Crestron TPS-ENET Come usare
Crestron TPS-ENET
Ethernet Card for TPS/Tilt Panel
Operations & Installation Guide
This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
All brand names, product names and trademarks are the property of their respective owners.
©2002 Crestron Electronics, Inc.
Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Contents
Ethernet Card for TPS/Tilt Panel: TPS-ENET 1
Introduction......................................................................................1
Features and Functions ..........................................................1
Specifications.........................................................................2
Connector Specifications.......................................................3
Physical Description ..............................................................3
Industry Compliance..............................................................5
Setup.................................................................................................5
Installation and Hookup.........................................................5
Obtaining Communications...................................................9
Ethernet Setup......................................................................13
Communicating with the Touchpanel via Ethernet.............15
Programming..................................................................................16
Programming with the Crestron AppBuilder ......................17
Programming with SIMPL Windows..................................18
Problem Solving.............................................................................21
Troubleshooting...................................................................21
Further Inquiries ..................................................................22
Firmware Upgrades .............................................................22
Future Updates.....................................................................22
Return and Warranty Policies ........................................................23
Merchandise Returns / Repair Service .......................23
CRESTRON Limited Warranty ...................................23
Operations & Installation Guide - DOC. 6016 Contents •i
Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Ethernet Card for TPS/Tilt Panel:
TPS-ENET
Introduction
Features and Functions
The TPS-ENET Ethernet card is an optional feature designed for
Crestron’s Isys®TPS-5000 and TPS-6000 tilt touchpanels. The card
provides communication via Ethernet/local area network (LAN) and wide
area network (WAN) to any Crestron®Internet protocol (IP) control
device. Adding Ethernet capabilities into the touchpanel via SIMPL
Windows allows remote diagnostics and upgrades, access to Crestron’s
network analyzer, and the ability to activate any device connected to the
Crestron remote control system (herein referred to as the Cresnet®
system). The TPS-ENET also allows a TPS touchpanel to communicate
through Ethernet with multiple control systems. Refer to “Ethernet
Setup” on pages 13-15. For additional information, refer to the “Ethernet
Touchpanels” and “IP Table Setup” sections of the latest revision of the
Crestron e-Control Reference Guide (Doc. 6052). The latest version can
be obtained from the Downloads | Product Manuals section of Crestron’s
website (www.crestron.com).
Functional Summary
Provides Ethernet communication for a TPS touchpanel
10BaseT or 100BaseT, half or full duplex networking
Supports several protocols including TCP/IP, UDP/IP, etc.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET •1
Ethernet Card for TPS/Tilt Panel Crestron TPS-ENET
Specifications
The table below provides specifications for the TPS-ENET.
Specifications of the TPS-ENET
SPECIFICATION DETAILS
Power Requirements 4 Watts (0.167 Amps @ 24 VDC)
Control S
y
stem U
p
date Files1, 2, 3
2-Series Control System Update Version C2-2004.CUZ or later
CNMSX-AV/Pro Update File (.upz) Version 51263X or later
CNRACKX/-DP Update File (.upz) Version 51263W or later
CEN/CN-TVAV Update File (.upz) Version 51263V or later
Acceptable file extension: (TPS 5000L and 6000L only)
.csf TPS.v1.013.0 .csf or later (panel
firmware file)
Network Type 10BaseT/100BaseT, half or full duplex
Protocols TCP/IP, UDP/IP, ICMP (Ping), & CIP
Default IP Ports 41795 (Viewport/Diagnostics)
41794 (CIP)
LED Indicators GREEN for link status and YELLOW for
Ethernet activit
y
Dimensions & Wei
g
ht Hei
g
ht: 0.64 in
(
1.61 cm
)
Width: 1.13 in (2.86 cm)
Depth: 5.75 in (14.61 cm)
Weight: 1.20 oz (0.03 kg)
1. The latest versions can be obtained from the Downloads | Software Updates section of the Crestron website
(www.crestron.com). Refer to NOTE after last footnote.
2. Crestron 2-Series control systems include the AV2, PAC2, PRO2, and RACK2.
3. CNX update files are required for either CNMSX-AV/PRO or CNRACKX/-DP. Filenames for CNX update
files have a UPZ extension and are in one EXE or zipped UPZ file. To avoid program problems, make certain
you are using the update file with the correct suffix letter (e.g., S, V, W, X).
NOTE: Crestron software and any files on the website are for
Authorized Crestron dealers only. New users may be required to register
to obtain access to certain areas of the site (including the FTP site).
