Danfoss DEVIreg 530 Manuale utente

www.DEVI.com

Installation Guide

DEVIreg™ 530

Electronic Thermostat

DEVIreg™ 530

Installation Guide2

The English language is used for the original instructions.

Other languages are a translation of the original instructions.

(Directive 2006/42/EC)

DEVIreg™ 530

Installation Guide 3

1 Introduction

DEVIreg™ 530 is an electronic thermostat provided with a

2-pole switch and a wire sensor to measure and control the

desired oor temperature. It can be either ush-mounted

(standard) or surface-mounted (using special box).

The thermostat has a button for adjusting the temperature

setting with a scale from ( ) 1 to 6 (each step corresponds

to approximately 8°C). Furthermore, it has a LED indicator

showing standby periods (green light) and heating periods

(red light).

More information on this product can also be found at:

devireg.devi.com

Table of Contents

1 Introduction . . . . . . . . . . . . . . . . . . . . . . . 3

1.1 Technical Specications . . . . . . . . . . . . 4

1.2 Safety Instructions . . . . . . . . . . . . . . . . 5

2 Mounting Instructions . . . . . . . . . . . . . . . . 6

3 Settings . . . . . . . . . . . . . . . . . . . . . . . . . . 10

4 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . 12

5 Disposal Instruction . . . . . . . . . . . . . . . . . . 14

DEVIreg™ 530

Installation Guide4

1.1 Technical Specications

Operation voltage 220-240V~, 50Hz

Standby power

consumption

Max 0.25W

Relay:

Resistive load

Inductive load

Max 15A / 3450W @ 230V

cos φ= 0.3 max 1A

Sensing units NTC 15kOhm at 25°C

Sensing values:

0°C

25°C

50°C

42 kOhm

15 kOhm

6 kOhm

Hysteresis ± 0.4°C

Ambient temperature -10 to +30°C

Frost protection

temperature

5 °C -

Temperature range ( ) 5-45°C with oor

sensor only

Cable specication max 1x4mm² or 2x2,5mm²

Ball pressure temperature 75 °C

Pollution degree 2 (domestic use)

DEVIreg™ 530

Installation Guide 5

Type 1C

Storage temperature -20 to +65°C

IP class 31

Protection class Class II -

Dimensions 85 x 85 x 36 mm

Weight 90 g

The product complies with the EN/IEC Standard «Automatic

electrical controls for household and similar use»:

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

1.2 Safety Instructions

Make sure the mains supply to the thermostat is turned o

before installation.

IMPORTANT: When the thermostat is used to control a

oor heating element in connection with a wooden oor or

similar material, always use a oor sensor and never set the

maximum oor temperature to more than 35°C.

Please also note the following:

• The installation of the thermostat must be done by an

authorized and qualied installer according to local

regulations.

DEVIreg™ 530

Installation Guide6

• The thermostat must be connected to a power supply

via an all-pole disconnection switch.

• The sensor is to be considered as live voltage. Have

this in mind if the sensor must be extended.

• Always connect the thermostat to continuous power

supply.

• Do not expose the thermostat to moisture, water,

dust, and excessive heat.

2 Mounting Instructions

Place the thermostat at a suitable height

on the wall (typically 80-170cm.).

In wet rooms, place the thermostat according

to local regulation on IP classes.

DEVIreg™ 530

Installation Guide 7

Note: A oor sensor enables a more accurate

temperature control and is recommended

in all oor heating applications

and mandatory under wooden oors to

reduce the risk of over-heating the oor.

• Place the oor sensor in a conduit in an appropriate

place where it is not exposed to sunlight or draft from

door openings.

• Equally distant and >2cm from two heating cables.

• The conduit should be ush with the oor surface -

countersink the conduit if necessary.

• Route the conduit to the connection box.

• The bending radius of the conduit must be min 50mm.

DEVIreg™ 530

Installation Guide8

Follow the steps below to mount the thermostat:

1. Open the thermostat:

devireg™550

• Press the release tab in the bottom of the

thermostat using a at object.

