Eaton Power Xpert Gateway Minislot Manuale di programmazione

Eaton®Power Xpert®Gateway Minislot (PXGMS) UPS Card

Quick Start Instructions

Package Contents

lPower Xpert Gateway Minislot (PXGMS) UPS Card

lUSB Cable

lQuick Start Instructions

Help Desk Numbers

United States 1-800-356-5737 or 1-800-843-9433

Canada 1-800-461-9166 ext 260

All Other Countries Call your local service representative

Web sites:

www.eaton.com/powerxpert

www.eaton.com/pxgms

NOTE: On the Web site opening page, click Support and select the

Customer Service link for more information.

Eaton and Power Xpert are registered trademarks of Eaton Corporation or its

subsidiaries and affiliates. Google Chrome is a trademark of Google Inc. Linux is

a registered trademark of Linus Torvalds. Microsoft, Internet Explorer, and

Windows are registered trademarks of Microsoft Corporation in the United

States and in other countries. Mozilla and Firefox are registered trademarks of

the Mozilla Foundation. Phillips is a registered trademark of Phillips Screw

Company. All other trademarks are property of their respective companies.

part of this document may be reproduced in any way without the express written

approval of Eaton Corporation.

Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1 1

TABLE OF CONTENTS

Section 1 Installation Checklist ........................................................................ 2

Section 2 Install the Card ................................................................................. 3

Section 3 Connect the Card to the Computer .................................................. 5

Section 4 Install the USB Driver Software (Windows XP) ............................... 7

Section 5 Install the USB Driver Software (Windows 7) ............................... 14

Section 6 Verify IP Address Assignment ....................................................... 18

Section 7 Assign an IP Address ..................................................................... 20

2 Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1

Section 1 Installation Checklist

1. Verify that the following items are available:

oPower Xpert Gateway Minislot (PXGMS) UPS Card package contents

(see front cover)

oPhillips®screwdriver

oAvailable USB port on a computer running Microsoft®Windows®

oWeb browser (Microsoft Internet Explorer® version 8.0 and higher,

Mozilla®Firefox®, or Google Chrome™ are recommended)

2. If you are going to use Dynamic Host Configuration Protocol (DHCP), provide

your local network administrator with the card's MAC address. The MAC

address is located on a label on the bottom of the card.

oMAC Address _____________________________________________

3. If you are not going to use DHCP to provide any of the settings listed below,

contact your local network administrator for the settings. Select DHCP or

enter the values for manual configuration in the table below:

4. If you need e-mail functionality, obtain the SMTP mail server's IP address or

host name. If using the SMTP host name, verify that you also have the

Name Server IP address (see Step 3).

oSMTP (mail server) IP Address

or Host Name _____________________________________________

Item

Either Provided

by DHCP* Or Manual Configuration

IPv4 oCard IP Address: ________________________

Netmask: ________________________

Gateway: ________________________

DNS – Name Servers oName Server #1: ________________________

Name Server #2: ________________________

Name Server #3: ________________________

DNS – Domain oDomain: ________________________

* The network administrator normally sets up the DHCP server to provide a static IP address each time

the card makes a DHCP request.

Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1 3

Section 2 Install the Card

Note: The hot-swappable PXGMS card can be installed without turning off the

UPS or disconnecting the load.

To install the PXGMS card:

1. Verify that all six DIP switches on the card are in the OFF position (see

Figure 1).

Figure 1. Verify DIP Switches are OFF

2. Remove the Minislot cover. Retain the screws.

Note: If there is another card already installed with an attached

communication cable, disconnect the cable and then remove the card.

3. If not already done, record the MAC address for future reference (see Step 2

on page 2).

4. To prevent electrostatic discharge (ESD), place one hand on a metal surface,

such as the UPS rear panel.

Ident

Power

Act

100

PXGMS UPS

Restart

Setup

CMN

Status

DHCP

EMP

Ethernet 10/100

13456

OFF

4 Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1

5. Slide the card into the open slot and secure with the screws removed in

Step 2 (see Figure 2).

Figure 2. Secure the PXGMS Card

6. Connect an active Ethernet cable (not supplied) to the Ethernet 10/100

connector on the PXGMS card (see Figure 3).

Figure 3. Install the Ethernet Cable

Ident

Power

Act

100

PXGMS UPS

Restart

Setup

CMN

Status

DHCP

EMP

Ethernet 10/100

Ident

Power

Act

100

PXGMS UPS

Restart

Setup

CMN

Status

DHCP

EMP

Ethernet 10/100 +

Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1 5

Section 3 Connect the Card to the Computer

To connect the card to the computer:

1. G o t o www.eaton.com/pxgms and perform one of the following:

lClick the Power Xpert Gateway Minislot UPS Card link beside the

PXGMS card photograph.

lIn the left column under Products and Services > Power Quality and

Monitoring > Networking Hardware, select Power Xpert Gateway

Minislot UPS Card.

