Extreme Networks Altitude 4511 Manuale utente

Extreme Networks, Inc.

3585 Monroe Street

Santa Clara, California 95051

(888) 257-3000

(408) 579-2800

http://www.extremenetworks.com

Published: July 2011

Part Number: 120676-00 Rev 01

Altitude™ 4511 Access Point

Installation Guide

Altitude 4511 Access Point Installation Guide

2Altitude 4511 Access Point Installation Guide

AccessAdapt, Alpine, Altitude, BlackDiamond, EPICenter, ExtremeWorks Essentials, Ethernet

Everywhere, Extreme Enabled, Extreme Ethernet Everywhere, Extreme Networks, Extreme

Standby Router Protocol, Extreme Turbodrive, Extreme Velocity, ExtremeWare, ExtremeWorks,

ExtremeXOS, Go Purple Extreme Solution, ExtremeXOS ScreenPlay, ReachNXT, Sentriant,

ServiceWatch, Summit, SummitStack, Triumph, Unified Access Architecture, Unified Access RF

Manager, UniStack, the Extreme Networks logo, the Alpine logo, the BlackDiamond logo, the

Extreme Turbodrive logo, the Summit logos, and the Powered by ExtremeXOS logo are

trademarks or registered trademarks of Extreme Networks, Inc. or its subsidiaries in the United

States and/or other countries.

sFlow is a registered trademark of InMon Corporation.

Specifications are subject to change without notice.

All other registered trademarks, trademarks, and service marks are property of their respective

owners.

Altitude 4511 Access Point Installation Guide 3

Chapter 1: Introduction.............................................................................................5

Document Conventions ........................................................................................ 6

Warnings............................................................................................................ 6

Site Preparation.................................................................................................. 7

Package Contents ............................................................................................... 7

Features............................................................................................................. 7

Chapter 2: Hardware Installation...............................................................................9

Installation Instructions....................................................................................... 9

Precautions ...................................................................................................... 10

Access Point Placement .................................................................................... 10

Wall Mount Installation ..................................................................................... 10

Telco Box Installation........................................................................................ 14

Altitude 4511 Access Point Antennas ................................................................. 18

LED Indicators.................................................................................................. 18

Chapter 3: Specifications ....................................................................................... 19

Electrical Characteristics ................................................................................... 19

Physical Characteristics..................................................................................... 19

Radio Characteristics ........................................................................................ 20

Chapter 4: Regulatory Information........................................................................... 21

Regulatory Overview .......................................................................................... 21

Wireless Device Country Approvals...................................................................... 21

Country Selection – Note for AP & Wireless Controller..................................... 22

Frequency of Operation – FCC and IC............................................................ 22

Health and Safety Recommendations.................................................................. 22

Warnings for the use of Wireless Devices ....................................................... 22

Potentially Hazardous Atmospheres – Fixed Installations................................. 23

Safety in Hospitals ...................................................................................... 23

RF Exposure Guidelines..................................................................................... 24

Safety Information ...................................................................................... 24

International..................................................................................................... 24

EU .................................................................................................................. 24

Table of Contents

Altitude 4511 Access Point Installation Guide

US and Canada................................................................................................. 24

Power Supply ................................................................................................... 25

Radio Frequency Interference Requirements – FCC .............................................. 25

Radio Frequency Interference Requirements – Canada ........................................ 26

Radio Transmitters...................................................................................... 26

CE Marking and European Economic Area (EEA) .................................................. 27

Statement of Compliance................................................................................... 27

Waste Electrical and Electronic Equipment (WEEE) ............................................. 28

TURKISH WEEE Statement of Compliance.......................................................... 29

Japan (VCCI) - Voluntary Control Council for Interference Class B ITE ................... 30

Korea Warning Statement for Class B ITE............................................................ 30

Other Countries ................................................................................................ 30

Australia .................................................................................................... 30

Brazil......................................................................................................... 31

Chile.......................................................................................................... 31

Mexico....................................................................................................... 31

Taiwan....................................................................................................... 32

Korea......................................................................................................... 33

Chapter 5: Customer Support .................................................................................. 35

Registration...................................................................................................... 35

Documentation ................................................................................................. 35

Altitude 4511 Access Point Installation Guide 5

1Introduction

The Altitude™ 4511 Access Point links wireless 802.11a/b/g/n devices to the controller,

enabling the growth of your wireless network with a cost-effective alternative to

standard Access Points.

The Altitude 4511 Access Point is an enterprise class 802.11n Access Point, installed in

minutes anywhere a CAT-5 (or better) cable is located. The Altitude 4511 Access Point’s

mechanical design is optimized for installation over a standard CAT-5 (or better) wall

jack. The AP does not protrude into the wall cavity, allowing for an efficient heat

transfer and a universal installation over a standard Telco wiring plate. The Altitude

4511 Access Point’s modular design allows the end-user to add switched Ethernet ports

as-needed, and attach a standard keystone or Leviton QuickPort®modular connector to

the wall plate.

