CNB NB21-7MHR-6 Manuale utente

MB12-7MH

Owner’s Manual

NB21-7MHR-6

Fusion IR Full HD Bullet IP Camera

-7

R-

-6

r’

’s

Rev.1.4

The lightning flash with arrowhead symbol, within an equilateral triangle, is

intended to alert the user to the presence of uninsulated “dangerous voltage"

within the product's enclosure that may be of sufficient magnitude to constitute

a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to

the presence of important operating and maintenance (servicing) instructions in

the literature accompanying the appliance.

THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM OF THE SYSTEM.

"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE"

Directions

Be careful not to cause any physical damage by dropping or throwing IP Camera. Especially keep

the device away from children.

Do not disassemble IP Camera. No After Service is assumed when disassembled.

Use only the power adapter provided with IP Camera.

Be careful to prevent moisture or water penetration into the unit. Particular attention is needed

when installing IP Camera. The screw holes for the installation screws and pipes should be

maintained tight during the whole life time of the product.

All the electrical connection wires plugging in the unit should be prepared so that water from the

outside cannot flow into the unit through the surface of the wires. Penetration of the moisture

through the wire for extended period can cause malfunction of the unit or deteriorated image.

CAUTION!

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO

NOT REMOVE COVER (OR BACK). NO USER

SERVICEABLE PARTS INSIDE. REFER SERVICING

TO QUALIFIED SERVICE PERSONNEL.

MB12-7MH

Owner’s Manual

-7

R-

-6

r’

’s

Rev.1.4

CAUTION!

Changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate the equipment.

Regulatory Notice

This equipment has been tested and found to comply with limits for a Class of digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at their own

expense.

-7

R-

-6

r’

’s

Rev.1.4

Contents

1. Introduction....................................................................................................................................................5

1.1. Overview...............................................................................................................................................5

1.2. Features & Specification.......................................................................................................................6

1.2.1.

......................................................................................................................................6

................................................................................................................................6

1.3. Applications of IP Camera ....................................................................................................................9

2. Product Description ....................................................................................................................................10

2.1. Contents..............................................................................................................................................10

2.2. Camera mount configuration...............................................................................................................10

2.3. Product Preview..................................................................................................................................11

2.4. Physical description ............................................................................................................................11

2.4.1. External View............................................................................................................................11

2.4.2. Dimension.................................................................................................................................12

2.4.3. External Connector...................................................................................................................12

2.4.4. Factory Default Switch..............................................................................................................12

2.5. Functional Description ........................................................................................................................13

3. On Site Installation ......................................................................................................................................15

4. Getting Started.............................................................................................................................................17

4.1. PC Requirement .................................................................................................................................17

4.2. Quick Installation Guide......................................................................................................................17

4.2.1. Connect PC and IP Camera to network. ..................................................................................17

4.2.2. Install IP installer and set IP parameters on IP Camera...........................................................18

4.2.3. Remote video connection to IP Camera...................................................................................21

4.2.4. Additional settings through connection to the Admin Page......................................................22

5. Troubleshooting...........................................................................................................................................23

5.1. No power.............................................................................................................................................23

5.2. Cannot connect to the Video...............................................................................................................23

5.3. Windows 7 ..........................................................................................................................................24

5.4. Technical Assistance...........................................................................................................................25

AppendixA–Important Noticein ExchangingSD Card(MicroSD).........................................................................26

-7

R-

-6

r’

’s

Rev.1.4

1. Introduction

1.1. Overview

The product is multi-codec (H.264, MJPEG) IP camera (or network camera) built with embedded software and

hardware technology. It enables real time transmission of synchronized video up to 1,080P and audio data.

Remote clients can connect to IP Camera for the real time video/audio data through various client solutions

running on PC or smart device. Real time 2-way communication is available through bidirectional audio

communication feature.

Dark Hunter technology is the most optimized solution for indoor and outdoor surveillance in low-light conditions

by using superior CMOS sensor with low-light sensitivity ISP sensor.

Furthermore, it can get much vivid image using Super IR LED in extremely low light conditions compared with

using conventional IR LED.

Designed to be a stand-alone streaming audio & video transmission device, the product can be applied to

various application area such as video security, remote video monitoring, distance education, video conference

or internet broadcasting system.

Vandal proof and weather proof housing will extend the application area to harsh environment of wide

temperature range. Embedded PoE (Power of Ethernet, IEEE 802.3af) will enable the owner to reduce TCO

(Total Cost of Ownership) by reducing on-site wiring works for the installation.

-7

R-

-6

r’

’s

Rev.1.4

1.2. Features & Specification

1.2.1.

H.264MP IP Camera

Fusion IR Full HD Bullet IP Camera

1/3” Progressive scan CMOS Sensor

Dual-Codec (H.264MP/MJPEG)

Progressive scan megapixel (2M CMOS)

Multi profile streaming

(5 different streams per Resolution, Frame, Rate, Codec)

Digital PTZ, video crop

Analog video output (CVBS)

Built-in standard PoE

Two-way audio communication

Dark Hunter + Super IR LED

Compact design & Easy installation

Vandal proof, Weather proof (IP66)

Camera

Image sensor

Progressive scan 1/3 inch CMOS 2M pixels

Full resolution

1,920 x 1,080 pixels (Full HD)

Sync System

Internal

Lens

6mm Fixed

Day & Night

AUTO, DAY, NIGHT

Sensitivity

Color : to 0.04Lux, B/W : 0Lux(IR ON)

Back Light Compensation

ON / OFF

White Balance

ATW(2.000K ~ 10,000K) / MANUAL / PUSH

Exposure

DC / ESC

WDR

ON / OFF

3D-DNR

0 ~ 20

Dark Hunter

AUTO ON (Max. x32) / OFF

Privacy Mask

ON / OFF (1 Programmable Zone)

Motion Detection

ON / OFF (3 Programmable Zone)

Digital Zoom

X1 ~ X12

-7

R-

-6

r’

’s

Rev.1.4

Mirror

H / V / Rotate

DEFOG

ON / OFF

OSD

BUILT IN

Super IR LED

2EA

Video

Compression method

Simultaneous Dual Codec (H.264MP / MJPEG)

Resolution

1,920 x 1,080@30fps

Multi-Profile Streaming

- 5 simultaneous video profiles

- Select the codec type, resolution and frame rates for each profile.

Intelligent Bit-Rate Control

Hybrid Bit Rate control (VBR+CBR)

PTZ

Digital PTZ & Video crop

Image Setting

Text overlay, Privacy mask, De-interlace filter

Motion detection

3 regions

Audio

Mono Upstream

32Kbps G.726 ADPCM, 64Kbps 16bit μ-law PCM ~ MIC/Line-in

Mono Downstream

64Kbps 16bit μ-law PCM ~ Line-out

Network

Network Protocol

- IPv4, TCP/IP, UDP, IGMP, ICMP, ARP, RARP, PPPoE, RTCP

- RTP, RTSP, SDP, HTTP, SMTP, FTP, DHCP, UPnP

- NTP, DNS, DynDNS

Dynamic IP

Supported

Security

- User ID & Password protection, IP address filtering

- Digest Authentication, User Access Log

Streaming method

- RTSP streaming with proprietary format for control information

- standard RTSP streaming

- HTTP streaming

- Onvif Profile-S

External Terminals

LAN

10/100BaseT LAN (auto MDIX)

Analog output

1 channel D1 CVBS output of the encoding video

Alarm input / output

Alarm I/O (1 Sensor input & 1 Relay output)

Factory Reset

Supported

Other

MIC, Line in / Line out / DC 12V in

Installation

Standard PoE

IEEE802.3af Supported

System Integration

Intelligent Video

Motion Detection

-7

R-

-6

r’

’s

Rev.1.4

Alarm Triggers

Motion Detection + Sensor Input +Audio Detection

Alarm Events

Video file upload(FTP), Still Image transmission(Email), Relay output

Alarm Buffer (Audio/Video)

Configurable Pre-alarm (5~15 sec) & Post-alarm (10~60 sec)

Operating Environment, Power, Dimensions

Operating Temperature

-10C ~ 50C

Operation Humidity

8 ~ 80% RH

Power

DC 12V, 0.6A

Dimensions(W x H x D)

Ø 99mm x 252.7mm

Weight

1.1kg

Casing

AL, PC, IP66

Approvals

FCC, CE, KC

Package information

IP camera, CD (User’s guide, Software…)

Client Software

NVR2

64ch (free of charge)

Mobile

Android, iOS (free of charge)

Optional Items

Local storage

Micro SD card

Adapter

DC 12V, 1.5A

-7

R-

-6

r’

’s

Rev.1.4

1.3. Applications of IP Camera

Security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities,

military, etc.)

Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)

Teleconference (Bi-directional audio conference). Remote Learning, Internet broadcasting

Weather and environmental observation

-7

R-

-6

r’

’s

Rev.1.4

2. Product Description

2.1. Contents

The product package contains followings:

Contents

Description

Remarks

IP Camera

NB21-7MHR-6 main unit

Accessories

Screws

L-type wrench, CVBS Cable

Guide pattern

Software & User’s Guide

Power Adaptor

Default built in standard PoE module

(IEEE802.3af)

12V DC Adaptor

(Optional item)

2.2. Camera mount configuration

Questo manuale è adatto per i seguenti modelli

Altri manuali CNB Telecamera di sicurezza

Manuali Telecamera di sicurezza popolari di altre marche

Okina USA

Okina USA SIR36-870VF650LP Manuale utente

Divio

Divio NDR155PA Manuale utente

Canon

Canon VB-C500D Manuale utente

Easy Access

Easy Access EasyGuard Manuale utente

Vivotek

Vivotek FD9389-EHV-v2 Manuale utente

TUYA

TUYA COSMO W2 Manuale utente

Eusso

Eusso UNC7500-IR Guida all'installazione

urmet domus

urmet domus 1096/204 Manuale utente

VC VC20 series Manuale utente

Axis

Axis Q1614 Manuale utente

ieGeek

ieGeek DD201 Manuale utente

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuale utente

Vicon

Vicon V662-D-1 Istruzioni operative

Grundig

Grundig GCH-K0274P Manuale utente

Lorex

Lorex VANTAGE LBC7032 Manuale utente

4xem

4xem WPT Manuale utente

Samsung

Samsung SCV-3082 Manuale utente

Vitek

Vitek VTC-C544 Manuale utente