FlowCon PIM-DP Manuale utente

Figure 3









Measurement

Measure the ΔpCircuit on the p/t plugs



(figure 2)

while turning the adjustment . WAIT UNTIL

THE VALVE STABILIZES ITSELF.

Close off procedure

1. Turn the adjustment bolt under the cap 

(figure 2) clockwise to fully open position (max.

12.5 Nm).

2. Turn off the ball valve  (figure 2) by position-

ing the handle across the pipe and wait for at

least 1 minute.

3. Close the on/off bolt  (figure 2) all the way

by turning clockwise with a flat screwdriver on

DN65/80 (2 1/2”) or a 13 mm (1/2”) Allen key

on DN80/100 (3”/4”) and DN125/150 (5”/6”).

To open the valve, please follow steps 1 through

3 in reverse order.

Filter cleaning

1. Isolate the filter by turning the valve off (fol-

low the close off procedure).

2. Then remove the copper tubing by loosening

the connection nuts . Experiencing some

water leaking is possible due to downstream

pressure.

3. Remove the filter housing  and thereafter

remove the filter  with a sharp pick. BE

CAREFUL NOT TO DAMAGE ENLARGEN

THE FILTER.

4. Clean the filter and put it back in. It is recom-

mended also to inspect the flow restrictor for

blockage .

This paper is a supplement to the FlowCon General Instruction

Latest release of any FlowCon material is available on www.owcon.com

FlowCon PIM™-DP 65-150 mm (2 1/2”-6”)

1H95040 - 04/2020

Page 2 of 2

FlowCon International assumes no responsibility for mistakes, if any, in any printed material.

Installation and Operation Instruction

Figure 1

Figure 2



FlowCon PIM™-DP DN65-80 (2 1/2”-3”)

FlowCon PIM™-DP DN100 (4”)













FlowCon PIM™-DP DN125-150 (5”-6”)









The FlowCon PIM™-DP are available in three

different models covering six different sizes:

•FlowCon PIM™-DP DN65-80 (2 1/2”-3”)

•FlowCon PIM™-DP DN100 (4”)

•FlowCon PIM™-DP DN125-150 (5”-6”)

Installation

Prior to installing the FlowCon PIM™-DP (supplied

from factory in fully open position), the system

should be properly flushed.

Capillary tube

Do not damage the capillary tube by compressing

or bending the tube with a bending radius below

20 mm (3/4”). Capillary tube is to be finger

mounted and tightened with 1-3Nm - DO NOT

OVER TIGHTEN.

Air venting

It is important to release all air inside the valve.

Upon doing so open and close the partner valve

fully. It will make the diaphragm to fully extend

and contract and thereby remove all trapped air

inside. PUMP MUST BE OPERATIONAL FOR

THIS PROCEDURE TO BE EFFECTIVE AND

IT MUST BE CARRIED OUT AFTER THE

SYSTEM HAS BEEN VENTED.

Setting

After installation and air venting, the desired

ΔpCircuit is set by adjusting the setting  (figure

2) under the cap on top of the valve. Use a 13 mm

(1/2”) Allen key and NOTE: ADJUSTMENT

SHOULD BE DONE SLOWLY, APPROXIMA-

TELY ONE TURN EVERY 10 SEC. Increasing

the ΔpCircuit by turning clockwise and decrease

by turning counter-clockwise. To increase to

maximum ΔpCircuit (170 kPaD / 25 psid) turn the

setting approximately 15 full turns.

FlowCon PIM™-DP 65-150 mm (2 1/2”-6”)

1H95040 - 04/2020

This paper is a supplement to the FlowCon General Instruction

Latest release of any FlowCon material is available on www.owcon.com

Page 1 of 2

FlowCon International assumes no responsibility for mistakes, if any, in any printed material.

Altri manuali FlowCon Unità di controllo

FlowCon

FlowCon SH series Manuale del proprietario

FlowCon

FlowCon AHU Wafer Manuale del proprietario

FlowCon

FlowCon S-JUST Manuale del proprietario

FlowCon

FlowCon DPCV Manuale del proprietario

FlowCon

FlowCon UniQ Manuale del proprietario

FlowCon

FlowCon EVS Manuale utente

FlowCon

FlowCon Green Manuale del proprietario

FlowCon

FlowCon SM.3.0 Manuale utente

FlowCon

FlowCon SM.1.1 Manuale del proprietario

FlowCon

FlowCon ABM Manuale del proprietario

FlowCon

FlowCon Green.3 DN40 Manuale del proprietario

FlowCon

FlowCon Green.3 Series Manuale del proprietario

FlowCon

FlowCon Green Manuale del proprietario

FlowCon

FlowCon SM 50-250mm Manuale del proprietario

FlowCon

FlowCon FlowCon Green Series Manuale del proprietario

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente