EOS Tech VT-300 Manuale utente
User Manual Rev.1.2.1EN
Network Drive Recorder
Network Drive Recorder
VT-300
1
Thank you for purchasing
this network drive recorder.
Please read this user
manual carefully before
you use the NDVR and
keep it handy for future
reference.
Before reading this user manual
2
⚠WARNING
Failure to follow these safety instructions could result in fire,
electric shock, or other injuries, or damage to product or other
property. Read all the safety information below before using
product.
* Do not disassemble or modify s product under user's own
discretion, or it may cause product failure, electric shock or
fire.
* When terminal is in malfunction, do not operate terminal.
* If foreign matter or water gets into terminal or smoking, stop
using and contact service center for A/S.
* When other electronic product is installed in vehicle, be
careful that terminal power cable is cut or gets damaged, or it
may cause product failure or electric shock or fire.
* Do not change the terminal installation location without
authorization, or there may be blind area in image
photography and user shall be liable on this.
* Fuse shall be in rated capacity.
* Unauthorized installation may cause failure in vehicle or
product.
* When power is connected, do not remove memory card,
cause memory card failure.
* Do not touch memory card with oily or wet hand, or it may
cause product failure.
* Please use only authenticated and recommended memory
card, or it may cause data loss.
* Do not put foreign material into card insertion slot of the
terminal, or card may not be inserted or it may cause product
failure.
* An improper connection could result in loss of data or memory
card defect.
* For cleaning, do not use water, benzene or alcohol to product
and parts. Please use soft and dry cloth, or it may cause
product failure.
* Do not apply strong impact to the terminal, or terminal may
break by the impact or it may cause product failure.
Section 1
Important safety information
3
* GPS receiver module requires warming up time for initial start
up. It may take several seconds or several minutes after
power is turned on according to signal receiving environment.
* Metallic coating on front window of vehicle may cause signal
trouble in GPS.
* Be careful for In-Cabin camera angle not to be shaded by
inside room mirror when the product install.
* Adhere after working Air Drier (Air Conditioner) in case of
much humidity.
* Do not operate the terminal in driving or it may cause a traffic
accident. Park vehicle safely first and then operate the
terminal.
* When service is required please contact our service center for
A/S.
* Do not touch to camera lens. Finger prints are may cause
unclear recorded video quality.
2
Getting to know the network drive
recorder
5
Your network drive recorder comes with the accessories shown
on this page. If any of these items is missing from your box, call
customer center.
* The exact appearance of each item may vary by model.
* Micro SDXC memory card are not included.
* You can purchase parts and accessories after consulting with
your local distributor. Product is not responsible for reduced
malfunctions caused by any unauthorized use of accessories
such as the power cable etc.,
* The exact appearance of each item may vary by model.
Section 1
Unpacking
Main NDVR GPS Module & Cradle
Tamperproof cover Screw seal Screw Screw wrench
Cable Clip & Tie Uninterrupted power cable CD
6
Section 2
Optional Accessories
RCAM-D16M
3rd Camera
* 720x480p
* 6 meters cable
* Reverse gear signal wire port
* DC 5V power use from NDVR
* Korea origin
* 720x480p / IP67 / Waterproof
* 160(D) wide angle / IR LED
* 23 meters cable
* Reverse gear signal wire port
* DC 5V power use from NDVR
RCAM-9990IR
3rd Camera
* IEEE 802.11 b/g/n
* 2.4GHz frequency bands
* OFDM, Peak rate 150Mbps
* Peak throughput 90Mbps.
* 64/128 WEP,WPA,WPA2,TKIP,AES
WF-700RA
Wireless LAN USB Adopter
* IP67 / Waterproof
* 6 meters cable length
* Magnetic type
* MCX connecter
GPSA-6000
External GPS Antenna for
metal film coating vehicle.
* 2.5mm EarPhone jack to RCA
* 3 meter cable length
* UL approved
VOC-300
Video-out Cable
* 2.5mm EarPhone jack type
* 1 male to 2 female jack use
* This part is may need to use video-out
cable and panic button use at once
YCB-100
Y-Type Cable
* IP54 / Metal type
* 5 meters cable length
* 10A/250VAC
* This part is able to connect to
Video-out port from NDVR
FS-5M
Panic Foot Switch
* L-angle male to right angle female
* Use for external flash memory
USB-200
USB 2.0 Cable
7
Section 3
Part & Names
Read this section to learn about the NDVR features, how to use the
controls, and more.
GPS & Cradle
Operating LED
Road view camera
(Six-element lens)
GPS receiver module
(GNSS worldwide)
In-cabin view camera
Angle hook for
tamperproof case
Speaker
Main device-Road side view
In-cabin view camera
(Six-element lens)
In-cabin IR LEDs
(Infrared night vision
recording)
Micro SD card slot
(Dual slot)
DC power
GPS port
Video-out port
3rd camera port
USB 2.0 port
Micro USB port
Network state LED
Record state LED
GPS state LED
Manual event recording button
Microphone and
Reset button
Main device-InCabin side view
In Cabin view
9
GPS cable jack
Install type
assignment icon
External GPS antenna MCX
connecter
Main device joint hook
Tamperproof cover hook
GPS Receiver
module inside
GPS & Windshield cradle
GPS & Cradle
Indice
