• Insert EVA iPod charging cable into EVA iPod.
• Insert Emmes EVA Program Flash Drive into USB
port next to the one reserved for the EVA iPod.
4 ORIENT
• Turn enre connected assembly around so the
screen is facing you.
• Organize all cables as necessary, being mindful of
where available power outlets are located.
• Plug wall-side ends of power cables into available
receptacles.
5 TURN ON
• Power on EVA iPod – single press and briey hold
the power buon.
• Power on the EVA display – single press once the
right-most buon on the EVA display unl it lights
up any color (orange or blue).
• Power on the EVA PC – single press the power
buon.
6 WAIT
**NOTE** This step is important every me the
device is restarted or powered on.
• Once ALL components are on and fully booted
(iPod shows lock-screen [1]; display shows “Tesng
Requirements”[2]), WAIT at least 30 seconds
BEFORE launching the EVA App on the EVA iPod.
a
7
c
5
b
6
[1] [2]
contact EVA support.
Proles. If you don’t see the study you’re looking for,
> ManageStudies and scroll through available Study
Enable Study Proles:
In the EVA App, tap Sengs
as necessary to look up the previous test.
EVA App, tap “Test Results”, select NON STUDY, proceed
Look up the previous NON STUDY test result:
In the
the results screen.
with the prompts. Complete/nish the test and note
select NON STUDY, proceed and familiarize yourself
Try an E-ETDRS Test:
In the EVA App, tap E-ETDRS,
•
Shutdown.
•
Sleep/Wake Up
•
Sengs
•
Test Results
•
Chart
•
Low Contrast ATS-HDTV
•
Low Contrast E-EDTRS
•
ATS-HOTV
•
E-EDTRS
sub-applicaons:
Once the EVA App loads, you should see the following
WAIT for EVA App to load:
it may take severalmoments.
the arrow.
Single-tap the EVA App on the EVA iPod screen below
7 LAUNCH EVA APP