The Altitude 4511 Access Point ships with a single dual-band radio supporting the

802.11a/b/g/n radio bands.

The Altitude 4511 Access Point receives all power and transfers data through the same

CAT-5 or better Ethernet cable. There is no additional power supply required. An

802.113af Ethernet switch or an Extreme Networks Summit®WM3400 or Summit

WM360 model controller (both PoE capable) is required to power the Altitude 4511

Access Point.

Once cabled and powered, the Altitude 4511 Access Point functions as a dependent

mode Access Point, and receives its configuration once adopted by a Summit WM3400,

WM3600 or WM3700 Controller.

The Altitude 4511 Access Point can be ordered for US deployment (Part Number 15761)

or ordered for deployment outside of the US (Part Number 15762).

Introduction

Altitude 4511 Access Point Installation Guide

Document Conventions

The following graphical alerts are used in this document to indicate notable situations

NOTE

Tips, hints, or special requirements that you should take note of.

CAUTION

Care is required. Disregarding a caution can result in data loss or equipment malfunction.

WARNING!

Indicates a condition or procedure that could result in personal injury or equipment damage.

Warnings

●Read all installation instructions and site survey reports, and verify correct

equipment installation before connecting the Altitude 4511 Access Point to its power

source.

●Remove jewelry and watches before installing this equipment.

●Verify that the unit is grounded before connecting it to the power source.

●Verify any device connected to this unit is properly wired and grounded.

●Connect all power cords to a properly wired and grounded electrical circuit.

●Verify the electrical circuits have appropriate overload protection.

●Attach only approved power cords to the device.

●Verify the power connector and socket are accessible at all times during the

operation of the equipment.

●Do not work with power circuits in dimly lit spaces.

●Do not install this equipment or work with its power circuits during thunderstorms

or other weather conditions that could cause a power surge.

Altitude 4511 Access Point Installation Guide 7

●Verify there is adequate ventilation around the device, and that ambient

temperatures meet equipment operation specifications.

Site Preparation

●Consult your site survey and network analysis reports to determine specific

equipment placement, power drops, and so on.

●Assign installation responsibility to the appropriate personnel.

●Identify and document where all installed components are located.

●Ensure adequate, dust-free ventilation to all installed equipment.

●Prepare Ethernet and console port connections.

●Verify cable lengths are within the maximum 100 meter allowable length.

Package Contents

●Altitude 4511 Access Point with internal (integrated) antennas

●Mounting plate (used for both wall mount and Telco Box installations)

●Mounting plate lock screw

●Altitude 4511 Access Point Installation Guide (This Guide)

●RJ-45 double plug interconnect cable

●Fast Ethernet port 1 interconnect cable

Features

●One RJ-45 PoE Ethernet port (built into the Altitude 4511 Access Point)

●Optional second RJ-45 Ethernet port utilizing a pass through (keystone) cable

(included)

●Optional three port Ethernet expansion module (sold separately)

●2 LED indicators

Introduction

Altitude 4511 Access Point Installation Guide

The pass through (keystone) cable provides an option to add a second Ethernet port

before installing the Altitude 4511 Access Point.

The Altitude 4511 Access Point has one RJ-45 connector supporting a 10/100 Ethernet

port and requires 802.3af compliant power from an external source.

The Altitude 4511 Access Point ships with a single dual-band radio supporting the

802.11a/b/g/n radio bands.

The Access Point contains runtime firmware which enables the unit to boot after either

a power up or a watchdog reset. The runtime firmware on the Access Point can be

updated via the Ethernet interface.

The front of the Altitude 4511 Access Point has an access cover that can be removed to

expose an additional connector. A three port RJ-45 Ethernet expansion module connects

to the hidden header and snaps onto the Altitude 4511 Access Point in place of the

access cover.

Remove the Altitude 4511 Access Point’s access cover by inserting a tool into the

circular hole (opening) on the bottom of the Altitude 4511 Access Point. Pull the access

cover up and away from the Altitude 4511 Access Point. Reverse the procedure to

install the expansion module.

The Ethernet expansion module has three ports labeled FE2, FE3 and FE4.

The expansion module (Part Number 15763) is a separately orderable component from

Extreme Networks.

Altitude 4511 Access Point Installation Guide 9

2Hardware Installation

Installation Instructions

An Altitude 4511 Access Point mounts either on a wall, under a table or over a Telco

Box. The Altitude 4511 Access Point is not plenum rated.

NOTE

The provided metal mounting plate is fastened to an existing standard Telco in-wall box. The box

is customer provided within the customer building structure, and can be either plastic or metal in

composition. Screws and other mounting hardware are not included.

The Altitude 4511 Access Point is mounted to a wall or Telco Box so the mounting plate

is flush with the mounting surface.

The Altitude 4511 Access Point snaps on to the mounting plate without the use of tools

or fastening hardware. Removal of the Altitude 4511 Access Point from the mounting

plate can be accomplished without the use of a tool. A mounting lock screw is provided

to help ensure a tamper resistant installation.

