Honeywell V100P Manuale utente

62-3006-2

INSTALLATION INSTRUCTIONS

V100P, Y100P Radiator Valve

FOR ONE-PIPE STEAM SYSTEMS

DESCRIPTION

The V100P Radiator Valve is designed to automatically

control temperatures of one-pipe low pressure steam

radiators, convectors, or other heating units. Install the

V100P Radiator Valve with a T100 Thermostatic Control

and an SA123A (or equivalent) steam/air vent (see Fig. 1).

The Y100P includes the V100P Valve and the SA123A

Steam/Air Vent. V100P Radiator Valves are cast bronze,

with nickel plating. The working parts are designed as an

easily replaceable cartridge. A resilient seat disk provides

positive shut-off.

SPECIFICATIONS

Valve

Maximum Temperature:

248°F (120°C).

Maximum Pressure:

15 psi (103 kPa).

Size:

1/8 in. angle body only.

SA123A Steam/Air Vent

Vent Port:

1/16 in.

Maximum Operating Pressure:

6 psi (41 kPa).

Height:

3-3/4 in.

Fig. 1. Mounted V100P Valve, SA123A Steam/Air

Vent, and T100A Controller.

OPERATION

The V100P Radiator Valve works in conjunction with an

SA123A (or equivalent) steam/air vent (see Fig. 1).

During a call for heat, the valve opens, allowing air to

vent from the radiator. This, in turn, allows steam to flow

into the radiator. When the space temperature reaches

the setpoint, the valve closes, preventing air from

venting. When the valve is closed, the radiator cools.

The control has a modulating rather than an on/off

action to minimize room temperature changes.

M11752

SA123A

V100P

T100A

62-3006—1 2

V100P RADIATOR VALVE FOR ONE-PIPE STEAM SYSTEMS

Home and Building Control

Honeywell Limited-Honeywell Limitée

155 Gordon Baker Road

North York, Ontario

M2H 3N7

62-3006—2 B.B. Rev. 10-98

Home and Building Control

Honeywell Inc.

Honeywell Plaza

P.O. Box 524

Minneapolis, MN 55408-0524

www.honeywell.com

www.honeywell.ca/braukmann/

The V100P is only one component of a one-pipe steam

conversion. Full conversion requires additional

components. For proper temperature control, Honeywell

recommends the following system modifications in

addition to the V100P:

1. A boiler interval timer to provide proper boiler

cycling.

2. Vacuum breakers on the supply piping, or on the

individual radiators to allow air to enter during the

boiler off cycles. Air entry is required to ensure

optimum control.

INSTALLATION

Install V100P Radiator Valves on the vent connection

tapping of a radiator or convector. Use thread sealant

on all connections.

1. Remove old steam/air vent from radiator or

convector.

2. Screw in 1/8 in. male fitting and V100P Valve.

NOTE: The V100P requires horizontal

positioning, or use of a controller with a

remote sensor.

3. Install steam/air vent into V100P.

IMPORTANT

Mount the vent vertically.

4. Install T100 series operator using instructions

included with the unit.

5. Set control to desired setpoint. Valve

automatically controls steam flow to maintain

temperature.

CHECKOUT

If radiator fails to heat:

1. Check that the boiler interval timer is installed

and operating.

2. Check that the vacuum breakers are installed

and operating.

3. Check for proper venting of air:

a. Turn control setpoint to the highest number.

b. If no air is released, turn the control setpoint

to minimum and remove the vent.

c. Check for adequate pressure by slowly

turning the control toward maximum. Steam

flow through the vent port verifies adequate

pressure. Turn setpoint to minimum.

d. If steam flows through the vent port, repair

or replace vent.

e. If steam does not flow through the vent port,

check for blockage in the valve body,

cartridge and the piping.

NOTE: See controller Installation Instructions for

additional troubleshooting procedures.

Printed in U.S.A. on recycled

paper containing at least 10%

post-consumer paper fibers.

Questo manuale è adatto per i seguenti modelli

Altri manuali Honeywell Unità di controllo

Honeywell

Honeywell 7800 SERIES Manuale utente

Honeywell

Honeywell TS131 Manuale utente

Honeywell

Honeywell Exi-/MaxLED T2 Manuale utente

Honeywell

Honeywell SV2 Series Manuale utente

Honeywell

Honeywell FIRE-LITE ALARMS TS540/1 Manuale utente

Honeywell

Honeywell Fire-Lite ANN-LC Manuale utente

Honeywell

Honeywell S4560 Manuale utente

Honeywell

Honeywell DirectLine DL421 Manuale utente

Honeywell

Honeywell SDW 10 Manuale di servizio

Honeywell

Honeywell 7800 SERIES Manuale utente

Honeywell

Honeywell MI-DCZME Manuale utente

Honeywell

Honeywell L506 Manuale utente

Honeywell

Honeywell PW6K1R1E Manuale dell'operatore

Honeywell

Honeywell PENA D MLS2000SSP Manuale di installazione e funzionamento

Honeywell

Honeywell TR70 Manuale utente

Honeywell

Honeywell AM-1 Series Manuale utente

Honeywell

Honeywell 7800 SERIES Manuale utente

Honeywell

Honeywell D05F Manuale utente

Honeywell

Honeywell FF-SRM200P2 Manuale utente

Honeywell

Honeywell REDLINK ERM5220R Manuale operativo

Honeywell

Honeywell MNG verafix Manuale utente

Honeywell

Honeywell ESSER IQ8MCP Manuale utente

Honeywell

Honeywell IDENT KEY 3 Manuale utente

Honeywell

Honeywell S8600A Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente