MEG-1000
Page nº 3
Two output relays with temporisation adjustment are available: high resistance
relay (NORMAL) and low resistance relay (ALARM). The trip value and the delay
can be adjusted on each relay. The adjustment is done by means of three rear
push buttons (MODE,
,
). All adjustments are memorised even if the equipment
is not powered on.
The equipment has five led in the front plate, that indicate the measuring scale
and the output relays status in the operation mode; and the adjusted parameter in
the set-up mode.
Before operating the instrument read the INSTALLATION and ADJUST chapters
and choose the properly operation mode.
3.- INSTALLATION AND START-UP
The manual you hold in your hands contains information and warnings that the
user should respect in order to guarantee a proper operation of all the instrument
functions and keep its safety conditions.
The instrument must not be powered on and used until its definitive assembly on
the cabinet’s door.
If the instrument is not used as manufacturer’s specifications, the protection of
the instrument can be damaged.
When any protection failure is suspected to exist (for example, it presents external
visible damages), the instrument must be immediately powered off. In this case
contact a qualified service representative.