NOTE

Once installed onto the mounting plate, the assembly can resist a minimum of 10 lbs of force

before unit breakage or accidental disassembly.

To prepare for an Altitude 4511 Access Point installation, perform the following:

1Verify the contents of the box includes the intended Altitude 4511 Access Point and

accessory hardware.

2Review site survey and network analysis reports to determine the location and

mounting position for the Altitude 4511 Access Point.

3Connect a CAT-5 or better Ethernet cable to a PoE compatible device and run the

cable to the installation site. Ensure there is sufficient cable slack to perform the

installation steps.

Hardware Installation

Altitude 4511 Access Point Installation Guide

Precautions

Before installing an Altitude 4511 Access Point:

●Verify the intended Altitude 4511 Access Point deployment location is not prone to

moisture or dust.

●Verify the environment has a continuous temperature range between 0° C to 40° C.

Access Point Placement

For optimal performance, install the Access Point away from transformers, heavy-duty

motors, fluorescent lights, microwave ovens, refrigerators and other industrial

equipment. Signal loss can occur when metal, concrete, walls or floors block

transmission. Install the Access Point in an open area or add Access Points as needed to

improve coverage.

To maximize the Access Point’s radio coverage area, Extreme Networks recommends

conducting a site survey to define and document radio interference obstacles before

installing the Access Point.

Wall Mount Installation

To support wall mount installations, the metal mounting plate (provided with the

Altitude 4511 Access Point) is fastened to a flat wall surface. The wall should be of

gypsum board, plaster, wood or concrete in composition.

NOTE

Extreme Networks recommends the following customer supplied mounting accessories for an

Altitude 4511 Access Point wall mount installation:

2, screws, #6 x 2.00 inch pan head

2, wall anchors suitable for the #6 screws

Altri manuali per Altitude 4511

Indice

Altri manuali Extreme Networks Punto di accesso wireless

Extreme Networks

Extreme Networks WS-AP3805-FCC/ROW Manuale utente

Extreme Networks

Extreme Networks WiNG AP-7612 Manuale utente

Extreme Networks

Extreme Networks ExtremeWireless AP510i Manuale utente

Extreme Networks

Extreme Networks Altitude 4521 Series Manuale utente

Extreme Networks

Extreme Networks ExtremeWireless AP3000X Manuale utente

Extreme Networks

Extreme Networks AP410C Manuale utente

Extreme Networks

Extreme Networks AP-7602 Manuale di servizio

Extreme Networks

Extreme Networks Altitude 4511 Foglio di istruzioni

Extreme Networks

Extreme Networks Altitude 4522 Series Manuale utente

Extreme Networks

Extreme Networks ExtremeWireless AP560i Manuale utente

Extreme Networks

Extreme Networks ExtremeWireless AP3935e Manuale utente

Extreme Networks

Extreme Networks Altitude 3550 Guida di riferimento rapido

Extreme Networks

Extreme Networks AP305C Manuale utente

Extreme Networks

Extreme Networks AP305C Manuale di installazione

Extreme Networks

Extreme Networks ExtremeWireless AP4000 Manuale utente

Extreme Networks

Extreme Networks AP60C Manuale di installazione

Extreme Networks

Extreme Networks Altitude 4700 Series Manuale utente

Extreme Networks

Extreme Networks AP410C Manuale utente

Extreme Networks

Extreme Networks WiNG AP-7602 Manuale utente

Extreme Networks

Extreme Networks ExtremeRouting SLX 9640 Manuale utente

Extreme Networks

Extreme Networks ExtremeWireless AP3000X Manuale utente

Extreme Networks

Extreme Networks Altitude 3500 Series Manuale di installazione e funzionamento

Extreme Networks

Extreme Networks ExtremeWireless AP3935i Manuale utente

Extreme Networks

Extreme Networks Altitude 4700 Series Manuale di installazione e funzionamento

Manuali Punto di accesso wireless popolari di altre marche

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuale utente

Ubiquiti

Ubiquiti NanoStation NSM2 Manuale utente

Cisco

Cisco Aironet 1550 Series Manuale utente

Aruba

Aruba IAP-335 Manuale utente

Advantek Networks

Advantek Networks AWN-AP-54MR Manuale utente

IP-COM

IP-COM AP355 Manuale utente

Buffalo

Buffalo AirStation WLA-L11G Manuale utente

EnGenius

EnGenius EnStationACv2 Manuale utente

D-Link

D-Link DAP-3662 Manuale utente

xG Technology

xG Technology xMax CN1300 Manuale utente

Widelink

Widelink ezWave WAP-1100 Series Manuale utente

Edimax

Edimax CAP1200 Manuale utente

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuale utente

Aruba

Aruba AP-203R Manuale utente

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuale utente

CreatComm

CreatComm TB5F Manuale utente

SineDigital

SineDigital MW-1500AP(H) Manuale utente

TP-Link

TP-Link AP9650 V1 Manuale utente