Eiki PJNET-300 Manuale utente
PjNET-300
OWNER'S MANUAL
LINK ACT
2
Compliance and Caution
Compliance
Federal Communication Commission Notice
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment causes harmful
interference to radio or television reception which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15
of FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise speci-
fied in the manual. If such changes or modifications should be made, you could be
required to stop operation of the equipment.
Model Numbers : PjNET-300
Trade Name : EIKI
Responsible party : EIKI International, Inc.
Address : 30251 Esperanza Rancho Santa Margarita CA 92688-2132
Telephone No. : 800-242-3454 (949-457-0200)
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
EIKI PjNET-300
3
OWNER'S MANUAL
ENGLISH
CAUTION
Eiki International, Inc. assumes no responsibility for the loss or damage of data or
damage of the computer caused by usung this product.
CAUTION ON USE IN NETWORK
- When you receive an alert e-mail from the projector, you must check the projector
immediately. Fire or accident may result if the projector is used in an abnormal
condition.
- When you install the projector at remote location and use it through the network,
you must perform the safety inspections periodically. In this case you must pay
attention to the change of environment in which you installed the projector. It may
cause fire or an accident depending on the change of environment.
The CE Mark is a Directive conformity mark of the European Community
(EC).
Compliance and Caution
NOTE: This symbol mark and recycle system are applied only to EU countries
and not applied to the countries in the other area of the world.
Your EIKI product is designed and manufactured with high quality
materials and components which are can be recycled and reused.
This symbol means that electrical and electric equipment, at their
end-of-life, should be disposed of separately from your household
waste.
Please dispose of this equipment at your local community waste col-
lection/recycling centre.
In the European Union there are separate collection systems for used electrical and
electric products.
Please help us to conserve the environment we live in!
4
Compliance ..............................................................................................................2
Federal Communication Commission Notice .......................................................2
Trademarks ..........................................................................................................2
Contents ...................................................................................................................4
Chapter 1 Preparation .........................................................................................7
Features ....................................................................................................................8
Operating environment ........................................................................................ 10
Before use ............................................................................................................. 11
Chapter 2 Installation ........................................................................................ 13
Flow of installation ............................................................................................... 14
[1] Name and function of each part ................................................................... 15
[2] Installation and network configuration ........................................................16
Mounting ........................................................................................................... 16
Connection of LAN cable ................................................................................... 17
Network configuration .......................................................................................18
Network PIN code setting ..................................................................................20
How to enter the numbers with the screen 10-key pallet .................................21
Notice about system construction .....................................................................22
Chapter 3 Basic Setting and Operation ....................................................23
Login the setting page of the projector ............................................................24
1 Enter the IP address .......................................................................................24
2 Select a display mode and login .....................................................................24
3 Display of main setting page ...........................................................................25
How to use the setting page ..............................................................................26
Initial setting ..........................................................................................................28
Network PIN code setting ..................................................................................29
PJLink and password setting .............................................................................29
What's PJLink? .............................................................................................29
Date and time setting ........................................................................................30
Network configuration .........................................................................................31
E-mail setting .........................................................................................................32
Examples: Type and contents of alert mail .........................................................34
SNMP setting ........................................................................................................36
Chapter 4 Controlling the Projector ...........................................................39
Power control and status check .........................................................................40
Controls ..................................................................................................................42
Input ...................................................................................................................42
System ...............................................................................................................43
Image adjustment .............................................................................................44
Sound ................................................................................................................45
Menu ................................................................................................................45
PC adjustment .......................................................................................................46
Setting up the projector .......................................................................................47
Contents
5
OWNER'S MANUAL
ENGLISH
Contents
Save the controls and settings ...........................................................................49
Save/delete the settings ....................................................................................49
Check the saved items ......................................................................................50
Load a control set ..............................................................................................50
Timer setting .........................................................................................................51
How to set the timer .........................................................................................51
Check the timer events ......................................................................................52
Change the event mode ....................................................................................52
Projector information ............................................................................................54
Multi-control ..........................................................................................................56
Controlling and setting the multi-projectors .......................................................56
Start/stop the multi control ................................................................................57
Register the projector ........................................................................................58
Confirmation of registered projector ..................................................................58
Change the mode of the registered projector ...................................................59
Status .................................................................................................................59
Conf. & Change page in the light mode .............................................................60
Controlling all together .......................................................................................60
Setting all together .............................................................................................60
Chapter 5 Use of Serial Port ..........................................................................61
Serial port setting ..................................................................................................62
Setting examples for the serial control ..............................................................63
Control examples ..................................................................................................64
Use of telnet ..........................................................................................................66
Control the projector with telnet ........................................................................68
Chapter 6 Appendix ..........................................................................................69
Examples of connection ......................................................................................70
Web browser setting ............................................................................................72
Examples: OS/Browsers .....................................................................................73
Product specification ............................................................................................77
Port specification ..................................................................................................78
Q&A ........................................................................................................................79
6
7
OWNSER'S MANUAL
ENGLISH
7
1
Chapter 1
Preparation
Describes features and operating environment of this product.
