Ultimate outdoor bluetooth®speaker
DB1
QUICKSTARt guide
Using In and Around Water or Sand
IMPORTANT: Your DemerBox is only waterproof and sealed when the port plug is
properly inserted!
To Insert the Port Plug
1. Unscrew the port plug from its holder inside the DB1. To do this, use
one hand to hold the port plug collar while using your other hand to turn
the wings.
2. Close the DB1 lid and latch it.
3. Insert the port plug into the port tube outside the DB1 until the
port plug is fully seated in the port hole. To do this, use one
hand to hold the port plug collar and turn the port plug wings
clockwise until the plug is secure in the port hole. A snug
t is all you need.
Single Unit Mode
Turn on the DemerBox DB1 by pressing the Power
button . Find DemerBox DB1 under your device’s
Bluetooth®settings and select it.
Charging a Device Using the DB1
1. Plug a device into the USB charge out port on
the DB1.
2. Turn on the DemerBox DB1. Keep in mind, a DB1
battery will drain faster if you’re charging a device
from it.
Aux Cable
Plug one end of the AUX cable into the DemerBox DB1
and the other into the audio output of your device.
Volume Controls
You can control the volume two ways:
1. Use the volume controls on your device.
2. Use the UP/DOWN arrow buttons on
the front of the DemerBox. These only work in
Bluetooth mode.
CHARGING
First time use
Charge the DemerBox DB1 fully before using for the rst time.
The light on the charger will turn from red to green when fully charged.
Charge Status
The ve green LED lights on the DemerBox DB1 control panel show
the battery state of charge. When all ve LEDs are lit up, it will have
approximately 40 hours of continuous play time.
Preserving Battery Life
For best long-term battery life, don’t leave the DemerBox DB1 plugged
in for extended periods after the battery is charged.
Using the DemerBox
CHARGE
DEMERBOX
CHARGE
STUFF
AUDIO
IN
