Datalogic DL Cordless Card Manuale utente

Reference Manual

Cordless Card™

DL Cordless Card™

REFERENCE MANUAL

DATALOGIC S.p.A.

Via Candini 2

40012 - Lippo di Calderara di Reno

Bologna - Italy

DL Cordless Card™

Ed.: 12/2003

This manual refers to software version 1.0 and later

Datalogic reserves the right to make modifications or improvements without prior modifications.

Datalogic shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or

consequential damages resulting from the use of this material.

Products names mentioned herein are for identification purposes only and may be trademarks and or

registered trademarks of their respective companies.

03/12/03

iii

CONTENTS

1INTRODUCTION ..........................................................................................1

1.1 Overview.......................................................................................................1

1.2 LED Indicator................................................................................................2

2INITIAL SETUP ............................................................................................3

2.1 Configuration Strings.....................................................................................3

2.2 DLCC Setup..................................................................................................4

3CONFIGURATION........................................................................................5

4PARAMETER ISSUES AND DEFINITIONS...............................................15

4.1 Radio and Serial Communication Controls .................................................15

4.2 COM Port Parameters.................................................................................20

4.2.1 Handshaking...............................................................................................20

4.2.2 ACK/NACK Protocol....................................................................................22

4.2.3 RX Timeout.................................................................................................23

4.2.4 FIFO............................................................................................................23

4.2.5 Frame Packing............................................................................................24

4.3 Data Format................................................................................................26

4.3.1 Header/Terminator Selection......................................................................26

4.3.2 Address Stamping.......................................................................................27

4.3.3 Address Delimiter........................................................................................28

4.4 Radio Parameters.......................................................................................29

4.4.1 RF Baud Rate.............................................................................................29

4.4.2 Transmission Mode (Client only).................................................................29

4.4.3 Radio Protocol Timeout (Client only)...........................................................29

4.4.4 Single Store (Client only)............................................................................29

4.4.5 ACK/NACK From Remote Host (Client only) ..............................................30

4.4.6 Beacon (Client only)....................................................................................31

5DEFAULT CONFIGURATION....................................................................32

6TECHNICAL FEATURES...........................................................................33

REFERENCES

CONVENTIONS

This manual uses the following conventions:

"User" refers to anyone using a DL Cordless Card™.

"DLCC" refers to the DL Cordless Card™.

"You" refers to the System Administrator or Technical Support person using this

manual to install, configure, operate, maintain or troubleshoot a DLCC.

REFERENCE DOCUMENTATION

For further details refer to the card Quick Reference Manual and to the RHINO™

Reference Manual.

SERVICE, SUPPORT AND WARRANTY

Datalogic provides several services as well as technical support through its website.

Log on to www.datalogic.com/services/support and click on the links indicated for

further information including:

· Services - Warranty Extensions and Maintenance Agreements

· Support - Software Driver Downloads

· Contact Us - Listing of Datalogic Subsidiaries and Quality Partners

· Authorised Repair Centres

SAFETY PRECAUTIONS

Contact the competent authority responsible for the management of radio frequency

devices of your country to verify the eventual necessity of a user license.

Refer to the web site http://europa.eu.int/comm/enterprise/rtte/spectr.htm for further

information.

N2468

QUICK START

The following can be used as a checklist to verify all of the steps necessary for

complete installation of the DL Cordless Card™ for a DOS terminal and for a laptop

(with two PCMCIA overlaid slots for PC cards of type II and with Windows 98, ME,

XP, and later versions).

Installing to portable PC

1) Read all information in the section "Safety Precautions" at the beginning of

this manual.

2) Start your PC.

3) Insert the DLCC correctly in the PCMCIA slot. Refer to the PC user's

manual.

Figure 1 - Laptop Card Installation

A) Windows notifies the PC has a new hardware device (DLCC);

B) Windows searches for a driver;

C) Insert the enclosed installation CD-ROM and follow the procedure;

D) At the end of the driver installation, Windows assigns DLCC a virtual

COM port.

4) Configure the DLCC address according to your application. See

"Configuration Methods".

NOTE

The default communication parameters of the COM port are: 9600

baud, no parity, 8 data bits, 1 stop bit, handshaking disabled

The installation is now complete.

vii

Installing to DOS Terminal

Read all information in the section "Safety Precautions" at the beginning of this

manual.