2 •Ethernet Card for TPS/Tilt Panel: TPS-ENET Operations & Installation Guide - DOC. 6016
Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Connector Specifications
Connector Specifications of the TPS-ENET
PORT TYPE SIGNAL(S)
Touchpanel
Interface
40-pin connector Various
Pin 1 TD+
Pin 2 TD-
Pin 3 RD+
Pin 4 Connected to pin 5
Pin 5 Connected to pin 4
Pin 6 RD-
Pin 7 Connected to pin 8
Pin 8 Connected to pin 7
LAN (8-wire
RJ45)
RJ 45 Pinouts
18
18
Front
Top
NOTE: To determine which is pin 1 on the cable, hold the cable so that
the end of the eight pin modular jack is facing away from you, with the
clip down and copper side up. Pin 1 is on the far left.
Physical Description
The TPS-ENET card, as shown on the next page, is a printed circuit
board (PCB) that is designed to be installed in a specific expansion slot
on the touchpanel motherboard. The card contains a 40-pin connector
that attaches directly to the motherboard and the card is secured with two
mounting screws (supplied with TPS-ENET). An 8-position RJ45 port
(labeled LAN on the touchpanel) is permanently attached to the
motherboard and is accessible through the connector panel at the rear of
the touchpanel base. The port is used for connection to the Ethernet
(cable is not supplied). The port also contains two light-emitting diodes
(LEDs). The green LED on the left side of the port is a link status LED
and illuminates when the card is connected to a working network. The
yellow LED on the right-side flashes to indicate Ethernet activity.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET •3
Ethernet Card for TPS/Tilt Panel Crestron TPS-ENET
TPS-ENET Physical Views
TPS-ENET Side View
0.631 in
1.603 cm
Touchpanel connector
TPS-ENET Top View
5.750 in
14.605 cm
1.125 in
2.858 cm
4 •Ethernet Card for TPS/Tilt Panel: TPS-ENET Operations & Installation Guide - DOC. 6016
Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel
Touchpanel LAN Port (for reference only)
RGB LANNET/VIDEO 24VDC 2.0A
LINK STATUS
LED (GREEN)
ETHERNET
ACTIVITY
LED (YELLOW)
81
Industry Compliance
As of the date of manufacture, the TPS-ENET has been tested and found
to comply with specifications for CE marking and standards per EMC
and Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Setup
Installation and Hookup
The TPS-ENET is designed to be installed in a specific expansion slot in
the TPS-5000 and TPS-6000 touchpanels. The tools required for
installation are a grounding strap (or grounded workstation) and a #1
Phillips screwdriver.
CAUTION: The TPS-ENET and the touchpanel contain electrostatic
discharge sensitive devices (ESDs); observe precautions for handling
ESDs to avoid damaging the card and/or the touchpanel.
Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET •5
Ethernet Card for TPS/Tilt Panel Crestron TPS-ENET
NOTE: If the angle of the touchscreen needs to be adjusted, refer to the
latest revision of the TPS-5000 or TPS-6000 Operations Guide (Doc.
5863 or 5864, respectively) for instructions of how to use the touchpanel
position lock buttons. The latest version of the appropriate Operations
Guide can be obtained from the Downloads | Product Manuals section of
Crestron’s website (www.crestron.com).
NOTE: The diagrams in this procedure show a TPS-6000 touchpanel
but the steps for installation in the TPS-5000 are identical.
1. If the optional external AC power pack is utilized, disconnect
the plug of the power pack from the touchpanel rear port
labeled 24VDC 2A.
2. To prevent errors when re-connecting, label and disconnect all
cables attached to the touchpanel rear panel ports.
3. If necessary, use the touchpanel position lock buttons to adjust
the touchscreen to the maximum (most vertical/upright) angle.
4. To prevent scratching of the screen, place the touchpanel face-
down onto a padded surface.
5. With one hand, hold the touchpanel base cover in place.
6. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen and remove the eight screws that secure the touchpanel
base cover.
Remove Touchpanel Base Cover Screws
6 •Ethernet Card for TPS/Tilt Panel: TPS-ENET Operations & Installation Guide - DOC. 6016
Indice
Altri manuali Crestron Scheda di rete
Manuali Scheda di rete popolari di altre marche
Buffalo
Buffalo AirStation WLI-PCM-L11GP Manuale utente
National Instruments
National Instruments NI 9234 Manuale utente
Hama
Hama 49276 Manuale utente
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Manuale operativo
Compaq
Compaq Wireless LAN 100 Manuale utente
Bose
Bose PowerMatch Dante Manuale utente