Carrier 7C-CM-C1K-XA Manuale utente

For more information, contact your local Carrier Controls Expert

INTRODUCTION

The Central Control Unit (CCU) is the local interface and access point for the entire system. With

the help of cloud computing and wireless sensors, the CCU optimizes the efficiency of existing

building equipment while keeping occupants comfortable, healthy, and productive.

PACKAGE CONTENTS

•8” Central Control Unit tablet

•Control Mote board

•Mounting accessories

SPECIFICATIONS

Power

Power Source: 24V AC/DC input (+/- 15%)

5VA (during Smart Damper calibration). Typical < 1VA consumption

Operating range

Humidity 20-85% non-condensing.

Temperature 0 to 122°F (-17 to 50°C)

Communication

Sensor bus for daisy chained sensor communication and low power 3V

dc.

4 wire interface for RS 485 communication @ 115200 baud and 5V

DC, 100mA power source

915 Mhz Mesh IEEE 802.15.4-compliant, for communications to CCU

Bluetooth: BLE 4.1 for commissioning and communication to wireless

sensors (in future)

2.4 GHz Wi-Fi to connect to the Internet

Inputs

2 x thermistor inputs. 10K Type 2. Or 0-50KΩ resistance

2 x 0-10V analog inputs. 10K impedance

Outputs

4 x 0-10V or 4-20mA analog outputs

8 x 24V DC/1A Relays

Common Pogo Pin termination for USB port and +5V DC power

USB-A port for communication

Central Control Unit

(7C-CM-C1K-XA/IA)

INSTALLATION GUIDE

Scan this QR

code to get a

more detailed

version of the

Installation

Guide

Figure 1

For more information, contact your local Carrier Controls Expert

MOUNTING

1. Mount the Control Mote (CM)

level 5’ from the floor. When using drywall anchors, drill a

5/16” hole and insert the provided anchors. Screw the CM into place using the provided

#6-13 1” screws. See Figure 2.

1. Central Control Unit Tablet

3. #6-13 1” Screws

4. Control Mote (CM)

2. Mount the 75F® CCU Tablet. Ensure that the power and volume buttons are facing

upward and that the two slots on the bottom of the tablet match with the two tabs on the

CM. Align the tabs to the slots, tilt, and push back the tablet until it clicks into place. If

power is supplied to the CM and the tablet is powered on, you will see a USB icon in the

upper left status bar of the tablet. The blue outline of a cloud signifies that data is being

transmitted. See Figure 3.

Cloud Connected

900MHz Connected.

Figure 3

Figure 2

PRECAUTIONS

•Failure to wire devices with the correct polarity when using a shared transformer may

result in damage to any device powered by the shared transformer.

•Turn off power before installing. Never connect or disconnect wiring with the power

turned on.

•Do not run the low voltage wiring in any conduit with line voltage.

•Install in accordance with all state and local codes.

For more information, contact your local Carrier Controls Expert

Optional for External Antenna

For CM board with external antenna – 7C-CM-C1K-XA

Connect the antenna to the CM Board as shown in Figure 4. Rotate the antenna clockwise

to lock in place.

Figure 4

CARRIER CLIMAVISION TECHNICAL SUPPORT

Installation and servicing of Control Systems can be hazardous due to electrical

components. Only trained and qualified service personnel should install, repair or service

control system components.

For more information on wiring, commissioning, or usage of the ClimaVision product line,

please refer to any documentation provided with the job. If no documentation was provided

with the job, please use the ClimaVision Help Center (support.climavision.com) where you

can find application specific wiring schematics and helpful user guides and videos or scan

the QR code here:

If you need help beyond that, please reach out to your local Carrier distributor for support.

Scan this QR code to

get a more detailed

version of the

Installation Guide

Questo manuale è adatto per i seguenti modelli

Altri manuali Carrier Unità di controllo

Carrier

Carrier Infinity SYSTXCCSAM01 Manuale utente

Carrier

Carrier AquaSnap 30WG Series Manuale utente

Carrier

Carrier Infinity SYSTXCCITC01-B Manuale utente

Carrier

Carrier 42BJ MCI LEC Manuale utente

Carrier

Carrier 50CO Series Manuale

Carrier

Carrier Infinity SYSTXCCUID01-V Manuale utente

Carrier

Carrier B Series Manuale utente

Carrier

Carrier 61AF Manuale utente

Carrier

Carrier 30MP015-045 Manuale utente

Carrier

Carrier Kilsen KAL740 Istruzioni per il montaggio

Carrier

Carrier LonWorks i-Vu Link Guida rapida alla configurazione

Carrier

Carrier 50CJ Manuale

Carrier

Carrier Signature Series Istruzioni per il montaggio

Carrier

Carrier 30GTN Manuale utente

Carrier

Carrier SYSTXCC4ZC01 Istruzioni e ricette

Carrier

Carrier Touch Pilot Manuale utente

Carrier

Carrier Infinity series Manuale utente

Carrier

Carrier WTC-LEX Manuale utente

Carrier

Carrier 42BJ ICM Manuale utente

Carrier

Carrier 80AWX-065 series Manuale

Carrier

Carrier AppController OPN-APP Manuale di installazione

Carrier

Carrier 50CJ Manuale

Carrier

Carrier INFINITY SYSTXCCITC01 Manuale utente

Carrier

Carrier INDUCTION AIR TERMINALS 36S Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente