motors

work together to move a gimbaled assembly

with erecting prism to counteract vibration

and keep the image steady, which offers shake-

free viewing even from a moving vehicle.

• The position sensor activates the stabilization

feature as it detects vertical and horizontal

motion.

• The newly designed lenses are multi-coated

for bright images.

• The prisms have a special coating that gives

sharper images than ever before.

• The eyepieces incorporate advanced optical

technology that offers a wide field of view

and reduces eye fatigue. The eyecups can be

twisted up and down for use with glasses.

• Bushnell StableView binoculars are waterproof

and filled with dry nitrogen to prevent internal

fogging of the optical components.

Eyepiece Lenses

Gimbal Assembly

EL Direct Motor

AZ Direct Motor

Position Gyro Sensor

Objective Lens

Position

Sensor

Prism Assembly

Position Sensor

Eyepiece Lenses

Gimbal Assembly

EL Direct Motor

HOW TO ADJUST AND FOCUS

Eyepiece

Rotate the rubber eyecups up or down to adjust the height. If you wear

glasses or sunglasses when using the binoculars, set the eyepcups at their

lowest positions.

Interpupillary adjustment

Use both eyes to look into the eyepieces and adjust the interpupillary

distance to match the distance between your two eyes until you see just

one perfectly circular image.

Diopter adjustment

You should perform the diopter correction before first usage, as the vision

of your two eyes might be different.

Close your right eye and use only your left eye as you adjust the focus

control knob.

Once you get a sharp image, close your left eye and open your right eye.

Turn the right diopter adjustment ring to focus for the right eye. (Do

NOT use the focus control knob.)

Now look through the binoculars with both eyes and make sure the

diopter adjustment is perfect. Only the focus control knob should be

needed for later focusing.

Focus Control Knob

Diopter Adjustment

Ring

BATTERY INSTALLATION

1) Slide the battery compartment release

switch on the handstrap to the Open

position to release the battery holder.

2) Insert two new size AA alkaline batteries.

3) Attach the battery holder to the handstrap

and slide the release switch to the locked

position to secure the compartment.

WARNING

• NEVER slide the stabilization

lever to the ACTIVE position if

you do not have two batteries

installed. Damage could result.

• Use the same type of batteries. Do

NOT mix old and new batteries.

Doing so can cause leakage or

rupture.

• When changing the batteries

outdoors, be sure not to let

any water get into the battery

compartment.

• If you plan to leave the binoculars

stored for a prolonged period,

remove the batteries in order to

prevent natural discharge and/or

leakage.

When the batteries are removed,

keep the battery holder attached

to the handstrap to protect the

internal contact points.

• Keep the contact points away from

any metal. Damage could result.

SPECIFICATIONS

Magnification 10x

Objective Lens Diameter 35mm

Compensation Angle (stabilization correction) 3

Eye Relief 12mm

Field of View 260ft. at 1000yds/86.6m at 1000m

Minimum Focusing Distance 12ft.

Exit Pupil 3..5mm

Interpupillary Adjustment Distance 53 to 74 mm

Dimensions: LxWxH 7.25 x 6 x 3.5 inches (without strap)

Weight 43.9oz/1244g

Battery (2) Size AA alkaline batteries (not included)

Safe Ambient Temperature Range -10 C to 50 C (14 F to 122 F)

Specifications and designs are subject to change without notice.

Questo manuale è adatto per i seguenti modelli

Indice

Lingue:

Altri manuali Bushnell Binocolo

Bushnell

Bushnell Marine 13-7500 Manuale utente

Bushnell

Bushnell ImageView 18-0832 Manuale utente

Bushnell

Bushnell Imageview 11-1025 Manuale utente

Bushnell

Bushnell Marine 13-7507 Manuale utente

Bushnell

Bushnell Equinox Z 260501 Manuale utente

Bushnell

Bushnell Legend E Series Manuale utente

Bushnell

Bushnell H2O 157050R Manuale utente

Bushnell

Bushnell Elite e2 Manuale utente

Bushnell

Bushnell EQUINOX Z Manuale utente

Bushnell

Bushnell Instant Replay 118325 Manuale utente

Bushnell

Bushnell ImageView 11-1026 Manuale utente

Bushnell

Bushnell Marine 13-7500 Manuale utente

Bushnell

Bushnell ImageView 98-0917/04-09 Manuale utente

Bushnell

Bushnell NatureView Manuale utente

Bushnell

Bushnell LEGEND BB842W Manuale utente

Bushnell

Bushnell 23-2811 Manuale utente

Bushnell

Bushnell IMAGE VIEW 111024 Manuale utente

Bushnell

Bushnell Trophy XLT Manuale utente

Bushnell

Bushnell ImageView 11-8313 Manuale utente

Bushnell

Bushnell FORGE BF1030T Manuale utente

Bushnell

Bushnell LYNX 260401 Manuale utente

Bushnell

Bushnell Legend 98-1389/03-09 Manuale utente

Bushnell

Bushnell ImageView 11-8200 Manuale utente

Bushnell

Bushnell 260140 Manuale utente

Manuali Binocolo popolari di altre marche

Celestron

Celestron VistaPix 72218 Manuale utente

Levenhuk

Levenhuk Atom Digital DNM200 Manuale utente

ATN

ATN PS-15 Manuale utente

Bresser

Bresser TOPAS 7x50 Manuale utente

Berger & Schroter

Berger & Schroter LN-G3-B50 Manuale utente

Leica

Leica geovid 8x42 HD-R Manuale utente

Noblex

Noblex NF 8 x 42 inception Manuale utente

Newcon Optik

Newcon Optik AN Series Manuale utente

PHOTONIS

PHOTONIS VYPER Manuale utente

ATN

ATN 6015-WPT Manuale utente

Famous Trails

Famous Trails ViewCatcher DCB 822 Manuale utente

AGM

AGM EXPLORATOR FSB50-640 Manuale utente

Opticron

Opticron Marine-3 7x50 BIF.GA Guida all'installazione

Kayoba

Kayoba 009129 Manuale utente

Vixen

Vixen ARENA Series Manuale utente

MAGINON

MAGINON NVB 60 Manuale utente

Leica

Leica Geovid 56 Manuale utente

Leica

Leica GEOVID PRO Manuale utente