Page 6 / 16
MS3 Page 6 / 8
DIAGNOSTICS DIAGNOSTIQUES
Led Display Event Action
1x Red, 1x Green, 1x Blue Boot Sequence N/A
Fast Purple Blink Installer Mode for Validation testing Cycle ignition OFF to send an Unlock command
Fast Amber Blink Factory Reset Restart MS3 programming
1x Constant Amber Blink Unable to sync with Digital Remote
starter during MS3 power-up
Disconnect and Re-connect MS3 main harness.
Verify Protocol selection.
2x Constant Amber Blink Validation pending (make sure that the MS3
yellow (+) ignition wire is properly connected to
the vehicle's (+) ignition wire.)
Perform Validation Step:
a. Disconnect the MS3 unit
b. Cycle ignition to the ON position
c. Re-Connect the MS3 unit (DO NOT Press the
programming button)
d. The LED will blink Purple rapidly for 15
seconds
e. During this period, Cycle ignition to the OFF
position
f. If the vehicle door’s unlocks, your
programming is successful.
7x Amber Blink Pit-Stop Mode Not Available
Shutdown and Restart vehicle's engine and
retry Pit-stop mode and/or wrong DATA-LINK
communication port
1x Green Blink Command sent to Remote starter
succeeded
Remote starter will execute the command sent
from MS3 unit
1x Amber Blink Command sent to Remote starter failed Verify MS3 protocol selection and/or wrong
DATA-LINK communication port
État de la Del Évenement Action
1x Rouge, 1x Verte, 1x Bleue Séquence de démarrage N/A
Clignotement Rapide Mauve Mode installateur pour faire la
Validation
Mettre l'ignition a la position OFF pour
envoyer une commande de Déverrouillage
Clignotement Rapide Ambre Réinitialisation d’origine Refaire la programmation du module MS3
1x Clignotement Ambre
Constant
Incapable de syncroniser avec le
démarreur a distance digital durant
la mise sous tension du MS3.
Débrancher et Re-brancher le harnais
principal du module MS3. Véerifier la
sélection du protocol
