CDA ECH Series Guida rapida

ECH

Standard chimney extractors

Installation, use and maintenance

2 | Instruction Manual

Contents

3. Important

4. Declaration of Conformity & product disposal

5. Notes

6. Using your extractor

7. Care and maintenance

Removing and cleaning the grease filters

8. Changing a charcoal filter

9. Extractor lighting

Notes on operating modes

10. Mains electrical connection

11. Electrical information

Troubleshooting

12. Determining the position of your extractor

13. Fixings provided

Product dimensions

14. Installation steps

15. Cont.

16. Ducting and ventilation

17. Energy Efficiency Information (product fiche)

18. Notes page

Instruction Manual | 3

Important

The CDA Group Ltd cannot be held responsible for

injuries or losses caused by incorrect use or installation

of this product. Please note that CDA reserves the right

to invalidate the guarantee supplied with this product

following incorrect installation or misuse of the

appliance or use in a commercial environment.

This appliance is not designed to be used by people

(including children) with reduced physical, sensory or

mental capacity, or who lack experience or knowledge

about it, unless they have had supervision or instructions on

how to use the appliance by someone who is responsible

for their safety.

Under no circumstances should any external covers be

removed for servicing or maintenance except by suitably

qualified personnel.

Appliance information

Please enter the details on the appliance rating plate below for

reference, to assist CDA Customer Care in the event of a fault with

your appliance and to register your appliance warranty.

Appliance model

Serial number

4 | Instruction Manual

EU Declarations of Conformity

This appliance has been designed and manufactured to comply with

all applicable UK and EU legislation,

Low voltage Directive, 2014/35/EU

Electromagnetic compatibility Directive, 2014/30/EU

ErP Directive, 2009/125/EC

RoHS Directive, 2011/65/EU

and has been marked with the following symbols

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE

PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.

At the end of its working life, the product must be taken to a special

local authority waste collection site, or to a dealer providing

appliance recycling services.

Disposing of a household appliance separately avoids possible

negative consequences for the environment and health. It also

enables the constituent materials to be recovered, saving both energy

and resources. As a reminder of the need to dispose of household

appliances separately, the product is marked with a crossed-out

wheeled dustbin.

Instruction Manual | 5

Please note

Under no circumstances should the extractor be

connected to any gas ventilation system, flue system

or hot air ducting system.

Do not vent the extractor into an attic or loft space.

Only house the extractor in rooms with adequate

ventilation. Remember that the extractor is powerful and

whatever air is extracted needs to be replaced.

Do not tile the extractor in. It should be removable

for service or maintenance.

Do not use silicone sealant to secure the hood to the wall.

You must be able to isolate the extractor from the

mains electrical supply after installation.

This extractor has been designed to be used in a

room with a volume of less than 36m3.

Steam cleaners must not be used when cleaning

this appliance.

The performance of your extractor will vary depending

on several factors. These include type of extraction,

length of ducting, room volume, ventilation available and

cleanliness of the filters.

The extractor should be cleaned regularly to prevent

build-up of grease. We recommend cleaning both inside

and outside the appliance monthly. Failure to observe

the requirements specified in this manual can result in a

fire risk.

6 | Instruction Manual

Using your extractor

For best performance, you should switch on the extractor 15 minutes

before starting to cook and leave it to run for approximately 15

minutes after the end of cooking.

Control Panel

To switch the extractor light on or off

Press the “Lamp” indicator button.

To switch on the extractor or to change the speed at any time

when the extractor is running

Press the relevant button for the “Low”, “Mid” or “Max” speed

level as required.

To switch the extractor off

Press the “Off” button.

IMPORTANT: THE LIGHTS ON YOUR EXTRACTOR ARE TO BE

USED ONLY FOR THE DURATION OF COOKING. THEY ARE NOT

FOR USE AS AMBIENT LIGHTING.

Lamp Max Mid Low Off

Fig 1.

Instruction Manual | 7

IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING

OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE

ELECTRICITY SUPPLY.

Cleaning

You should use a non-abrasive cleaner. Any abrasive cleaner

(including Cif) will scratch the surface and could erase the control panel

markings. You can clean your extractor effectively by simply using a

dilute solution of water and mild detergent and drying to a shine with a

clean cloth. Ensure that the extractor is dry after cleaning.