• Carefully detach the front cover.

• Carefully detach the frame.

DEVIreg™ 530

Installation Guide 9

2. Connect the thermostat according to the connection

diagram.

IP31

-10T30

D530

Mains

220-240V~

Max. Load

15 (1) A

Sensor

NL NTC

LOAD

-5°C

9

By connecting an external timer to the terminal

marked by a moon symbol (and by using for example

the same phase as for the mains power supply), the

thermostat can be set to reduce the temperature by

5°C during specied periods.

The screen of the heating cable must be connected

to the earth conductor of the power supply cable by

using a separate connector.

Note: Always install the oor sensor in a conduit in

the oor.

DEVIreg™ 530

Installation Guide10

3. Mount and reassemble the thermostat.

• Fasten the thermostat to a socket or an exterior

wall box by driving the screws through the holes

in each side of the thermostat.

• Install the frame and front cover in the reverse

order of disassembly.

4. Turn on the power supply.

3 Settings

How to change the minimum and maximum oor

temperatures

1. Remove the adjustment button.

2. Move the pins to the desired

positions.

3. Put the adjustment button back

in place.

devireg™550

Note: Please be aware of the following:

• The oor temperature is measured where the oor

sensor is placed.

• The temperature of the bottom of a wooden oor can

be up to 10 degrees higher than the top.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Danfoss Termostato

Danfoss

Danfoss RET1000 B Manuale utente

Danfoss

Danfoss DEVIreg 531 Manuale utente

Danfoss

Danfoss GreenCon RC-T2 Manuale utente

Danfoss

Danfoss EFIT 540 Manuale utente

Danfoss

Danfoss FH-WS Manuale utente

Danfoss

Danfoss EFIT 550 Manuale utente

Danfoss

Danfoss RT1 Istruzioni di montaggio

Danfoss

Danfoss TP5001 series Manuale utente

Danfoss

Danfoss SET 3E Manuale utente

Danfoss

Danfoss REP24CO1 Manuale utente

Danfoss

Danfoss ECtemp 330 Manuale utente

Danfoss

Danfoss 3020P Istruzioni di montaggio

Danfoss

Danfoss ECtemp 130 Manuale utente

Danfoss

Danfoss RET2001RF Manuale utente

Danfoss

Danfoss DEVIreg 132 Manuale utente

Danfoss

Danfoss RET2001RF Manuale utente

Danfoss

Danfoss TRONE-RF Manuale utente

Danfoss

Danfoss RET B + RF Istruzioni operative

Danfoss

Danfoss Icon Master Manuale utente

Danfoss

Danfoss RET 230 HCW-1 Manuale utente

Danfoss

Danfoss RTW-RA Manuale utente

Danfoss

Danfoss TP7000 Series Manuale utente

Danfoss

Danfoss RT 106 Manuale utente

Danfoss

Danfoss TP5000 si range Manuale utente

Manuali Termostato popolari di altre marche

EWELLY

EWELLY EW-181 Manuale utente

Prolon

Prolon T1100 Istruzioni per l'installazione

Computherm

Computherm Q20 Manuale utente

Heatmiser

Heatmiser neoStat Manuale utente

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuale utente

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuale utente

Saswell

Saswell SAS920XWHB-7-S-RF Guida

Aircalo

Aircalo TFP1-ET85P2 Manuale utente

Honeywell

Honeywell CM721 Manuale utente

Carrier

Carrier DEBONAIR 33CS Manuale utente

Lennox

Lennox iHarmony Zone Thermostat Istruzioni per il montaggio

Gemtech

Gemtech GT7000 Manuale di istruzioni

Rollei

Rollei Smartes 45000 Manuale utente

Sinope

Sinope TH1300RF Manuale utente

Honeywell

Honeywell RLV4305 Manuale utente

Honeywell

Honeywell Prestige 2.0 THX9421 Manuale utente

NuTone

NuTone NTBZ48 Istruzioni operative originali

Stelpro

Stelpro MAESTRO ASMT402AD Manuale utente