Extron electronics SM 26 Manuale utente

Product Category

SM 26 • Setup Guide

This setup guide contains installation information about the Extron SM 26 speaker.

Installing the Speaker Mounting Plate

The SM 26 speaker comes with a at mounting plate and an adapter for positioning the speaker 10° up, down, left, or right.

• 0° mounting plate — The at (0°) mounting plate allows the speaker to be mounted at on a suitable surface.

• 10° mounting adapter — The 10° mounting adapter allows the speaker to be installed at a 10 degree angle so that the

speaker can be pointed up, down, left, or right from an elevated position by rotating the adapter.

The mounting plate can be installed vertically or horizontally as shown below right.

0° Mounting Plate

10° Mounting Adapter

NOTE: Observe all applicable building codes and

local ordinances when installing the speaker.

Mounting to a Wall Stud

1. Locate the wall stud where the mounting plate will be installed.

2. If using the 10° mounting adapter, position the adapter to the wall stud according to how the speaker will be angled and mark

the positions of the pilot holes. See the gure below right for mounting hole locations.

If not using the adapter, position the mounting plate against the wall. The #26 arrow molded into the mounting plate indicates

the vertical midpoint of the SM 26 speaker when it is mounted on a wall stud. While positioning the mounting plate on the

wall, mark the location of two pilot holes using the holes indicated below.

33-0000-01Rev.Ax1

–

LOOP

–

LOOP

SM26 Speaker

Stud

Mounting

Points

Horizontal Mounting

Catch Tab

Vertical Mounting

Mounting

Holes

SM 26 • Setup Guide (Continued)

NOTE: A speaker wire access hole (see the following gures) must also be cut in the wall, so mark that hole location now

with the mounting plate positioned on the wall while ensuring that the wall stud does not interfere with the wire

routing and that the mounting plate hides the access hole.

3. Drill the mounting plate pilot holes and cut the speaker wire access hole, as previously marked.

4. Install the speaker cables into the wall before installing the speaker mounting plate. Leave enough slack in the cable.

5. If using the 10° mounting adapter, route the speaker cable through the adapter and 0° mounting plate, and attach the

adapter to the 0° mounting plate using the four included screws and washers, as shown below.

6. Route the speaker cable through the rear of the mounting plate and attach the wire ends to the quick connect contacts using

a small screwdriver, as shown below. Be sure to observe the correct polarity.

7. Attach the mounting plate to the wall, as shown below.

NOTE: Figures below refer to steps 5 through 7.

10° Mounting

Adapter

0° Mounting Plate

(4) 4-40 x 3/16"

Screws

Quick Connect Contacts

Mounting Screws

Red Wire (+) from Ampliﬁer

Black Wire (-) from Ampliﬁer

Red Wire (+) from

Ampliﬁer/Previous Speaker

Red Wire (+) to Next Speaker

Black Wire (-) from

Ampliﬁer/Previous Speaker

Black Wire (-) to Next Speaker

LOOPIN INLOOP LOOPIN INLOOP

Number of Wires

per Connection Point Maximum

Wire Gauge

1 12 AWG

2 16 AWG

4 18 AWG

Wire Gauge Table

Loop-through Connection

Single speaker Connection

Number of Wires

per Connection Point Maximum

Wire Gauge

1 12 AWG

2 16 AWG

4 18 AWG

Wire Gauge Table

Product Category

NOTE: If surface mounting, route

wires through alternate

access points.

Attaching a Secondary Support Cable

If a secondary support cable is being attached, attach the cable to

the eye bolt, as shown on the right. The cable end should be properly

swaged.

Attaching the Speaker to the Mounting Plate

ATTENTION: The key must be rotated to the

unlocked position before the speaker is attached

to the mounting plate. Failure to place the speaker

in the unlocked position will result in damage to

the speaker lock mechanism should an attempt be

made to mount the speaker. By default, the

SM 26 speaker is shipped unlocked (see “Using

the Security Key to Lock and Unlock the

Speaker” on the next page).

NOTE: If a secondary attachment point is being

used, see the “Attaching a Secondary Support

Cable” section above for installation details before

proceeding further.

Position the rear mounting slot of the speaker above the

catch tab of the mounting plate, then slide the speaker down

into the mounting plate until a click is heard indicating that the

speaker is secured in place (see gure on the right). When

properly seated, the speaker connections are automatically made.

NOTE: If mounting the SM 26 with the yoke mount, refer to the Yoke Mount Setup Guide.

ATTENTION: Use the appropriate mounting screws. The screw heads must not protrude

more than 0.27 inch ( 7 mm) above the screw holes in the mounting plate (see the gure

on the left). If the screw head protrudes too far above the mounting plate surface, damage

to the speaker may occur when the speaker is attached.

