X400PRO.Q U IC K START . F UN D AM EN TA LS . MA IN T EN A NC E. T RO U BL ES HO O TI N G .
German RepRap X400 Pro V3
User Guide
Rev B01 germanreprap.us 7
E.6. Create each sub-assembly with T-slots and
6x12mm SHCS as shown below:
E.7. Slide 6 T Slots into the side of the profile sub as-
semblies for the crossbars.
E.8. Using an M5 hex wrench, attach a profile connect-
or to the 1st and 4th T Slots on all 4 of the assembled
legs. You want to tighten them just a bit so you can still
put the crossbar on the profile. The profile will go in the
top of the crossbar where the circular hole is.
E.9. The 2nd and 3rd T slots will be used for the top
mounting angle. The 5th and 6th T slots will be used for
the bottom mounting angle. Line up two crossbars and
one of the assembled sides of the stand. Adjust the T
slots on the bar so they line up with the mounting angle
holes.
E.10. Slip the two crossbars under the profile con-
nector and tighten completely to the T slot. This
should attach the cross bar to the leg of the stand.
E.11. Using four M6x12 screws, two for each
mounting angle, attach the mounting angles to the
T slots that were previously aligned.
E.12. Align the crossbars with the other pre-assembled
legs.
E.13. Repeat steps 8 through 12. You want to be sure
that when you are aligning your crossbars and mounting
angles, that you are perpendicular to the pre-assembled
crossbar, and that you are at the same height on the legs.
