Cervoz MEC-LAN-M102i Manuale utente
MEC-LAN-M102i
Mini PCI-e 2-port 10/100/1000 isolated Ethernet board
User’s Manual
First Edition, August 2021
© 2021 Cervoz Technology Co., Ltd. All rights reserved.
Reproduction without permission is prohibited
2
Mini PCI-e Ethernet Card
User’s Manual
The software described in this manual is furnished under a license agreement and may be
used only in accordance with the terms of that agreement.
Copyright Notice
© 2021 Cervoz Technology Co., Ltd. All rights reserved. Reproduction without permission is
prohibited.
Trademarks
Cervoz is a registered trademark of Cervoz Technology Co., Ltd. All other trademarks or
registered marks in this manual belong to their respective manufacturers.
Disclaimer
Information in this document is subject to change without notice and does not represent a
commitment on the part of Cervoz.
Cervoz provides this document “as is,” without warranty of any kind, either expressed or
implied, including, but not limited to, its particular purpose. Cervoz reserves the right to make
improvements and/or changes to this manual, or to the products and/or the programs
described in this manual, at any time.
Information provided in this manual is intended to be accurate and reliable. However, Cervoz
assumes no responsibility for its use, or for any infringements on the rights of third parties that
may result from its use.
This product might include unintentional technical or typographical errors. Changes are
periodically made to the information herein to correct such errors, and these changes are
incorporated into new editions of the publication.
Technical Support Contact Information
http://www.cervoz.com/contact.php
Cervoz Technology Co., Ltd.
Tel: +886-2-2911-9599
Fax: +886-2-2911-9566
3
Table of Contents
Chapter 1
Introduction
4
Overviews
4
Features
4
Installation Flowchart
5
Package Checklist
5
Chapter 2
Hardware Installation
6
Appendix
Pin Assignments
13
Board Side Pin Assignments
14
Device Side Pin Assignments
15
Technical Reference
16
MEC-LAN-M102i Specifications
16
MEC- LAN-M102i Dimensions
17
MEC- LAN-M102i Daughter Board Dimensions
17
Product Warranty Statement
18
4
1
Introduction
Overview
MEC-LAN-M102i is an Ethernet card for embedded PC. The card follows the Mini
PCI-e standard which is compliant with PCI Express x 1 classification and small form
factor (30×50.95 mm). This board fits in any host computer that has mini express card
slots. MEC- LAN-M102i is a highly cost-effective solution to expand Gigabyte network
for your computer.
Features
The PCI Express boards have the following outstanding features:
Single-Lane (x1) PCI-Express with throughput up to 5.0 / 2.5Gbps
Fully compliant with PCI-Express Base Specification Rev 2.0
Integrated 10/100/1000Mbps transceiver
IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, and IEEE 802.3z compliant
IEEE 802.3x Full-Duplex flow control
Complies with EN61000-4-2(ESD) Air-15kV, Contact-8kV
Complies with EN61000-4-4(EFT) 2kV
Complies with EN61000-4-5 2kV Surge protection
5
Installation Flowchart
Installation Flowchart of MEC-LAN-M102i
The following flowchart provides a brief summary of the procedure you should follow to
install the Mini PCI-e card:
Package Checklist
The following items are included in the Mini PCI Express board package:
Mini PCI-e Card x 1
Daughter Board x 1
Bracket x 1
M2.5 Screw x 2
20Pin Internal Connection Cable (30cm) x 2
Quick Installation Guide (Printed) x 1
Note: Notify your sales representative if any of the above items are missing or
damaged.
Connect the internal cable
Hardware Installation
Install the card in the Mini PCI-e slot
Connector Fixation
Confirm if device is ready to be used
Hardware Installation
Hardware Installation
6
2
Hardware Installation
This chapter describes the PCI Express Series hardware installation procedure. Since the
BIOS automatically assign the PCI Express board’s IRQ number and I/O addresses, you must
plug in the board before installing the driver.
Step 1
Connect the internal cable to the card
Note
Both sides of the cable connectors are the same, it doesn’t matter which side
you connect
7
Step 2
Install the card to the Mini PCI-e slot
Make sure you install the card in the right position (fool-proof design)
Step 3
Fix the card on the motherboard
Make sure you tighten up the screws to fix the card
8
Step 4
Card installation completed
Step 5
Connect the cable to the daughter board
Connect other side of the cable to the daughter board
Note
Both sides of the cable connectors are the same, it doesn’t matter which side
you connect
9
Step 6
Confirm if device is ready to be used
Start “Computer Management” program
Go to the route: My Computer → Manage → Device Manager → Network adapters
10
Connector Fixation
MECFIX –Versatile Mounting
1. Standard PCI/PCIe Bracket
PCI / PCIe IO Bracket
2. Low Profile PCI/PCIe Bracket
Low Profile IO Bracket
Indice
Altri manuali Cervoz Scheda di rete
Manuali Scheda di rete popolari di altre marche
Buffalo
Buffalo AirStation WLI-PCM-L11GP Manuale utente
National Instruments
National Instruments NI 9234 Manuale utente
Hama
Hama 49276 Manuale utente
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Manuale operativo
Compaq
Compaq Wireless LAN 100 Manuale utente
Bose
Bose PowerMatch Dante Manuale utente