0° Mounting Plate

Alternate Access Point Alternate Access Points

10° Mounting Adapter

33-0000-01 Rev. Ax1

–

LOOP

–

LOOP

0.47”

(12 mm)

0.27”

(7 mm)

Good

Bad

Secondary

Attachment

Cable

Anchor this end to a

suitable secure point.

Attach cable here

and secure.

Catch Tab

68-2164-50

Rev. A

03 13

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.863.1794

+1.714.491.1517 FAX +1.919.863.1797 FAX

Extron Europe

+800.3987.6673

(Inside Europe Only)

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

(Inside Asia Only)

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+4000.398766

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

Inside India Only

+91-80-3055.3777

+91 80 3055 3737 FAX

Setting the Tap Selector Switch

(SM 26T model only)

For the SM 26T model, insert a small screwdriver through the upper left portion of the front grille, as shown below, to adjust the

tap selector switch to the desired setting.

Using the Security Key to Lock and Unlock the Speaker

Insert the key into the center of the speaker grille and turn the key, as needed, so that the speaker is in the unlocked position (see

the gure above). There are three small raised “dimples” (see the gure below)on the grille surface that surrounds the keyhole.

Repeat this procedure, but set the key to the locked position to lock the speaker.

Removing the Speaker from the Mounting Plate

To remove the speaker from the mounting plate, you must unlatch the

locking mechanism.

1. Insert the security key into the keyhole of the speaker grille (see the previous

section) and turn the key to the unlock position.

2. Remove the security key.

3. Apply pressure to the grille with your nger over the “dimpled” keyhole to

unlatch the speaker from the mounting plate while lifting up on the speaker

(see gure on the right).

Press to Release

Unlocked

Twist to

Lock/Unlock

Unlocked Locked

8Ω

100

8Ω

Tap Indicator

for 70 volt

Tap Indicator

for 100 volt

Altri manuali per SM 26

Indice

Altri manuali Extron electronics Altoparlanti

Extron electronics

Extron electronics SoundField XD SF 26CT LP Manuale utente

Extron electronics

Extron electronics SpeedMount SM 26 Manuale utente

Extron electronics

Extron electronics BCK SF 3C LP Manuale utente

Extron electronics

Extron electronics FF 220T Manuale utente

Extron electronics

Extron electronics SM 26 Manuale utente

Extron electronics

Extron electronics FF 120T Manuale utente

Extron electronics

Extron electronics SM 3 Manuale utente

Extron electronics

Extron electronics SI 26CT Manuale utente

Extron electronics

Extron electronics SI 3CT LP Manuale utente

Extron electronics

Extron electronics SF 26PT Manuale utente

Extron electronics

Extron electronics BCK SF 26CT Manuale utente

Extron electronics

Extron electronics DAK SF 26CT Manuale utente

Extron electronics

Extron electronics SF 26PT Manuale utente

Extron electronics

Extron electronics SB 33 A Series Manuale utente

Extron electronics

Extron electronics SoundField XD SF 26CT LP Manuale utente

Extron electronics

Extron electronics SI 3C LP Manuale utente

Extron electronics

Extron electronics SF 228T Manuale utente

Extron electronics

Extron electronics SB 33 A Series Manuale utente

Extron electronics

Extron electronics CS 26T Plus Manuale utente

Extron electronics

Extron electronics CA 163 Manuale utente

Extron electronics

Extron electronics DAK SF 26CT Manuale utente

Extron electronics

Extron electronics SI 26 Manuale utente

Extron electronics

Extron electronics SPA 12 AAP Manuale utente

Extron electronics

Extron electronics SM 3 Manuale utente

Manuali Altoparlanti popolari di altre marche

argon audio

argon audio IE20 Manuale utente

Denon

Denon SC-N7 Manuale utente

Gemline

Gemline Ace 3952 Manuale utente

Focal

Focal ON WALL 300 Manuale di istruzioni

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuale utente

SoundLogic

SoundLogic BCCS-6/6395 Manuale utente

Peavey

Peavey DTH 218 Manuale utente

Avantree

Avantree Pluto Air Manuale utente

Morel

Morel Integra Series INTEGRA OVATION 4 Manuale utente

Oppo

Oppo SONICA Manuale utente

Bose

Bose SoundLink Wireless Music System Manuale utente

Rocksteady

Rocksteady Stadium Manuale utente

Bowers & Wilkins

Bowers & Wilkins 4 Manuale utente

Sonance

Sonance SONOS OUTDOOR Series Manuale utente

Electro-Voice

Electro-Voice EVID FM4.2 Manuale utente

Pioneer

Pioneer XW-HTD630 Manuale utente

Onn

Onn BWA16AA002 Manuale utente

HP GL313AA - USB Speakers PC Multimedia Manuale utente