Cisco MA-UMNT-MR-A3 Manuale utente

MA-UMNT-MR-A3 Aruba Mounting Adapter Installation Guide

Overview

The MA-UMNT-MR-A3 is a universal mounting adapter designed to simplify the transition from Aruba to Cisco Meraki access points. This adapter works with

MR33, MR42/42E, MR52, MR53/53E, MR45/55, MR36/46/46E/56 indoor access points. MA-UMNT-MR-A3 can be attached directly to the Aruba mount without

the need to remove this mount from its current mounting location. Supported Aruba mounts: JW046A, JW047A, AP-200-MNT-W2, AP-220-MNT-W2,

AP-220-MNT-W2W.

Package Contents

MA-UMNT-MR-A3 standard package includes the following equipment:

•1x MA-UMNT-MR-A3

•1x PH#2 M4XP0.6X14L security screw

•2x PH 19mm long screws, M3.5 threads

•1x TORX M4XP0.6X14L security screw

Note: The MA-UMNT-MR-A3 does not work with any of the outdoor MR access points.

Note: The MA-UMNT-MR-A3 cannot mount Meraki access points by itself and must be paired with one of the listed Aruba mounts.

Collect Tools

You will need the following tools to perform an installation:

1x Phillips head screwdriver

1x TORX screwdriver

Installation Instructions

Remove the current Aruba access point from the Aruba mount and ensure that the security lock on MA-UMNT-MR-A3 is not engaged.

1. If JW046A / JW047A Aruba mounts are used, position the MA-UMNT-MR-A3 to align with the currently installed Aruba mount, placing the MA-UMNT-

MR-A3 so that it’s mounting tabs are at an angle of approximately 30 degrees to the Aruba mount. Pushing toward the wall, rotate the MA-UMNT-MR-A3

clockwise until it clicks into place.

If AP-200-MNT-W2 / AP-220-MNT-W2 / AP-220-MNT-W2W Aruba mounts are used, align the pins on the rear panel of the MA-UMNT-MR-A3 with the slots on

the Aruba mount plate. Press the button on the bottom on the Aruba mount in and slide the MA-UMNT-MR-A3 into the Aruba mount until the pins are fully

engaged. Release the button to secure the MA-UMNT-MR-A3 to the Aruba mount. For additional security, insert the Torx security screw into the hole located

next to the button to lock the MA-UMNT-MR-A3 to the Aruba mount.

2. Use a Phillips head screwdriver to secure MA-UMNT-MR-A3 and ensure it’s in a locked position.

3. Use the two Phillips head screws included in the mount kit to attach your Meraki mount cradle to the MA-UMNT-MR-A3 mount.

Attach your Meraki access point to the Meraki mount cradle by lining up the top edge of the AP with the top tab of the mount cradle. Since the cradle is already

mounted to MA-UMNT-MR-A3 universal mount, guide the AP towards the top tab and insert the top tab into the AP slot.

Then adjust your AP to guide the bottom slot into the cradle’s bottom tab until it clicks into place.

Once in place, the AP should be secured to the cradle by using one of the included screws in the cradle’s bottom tab.

4. Run Ethernet cable(s) to LAN Access ports of your Meraki access point and connect into the appropriate LAN Access port(s). Note some Meraki APs

have 1x LAN port and some have 2x LAN ports. Secure the AP with a Torx security screw.

Indice

Altri manuali Cisco Hardware di rete

Cisco

Cisco WAVE-574-K9 - Wide Area Virtualization Engine... Manuale

Cisco

Cisco ATM Cable Interface Processor ACIP-SM(=) Manuale dell'operatore

Cisco

Cisco NM-1A-T3 - 1port Ds3 Atm Network Module Manuale utente

Cisco

Cisco Network Storage System NSS3000 Series Manuale utente

Cisco

Cisco ON100 Network Agent Manuale utente

Cisco

Cisco CTM GateWay Guida all'installazione

Cisco

Cisco RSP4+ Bootflash Memory Upgrade to 16MB... Manuale dell'operatore

Cisco

Cisco GS7000 Guida

Cisco

Cisco Firepower 9300 Manuale

Cisco

Cisco NCS 4201 Manuale

Cisco

Cisco Meraki MX68 Manuale

Cisco

Cisco MERAKI CW9166D1 Manuale utente

Cisco

Cisco CATALYST 6000 Manuale di installazione e funzionamento

Cisco

Cisco ONS 15540 ESP Manuale

Cisco

Cisco Aironet 340 Series Manuale utente

Cisco

Cisco ONS 15454 Series Manuale

Cisco

Cisco CSS11501 - 100Mbps Ethernet Load Balancing... Manuale utente

Cisco

Cisco 5500 Series Manuale utente

Cisco

Cisco WAE-674-K9 - Wide Area Application Engine... Manuale

Cisco

Cisco IPS-4260-K9 - IPS Sensor 4260 Manuale utente

Cisco

Cisco Firepower 9300 Guida alla manutenzione e all'assistenza

Cisco

Cisco IAD1101 Manuale utente

Cisco

Cisco Prisma EtherLinX Manuale utente

Cisco

Cisco Aironet 340 Series Manuale utente

Manuali Hardware di rete popolari di altre marche

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuale utente

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuale utente

Yudor

Yudor YDS-16 Manuale utente

D-Link

D-Link ShareCenter DNS-320L Manuale utente

Samsung

Samsung ES1642dc Istruzioni per l’uso

Honeywell Home

Honeywell Home LTEM-PV Istruzioni per il montaggio

evertz

evertz 7700 Series Manuale utente

D-Link

D-Link ShareCenter DNS-343 Manuale utente

Asante

Asante AsanteBridge 1012 Manuale utente

FireBrick

FireBrick FB2700 Manuale utente

Audiovox Electronics

Audiovox Electronics ARWH2T Manuale utente

ADC

ADC DSX-1 Manuale

NetComm

NetComm NF2 Manuale utente

Alcatel-Lucent

Alcatel-Lucent 5620 Manuale utente

Dell EMC

Dell EMC XC6420 Series Manuale utente

Lanner

Lanner NCA-1020A Manuale utente

Allied Telesis

Allied Telesis AT-TN121-A Manuale utente

Arista

Arista CCA-ETM-Q12 Manuale utente