Dell VersaRails Manuale di istruzioni
Throughout this guide, blocks of text may be accompanied by an icon and printed in
bold type or in italic type. These blocks are notes, notices, cautions, and warnings,
and they are used as follows:
NOTE: A NOTE indicates important information that helps you make better use of
your computer system.
!"
"#
$%&$%&!"
"#
Information in this document is subject to change without notice.
© 2001 Dell Computer Corporation. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Computer
Corporation is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and VersaRails are trademarks of Dell Computer
Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities
claiming the marks and names or their products. Dell Computer Corporation disclaims any propri-
etary interest in trademarks and trade names other than its own.
September 2001 P/N 6F566 Rev. A02
support.dell.com Installing VersaRails 1-1
This document provides instructions for trained service technicians to install Versa-
Rails in a four-post rack cabinet. One VersaRail kit is required for each system to be
installed in the rack.
Before attempting this installation you should read through this entire document
carefully.
For procedures on installing your system in the rack, see your Rack Installation Guide.
The kit includes the following items (see Figure 1-1):
One pair of VersaRails
Twelve 10-32 x 0.500 countersink Phillips-head screws
Twelve #10 conical washers
1-2 Installing VersaRails
See the safety instructions provided in your system’s System Information document
for additional information.
!
NOTES: Your Dell system is safety-certified as a free-standing unit and as a compo-
nent for use in a Dell rack cabinet using the Dell customer rack kit. The installation of
your system and rack kit in any non-Dell rack cabinet has not been approved by any
safety agencies. It is your responsibility to have the final combination of system and
rack kit in a non-Dell rack cabinet evaluated for suitability by a certified safety agency.
Dell disclaims all liability and warranties in connection with such combinations.
For instructions on installing the system itself, see your Rack Installation Guide.
10-32 x 0.500
Phillips-head
screws (12)
right side
left side
VersaRails (1 pair)
front of rack
conical
washers (12)
support.dell.com Installing VersaRails 1-3
See your Rack Installation Guide for important safety information.
To install the VersaRail kit components, you need the following tools:
#2 Phillips screwdriver
Measuring tape
Level
Installing the VersaRail kit and the system into a rack cabinet involves the following
tasks:
Installing the VersaRails in the rack
Installing the system chassis in the rack (see your Rack Installation Guide for
instructions)
You must allow 14 units (U) or 24.5 inches of vertical space for each system you install
in the rack. To install the rails in the rack, perform the following steps:
"#$%&
'(%()
!%'(
*!
1. Determine where you want to install the system in the rack.
2. Align the VersaRail with the rack’s front vertical rail (see Figure 1-2).
Each unit on the vertical rail consists of one 0.125-inch spacing and two
0.250-inch spacings. The 0.125-inch spacing is the beginning of a unit. Align the
bottom of the VersaRail with the 0.125-inch spacing on the vertical rails of the
rack. The first hole in the VersaRail aligns with second hole from the 0.125-inch
spacing on the vertical rail.
NOTE: The vertical rails in your rack may have round or square holes.
1-4 Installing VersaRails
3. Position the VersaRail’s mounting flange against the inner side of the rack's front
vertical rail so that the bottom of the VersaRail is aligned with the 0.125-inch
spacing on the rack’s front vertical rail (see Figure 1-2).
NOTE: Ensure that you use the mounting holes, as shown in Figure 1-2, to secure the
front of the VersaRails to the rack. The second mounting hole from the bottom of the
VersaRail is used to secure your system to the rack.
4. Secure the front of the VersaRail to the rack using three Phillips-head screws and
three conical washers (see Figure 1-3).
0.125-inch rail
spacing
bottom of
VersaRail
second hole
from the
0.125-inch rail
spacing
support.dell.com Installing VersaRails 1-5
5. Slide the back VersaRail’s mounting flange backward until the back mounting
flange fits snugly against the inner side of the back vertical rail.
6. With the VersaRail level, secure the back of the VersaRail to the rack using three
Phillips-head screws and three conical washers.
7. Repeat steps 2 through 6 to install the second VersaRail.
conical
washers (3)
Phillips-head
screws (3)
VersaRails (2)
1-6 Installing VersaRails
6F566ft2.fm Page 1 Friday, September 7, 2001 9:36 AM
Tout au long de ce guide, certains blocs de texte peuvent être accompagnés d'une
icône et imprimés en gras ou en italique. Ces blocs de texte correspondent à des
remarques, des mises en garde et des avertissements, et sont utilisés comme suit :
REMARQUE : UNE REMARQUE indique une information importante destinée à vous
aider à mieux utiliser votre système informatique.
!"#
$$$%&$$$%
'('
!#
)$$)$$
'('
! "#
Les informations fournies dans ce guide sont susceptibles d'être modifiées sans préavis.
© 2001 Dell Computer Corporation. Tous droits réservés.
La reproduction de ce document de quelque manière que ce soit sans l'autorisation écrite de Dell
Computer Corporation est strictement interdite.
Marques déposées utilisées dans ce guide : Dell, le logo DELL et VersaRails sont des marques
de Dell Computer Corporation.
Toutes les autres marques déposées et noms de marques utilisés dans ce document se rapportent
aux sociétés propriétaires des marques et des noms de ces produits. Dell Computer Corporation
décline tout intérêt dans l'utilisation des marques déposées et des noms de marques ne lui
appartenant pas.
Septembre 2001 Réf. 6F566 Rév. A02
6F566ft2.fm Page 2 Friday, September 7, 2001 9:36 AM
Indice
Lingue:
Altri manuali Dell Rack e supporto
Dell
Dell PowerEdge 4220 Manuale utente
Dell
Dell PowerVault MD1200 Manuale utente
Dell
Dell OptiPlex 780-USFF Manuale utente
Dell
Dell SPR-WL2-MNT Manuale utente
Dell
Dell PowerVault 770N Manuale utente
Dell
Dell EMC A16 Rails Manuale utente
Dell
Dell E-Flat Panel Stand Manuale utente
Dell
Dell PowerVault 770N Manuale utente
Dell
Dell OptiPlex 780-USFF Manuale utente
Dell
Dell SFF Manuale utente
Dell
Dell PowerVault MD1120 Manuale utente
Dell
Dell Mid-Mount Manuale operativo e di manutenzione
Dell
Dell OptiPlex 780-USFF Manuale utente
Dell
Dell SPR-RK3-MNT Manuale utente
Dell
Dell Precision 7920 Manuale utente
Dell
Dell A20 Manuale utente
Dell
Dell PowerEdge 2420 Guida rapida
Dell
Dell B13 Manuale utente
Dell
Dell PowerVault MD3060e Series Manuale utente
Dell
Dell 0HD058 - Monitor Stand For Latitude Manuale utente
