EVC electronic GmbH -8- BSL100 Manual
BSL-ADP
Pict. 1: Connectors and LEDs of the BSL-ADP.
The BSL-ADP is a USB-controlled, two-channel
pulse generator.
The outputs of the pulse generator channels will
be connected to the crankshaft sensor input and
camshaft sensor input on the Bosch-ECUs.
Using these signals, the ECU can be forced into
its service mode.
With the ECU in service mode, the password can
be read then.
First, the GND connection needs to be estab-
lished.
In case of the BSL131, the included black cable
can additionally be connected to the GND socket
of the BSL131.
In case of the BSL130 or BSL132, an extra GND
connection to the ECU is required.
Using the red cables with the clamp-type test
probes, each of the channels S1 and S2 need to
be connected to the corresponding pin of the
ECU.
The locations of the required pins on the ECU
are shown on our website:
http://www.evc.de/de/product/bsl/ecu.asp.
Pict 2: The pin out of the BSL-ADP and the
meaning of the LEDs.