Removing the grease filter

Cleaning the grease filter

The grease filter should be kept clean to minimise the risk of fire. At

least once a month you should remove and clean the grease filter with

hot soapy water. You can also wash the grease filter in a dishwasher,

ensuring that you place it in an upright position to prevent damage from

other items in the dishwasher. After rinsing and drying, replace the filter.

Fig 2.

To remove the grease filter,

pushing the button on the handle

and then pull down on the filter

at the front, as shown in figure 2.

Once released at the front it can

be pulled completely away.

8 | Instruction Manual

Please note that cleaning the grease filter(s) in a dishwasher may

cause the filters to discolour. This is normal and does not constitute a

fault with the appliance.

Changing the charcoal filter

To ensure the best performance of your extractor, you should replace

the charcoal filter every three to six months, depending on the frequency

of use and the style of cooking. To attach new charcoal filters, first

remove the grease filter(s) as described on the previous page. Offer up

the charcoal filters to the sides of the motor as shown in figure 3, turning

it clockwise until it locks in place.

Please note that charcoal filters are only required when the extractor

is being used in recirculation mode. Charcoal filters are not supplied and

are available to purchase from our Customer Care team

Fig 3.

Instruction Manual | 9

Extractor lighting

The lighting on your extractor uses energy efficient LED technology

and is designed to last the lifetime of the product. If the LED system

malfunctions, please contact CDA Customer Care.

Operating modes

Your extractor can be used in either of two modes - recirculation or

extraction. The choice often depends on the specific installation

requirements. Your installer will be able to advise which is best for you.

Note that when used in recirculation mode, the extractor will only

remove grease and odours from cooking. It will not remove steam.

The LED units must only be replaced by a

competent appliance service engineer.

Fig 4.

Fig 5.

Filter

Extraction mode

(ducted outside)

Recirculation mode

(no ducting)

10 | Instruction Manual

Mains electricity connection

THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY

BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE

POLE SWITCHED FUSED SPUR OUTLET AND PROTECTED BY A

3A FUSE.

We recommend that the appliance is

connected by a qualified electrician,

who is a member of the N.I.C.E.I.C. and

who will comply with the I.E.T. and local

regulations.

The wires in the mains lead of this

appliance are coloured in accordance

with the following code:

BLUE = NEUTRAL, BROWN = LIVE, GREEN & YELLOW = EARTH

As the colours of the wires in the mains lead for the appliance may

not correspond with the coloured markings identifying the terminals

connecting to the fused spur, proceed as follows:

The wire which is coloured green & yellow must be connected to the

terminal marked E (Earth) or coloured green.

The wire which is coloured blue must be connected to the terminal

marked N (Neutral) or coloured black or blue.

The wire which is coloured brown must be connected to the terminal

marked L (Live) or coloured red or brown.

Fig 6.

Questo manuale è adatto per i seguenti modelli

Indice

Manuali Scrubber popolari di altre marche

Olympus

Olympus M200H Manuale utente

Clarke

Clarke BEXT 100H Manuale di installazione e funzionamento

JOHNY VAC

JOHNY VAC JVC70BCT Manuale utente

RCm

RCm Elan Series Manuale

Kärcher

Kärcher B 120 W Manuale utente

Truvox

Truvox Orbis MotorScrubber 20 Manuale utente

Numatic

Numatic TTB 4045/100 Manuale utente

U.S. Products

U.S. Products PEX 500-C-TICK Istruzioni operative

Mclennan

Mclennan C510 Manuale utente

Tennant

Tennant T20 LPG Manuale utente

Columbus

Columbus ARA 66 BM 100 Manuale utente

Numatic

Numatic TTV 678G / 300T Manuale utente

American-Lincoln

American-Lincoln 505-945 Manuale utente

FIORENTINI

FIORENTINI ET 65-75 Manuale utente

Floorpul

Floorpul ruby 48 blt Guida utente

Onyx

Onyx RX-34 Manuale utente

Dustbane

Dustbane Hurricane 400 Manuale utente

Sana

Sana EUJ-702 Manuale utente