Clark Synthesis Diluvio Manuale utente

Installation Guide

Diluvio™ Underwater Loudspeaker

Installed in a Hayward Face Rim

is procedure uses the following parts:

• Diluvio™ Underwater Loudspeaker

• Hayward Stainless Steel Face Rim, Part Number SPX0580AS

• Hayward Assembly Clamp with Screw, Nut, and Washer, Part Number SPX0580BS

• Hayward Face Rim Lockscrew, Part Number SPX0980Z3

1 2

3 4

5 6

Remove the Diluvio™ Loudspeaker from its box. Using a pair of wire cutters, carefully remove 1 inch (2.54

cm) of the sound lens rubber ring (see Photo #1 below). DO NOT CUT the rubber ring that holds the

speaker wire. Next, remove the screw, nut, and washer from the assembly clamp (#2). Carefully spread the

assembly clamp so it can go around the sound lens rubber ring. Place the assembly clamp around the sound

lens rubber ring leaving the 1 inch (2.54 cm) gap in the rubber ring exposed (#3). Reinstall the screw, nut

, and washer in the assembly clamp (#4).

Carefully place the Hayward face rim (chrome side down) on a non-abrasive surface, and place the speaker

and assembly clamp on the Hayward face rim (#5). Align the assembly clamp screw so that it does not

cover the mounting tab or the face rim lockscrew. Once aligned, tighten the assembly clamp screw until

the speaker is securely attached to the face rim (#6). Do not overtighten. e gap in the rubber ring will

be reduced.

Diluvio™ INSTALL- HAYWARD FACE RIM

Underwater Speaker- Hayward Page 2 of 4 www.clarksynthesis.com

7 8

910

Insert the lockscrew in the face rim (#7). Place the lockwasher onto the screw threads and turn the screw

until the lockwasher is seated against the inside of the face rim (#8).

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using a wire

puller (#9). Leave 10 to 12 . of wire in the niche to allow for easier access during future servicing of the

speaker (#10).

Diluvio™ INSTALL- HAYWARD FACE RIM

Page 3 of 4 Underwater Speaker- Hayward

www.clarksynthesis.com

13 14

Place the speaker inside the light niche (#11). While inserting the speaker, carefully set the lock tab located

on the bottom of the face rim behind the receiving plate located on the bottom of the niche (#12). Align

the lockscrew on the face ring with the threaded receiving hole on the niche (#13). Attach the trim ring

securely to the niche by gently tightening the screw (#14). You are now ready to connect the speaker to

your audio system.

11 12

Diluvio™ INSTALL- HAYWARD FACE RIM

Underwater Speaker- Hayward Page 4 of 4 www.clarksynthesis.com

Indice

Altri manuali Clark Synthesis Altoparlanti