8
Chapter 1 Preparation
Features
E-Mail Alert function (☞p.32)
The projector (Network Unit)
sends messages to the regis-
tered e-mail addresses when
a lamp abnormality or power
failure occurs on the projector.
This message describes how
to solve the cause of the prob-
lems. You can take efficient
action for quick recovery.
PC4PC3 PC6
PC5
PC1 PC2
You’ve got
Mail.
PJ2 PJ1
Web Management function (☞p.39)
With this function, you can
monitor projector functions
such as power status, lamp
status, input mode, signal
condition, lamp-use time, etc.
through the network by using
the web browser installed on
your computer.
PC4PC3 PC6
PC5
PC1 PC2
Turn on PJ2.
PJ2 PJ1
SNMP Agent function (☞p.36)
The function to send informa-
tion of the projector to the
SNMP manager. Enables you
to manage the projector condi-
tion with the SNMP manager
software *.
PC6
PC4
PC5
SNMP Manager
Trap
Trap
You received
a trap.
PJ2PJ1 PJ4
PJ3
* This network unit does not provide the SNMP manager software.
9
OWNER'S MANUAL
ENGLISH
Features
Multi-control function (☞p.56)
A single computer can con-
trol and set up the multiple
projectors at the same
time.
PC6
PC4
PC5
Select Input 2
for PJ1 to PJ4
PJ2PJ1 PJ4
PJ3
Automatic On/Off using Clock function (☞p.51)
Automatically turn on or off the
projectors at specified date/day
and time by using the clock
function.
Now it’s 11:30
I am ready to turn ON,
and select Input 3 (Video)
Control port ready for external equipment (☞p.61)
This product provides a serial port (RS-
232C) for controlling external equipment.
By connecting the equipment to the serial
port, it can be controlled by a computer via
the network.
* This product does not provide the inter-
face driver software to control external
equipment.
PC3
PC5
Playback DVD
PJ2
DVD Player
10
Chapter 1 Preparation
*1 The "Light Mode" and "Standard Mode" will be explained on item "Display Mode" (☞ p.24-26)
PDA restriction
The PDA can be used for the Light mode*1 only. The operating system of the PDA is
PocketPC2002 or higher. The version of the Macromedia Flash Player is 6,0,81,0 or higher.
Operating environment
To perform the managing and setting up the projector using this product, the environ-
ment described below is required.
Operating System
Standard mode*1 : Windows 98, Windows Me, Windows 2000,
Windows NT4.0 SP6, Windows XP
Network
Network must handle Ethernet correctly and accept TCP/IP protocol.
Computer
The computer must provide a 10Base-T or 100Base-TX network card.
Web browser application*
● Microsoft Internet Explorer version 5.0, 5.5 or 6.0
● Netscape Navigator version 6.2, 7.0 or 7.1
* Used to control and set up the projector. The layout of pages in the browser may
slightly differ from each type of application or operating system you use.
● Plug-Ins: Macromedia Flash Player version 6,0,79,0(6.0r79) or later
Internet mail application*
● Microsoft Outlook ● Microsoft OutlookExpress
● Netscape Mail
* Required the internet e-mail application software to receive an e-mail alert sent
from this product. If you do not use the function E-mail Alert, this application is
not required.
Indice
Altri manuali Eiki Accessori per proiettori
Eiki
Eiki PjNET-20 Manuale utente
Eiki
Eiki AH-38321 Manuale utente
Eiki
Eiki AH-35001 Manuale utente
Eiki
Eiki LNS-T10 Manuale per l'uso e la cura
Eiki
Eiki PjNET-50 Manuale utente
Eiki
Eiki AH-45401 Manuale utente
Eiki
Eiki EVW-100 Manuale utente
Eiki
Eiki AH-45201 Manuale utente
Eiki
Eiki PjNET-10 Manuale del proprietario
Eiki
Eiki NPC-1 Manuale utente
Eiki
Eiki PJNET-30 Manuale utente
Eiki
Eiki AH-A25010 Manuale utente
Eiki
Eiki AH-55001 Manuale utente
Eiki
Eiki PjNET-15 Manuale utente
Eiki
Eiki AH-24711 Manuale per l'uso e la cura
Eiki
Eiki AH-50001 Manuale utente
Eiki
Eiki PjNET-10 Manuale del proprietario
Eiki
Eiki AH-55401 Manuale utente
Eiki
Eiki Smoke Resistant Box AH-69601 Manuale utente
