2-1.982-1.98
General Cautions for SM Solenoid Valve series
Please read the safety notice carefully before using and pay attention to the safety caution
for this series of products.
WARNING: Electrification, High temperature and Instruction
SM solenoid coil with built-in rectifying circuit and electrified indicator light, with specification of
AC220V, the built-in circuit is heated when electrified with high surface temperature (It is within
safety range, Don’t worry ), Please avoid touching it.
(1) Direction ( Horizontal& Vertical )
(2) Terminal and Wire ( Pressed )
DC 24V Below ±0.1 mA
Below ±0.1 mA
Below ±0.1 mA
AC 110V
AC 220V
DC 12V Below ±0.1 mA
Press down manual
button to rotate the
switching position so
that solenoid valve on
the lock status.
The purpose of pressing
the manual button is to
provide manual test or
test run adjustment.
It is not for normal use.
Must be check the lock
status if it has been lifted.
Manually button must be
at Push position that it
can be normal used for
electronic control.
Terminal plug
Vertical
direction
Terminal base
Terminal base
Terminal
Horizontal
direction
Wire
AV220V Solenoid Coil
Operation and Instruction for manual for manual override
Sage surge voltage protection circuit
Method and description of the selection of terminal board
General Cautions for SM Solenoid Valve series
Safety notice
Select “ thread type connection plate ”, may select various
fitting in discretion and fixed by screw thread.
Note : It will cause plug and coil damaged because of pulling out fitting by wrong way.
Select “ connection plate with fitting ”, first select the
size of pipe diameter; just insert the pipe into position while
assembling, need no fitting tightening.
Selection specification of the through hole
connection plate :
(3) Terminal and Press chain ( Device positioning )
(4) Press chain and Socket ( Pressed and Pulled )
Lacquer covered
wire pressed place
Core wire
pressed place Core wire
Max coverage Ø1.7mm
0.2 ~ 0.33 mm²
Lacquer covered wire
Thread type :
Thread type
connection plate
Screw
With fitting type :
Leak proof gasket
Screw
With fitting type
connection
Pipe
fitting
Pressed Pull
Press down the hook to make it detach
Pull out fitting
Note : The solenoid valve with fitting that
the height is lower and easy to install.
Ø8
Piping of fitting type
SM5000
Thread type
Model 1/8 1/4 Ø4 Ø6
SM7000
Ø10 Ø12
SM9000
3/8
Selection and use of the through hole connection plate