2. On the Features tab, click the Download Configuration File link to

download the powerxpert.inf file. Note the location of the downloaded file

on your computer so you can use it later.

3. Plug the USB cable into the Setup port on the card (see Figure 4).

Figure 4. Install the USB Cable

4. Plug the other end of the USB cable into the USB port on the computer.

Ident

Power

Act

100

PXGMS UPS

Restart TX RX

Setup

CMN

Status

DHCP EMP

Ethernet 10/100

6 Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1

5. The Windows operating system detects new hardware (see Figure 5).

Figure 5. Found New Hardware Wizard – Welcome Window

Note: If a message displays indicating that the device driver software was not

successfully installed, click Ignore.

6. The steps for installing the USB driver software are determined by the type

of operating system running on your computer:

lFor Windows XP, continue to "Install the USB Driver Software

(Windows XP)" on page 7.

lFor Windows 7, continue to "Install the USB Driver Software (Windows 7)"

on page 14.

Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1 7

Section 4 Install the USB Driver Software (Windows XP)

To install the USB driver software on a computer running Windows XP:

1. On the Welcome window, select No, not this time and click Next (see

Figure 6).

Figure 6. Found New Hardware Wizard – Welcome Window

8 Eaton PXGMS UPS Card Quick Start Instructions P-164000208—Rev 1

2. Select Install from a list or specific location (Advanced) and click Next

(see Figure 7).

Figure 7. Found New Hardware Wizard – Install Software Window

3. Select Don’t search. I will choose the driver to install and click Next

(see Figure 8).

Figure 8. Found New Hardware Wizard – Installation Options Window

Altri manuali per Power Xpert Gateway Minislot

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Eaton Portale

Eaton

Eaton ProtoAir FPA-W34 Guida utente

Eaton

Eaton EU5C-SWD-EIP-MODTCP Manuale utente

Eaton

Eaton Moeller SmartWire-Darwin Series Manuale utente

Eaton

Eaton SmartWire-DT Manuale utente

Eaton

Eaton SWIRE-GW-MB Manuale utente

Eaton

Eaton SmartWire-DT EU5C-SWD-DP Manuale utente

Eaton

Eaton INDGW-M2 Manuale utente

Eaton

Eaton EMP Manuale utente

Eaton

Eaton LumenSafe Manuale utente

Eaton

Eaton Moeller SmartWire-Darwin EU5C-SWD-DP Manuale

Eaton

Eaton 415U-2 Manuale utente

Eaton

Eaton Power Xpert Gateway 900 Manuale utente

Eaton

Eaton INDGW-X2 Manuale utente

Eaton

Eaton ELPRO 415U Manuale utente

Eaton

Eaton XN-312-GW-CAN Manuale utente

Eaton

Eaton 415U-2-C Manuale

Eaton

Eaton 415U-2 Manuale utente

Eaton

Eaton PXG600E Guida

Eaton

Eaton LOYTEC LGATE-902 Manuale utente

Eaton

Eaton EASY223-SWIRE Manuale

Eaton

Eaton EG-2 Manuale utente

Eaton

Eaton Power Xpert Meter 2000 Manuale utente

Eaton

Eaton EG2-NA Manuale utente

Eaton

Eaton Moeller SmartWire-Darwin EU5C-SWD-DP Manuale

Manuali Portale popolari di altre marche

LST

LST M500RFE-AS Manuale utente

Kinnex

Kinnex Media Gateway Manuale utente

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuale utente

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuale utente

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuale utente

Telsey

Telsey CPVA 500 - SIP Manuale utente

RTA

RTA 460A-NNA4 Scheda tecnica

Shaw

Shaw Gateway HDPVR Manuale utente

ABB

ABB VSN900 Guida rapida

Commander

Commander Pulse Manuale utente

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuale utente

NETGEAR

NETGEAR C6300BD Manuale utente

Amit

Amit CDW531AM Manuale utente

HMS

HMS Netbiter EasyConnect EC150 Manuale utente

Huawei

Huawei EchoLife HG620 Manuale utente

AT&T

AT&T U-verse 3801 Manuale per l'uso e la cura

Logic IO

Logic IO RTCU MX2 turbo Manuale utente

Suttle

Suttle MediaMAX MXM-521 Manuale utente