1) Rhino™ will recognize the card if the correct drivers are loaded. Therefore,

before inserting the card into the terminal make sure that:

- in NEWCFG.SYS the driver for the PCMCIA serial ports is loaded:

A:\PCMCIA\PCMSCD.EXE

- the scan engine driver is correctly configured (COM 3, interrupt 5) and

loaded after PCMSCD.EXE:

A:\DRIVERS\REDIR.SYS -c3 -i5 -b3

The following is an example of the NEWCFG.SYS:

;Load PCMCIA drivers

DEVICE=A:\PCMCIA\CNFIGNAM.EXE /DEFAULT

DEVICE=A:\PCMCIA\PCMSSC40.EXE

DEVICE=A:\PCMCIA\PCMCSFUL.EXE

DEVICE=A:\PCMCIA\PCMRMAN.SYS

DEVICEHIGH=A:\PCMCIA\PCMSCD.EXE

; Scan Engine Device Driver

; (Emulate SE1200 on Com3 @ 9600 N-8-1 Irq5)

DEVICEHIGH=A:\DRIVERS\REDIR.SYS -c3 -i5 -b3

2) Insert the DLCC correctly in the PCMCIA slot. Refer to the terminal user's

manual.

Figure 2 - DOS Terminal Card Installation

viii

3) Start the DOS terminal. The system assigns DLCC a virtual COM port

(COM 3, interrupt 5).

4) Configure the DLCC address according to your application. See

"Configuration Methods" paragraph.

NOTE

The default communication parameters of the COM port are: 9600

baud, no parity, 8 data bits, 1 stop bit, handshaking disabled

The installation is now complete.

Indice

Altri manuali Datalogic Lettore di codici a barre

Datalogic

Datalogic DS8100A-3002 Manuale utente

Datalogic

Datalogic QLM500 Manuale utente

Datalogic

Datalogic DLL5100 Series Manuale utente

Datalogic

Datalogic Gryphon I GD44XX Manuale utente

Datalogic

Datalogic PowerScan RF Manuale utente

Datalogic

Datalogic QuickScan QBT2430 Manuale utente

Datalogic

Datalogic Gryphon 2D Series Manuale di installazione e funzionamento

Datalogic

Datalogic F725-E SERIES Manuale utente

Datalogic

Datalogic DS4300 Manuale utente

Datalogic

Datalogic DSM0400 Manuale di installazione e funzionamento

Datalogic

Datalogic Gryphon Series Manuale utente

Datalogic

Datalogic MAGELLAN 3200VSI Manuale di installazione e funzionamento

Datalogic

Datalogic DS8100A Manuale utente

Datalogic

Datalogic LYNX BT 432 Manuale di servizio

Datalogic

Datalogic QuickScan i QD2100 Manuale di installazione e funzionamento

Datalogic

Datalogic QuickScan Lite QW2470-BKK3S Manuale utente

Datalogic

Datalogic PowerScan Area Imager Manuale utente

Datalogic

Datalogic PowerScan PM9100 Series Manuale utente

Datalogic

Datalogic Gryphon I GD441 Series Manuale utente

Datalogic

Datalogic QuickScan QD2131 Manuale utente

Datalogic

Datalogic Magellan 1500i Manuale utente

Datalogic

Datalogic Magellan 1100i Manuale di installazione e funzionamento

Datalogic

Datalogic Gryphon I GBT4130 Manuale utente

Datalogic

Datalogic DS4600A Manuale utente

Manuali Lettore di codici a barre popolari di altre marche

POSMicro

POSMicro Datalogic PowerScan D7100 Manuale utente

Marson

Marson MT780 Guida rapida alla configurazione

NCR

NCR RealPOS Manuale utente

Motorola

Motorola SE3300 Guida rapida alla configurazione

Element

Element P130BT Manuale utente

Motorola

Motorola Symbol LS3008 Manuale di installazione e funzionamento

Meec tools

Meec tools OBD-II / VAG Manuale utente

SICK

SICK CLP 100 Manuale utente

Royal Tag SA

Royal Tag SA I-Read Manuale utente

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manuale utente

Meteor

Meteor 8310 Manuale utente

Denso

Denso BHT-500B Manuale utente

Motorola

Motorola MP6000 Istruzioni di montaggio

Newland

Newland NLS-HR15-BT Manuale utente

ARTDEV

ARTDEV AS-1310 Manuale utente

Aopos

Aopos AS290 Manuale utente

ENS

ENS 367-5455 Manuale utente

Atid

Atid AT188N Plus Manuale utente