HP D7171A - NetServer - LPr Manuale utente
HP NetServer
Ultra Hot Swap Hard Disk Drive
and Tray
HP Part Number 5969-5925
Printed in February 2000
ii
Notice
The information contained in this document is subject to change without notice.
Hewlett-Packard makes no warranty of any kind with regard to this
material, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. Hewlett-Packard shall
not be liable for errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this material.
Hewlett-Packard assumes no responsibility for the use or reliability of its software
on equipment that is not furnished by Hewlett-Packard.
This document contains proprietary information that is protected by copyright.
All rights are reserved. No part of this document may be photocopied,
reproduced, or translated to another language without the prior written consent
of Hewlett-Packard Company.
Novell NetWare®is a registered trademark of Novell, Inc.
Microsoft®Windows NT, NTAS®, and MS-DOS®are registered trademarks of
Microsoft Corporation.
SCO®UNIX®is a registered trademark of The Santa Cruz Operation, Inc.
Banyan®and VINES®are the registered trademarks of Banyan Systems
Incorporated.
OS/2®is the registered trademark of the International Business Machines
Corporation.
Hewlett-Packard Company
Network Server Division
Technical Communications/MS 45SLE
10955 Tantau Avenue
Cupertino, CA 95014-8059 USA
© Copyright 2000 Hewlett-Packard Company.
Audience Assumptions
The guide is for the person who installs, administers, and troubleshoots LAN
servers. Hewlett-Packard Company assumes you are qualified in the servicing of
computer equipment and trained in recognizing hazards in products with
hazardous energy levels.
iii
Contents
1 Installation Procedure................................................................................. 1
Installing the Hot Swap Hard Disk Drive in a Tray (optional).......................... 1
Unpacking and Shipping................................................................................ 2
Installing the Hot Swap Hard Disk Drive ........................................................ 3
Removing the Hot Swap Hard Disk Drive ...................................................... 4
2 Disk Drive Characteristics........................................................................... 7
NetWare and DOS ........................................................................................ 7
OS/2 and Windows NT.................................................................................. 8
UNIX and Banyan Vines................................................................................ 9
3 Application Alerts...................................................................................... 11
D4903A Cooling Requirements.................................................................... 11
D3604A/B Storage System/6 using Ultra SCSI Drives................................. 11
Hot Swap Drives Must be Parked Prior to Removal..................................... 11
A Warranty and Support............................................................................... 13
Hardware Warranty ..................................................................................... 13
HP Repair and Telephone Support .............................................................. 13
HP World Wide Web Site............................................................................ 13
B Regulatory Information............................................................................. 15
1
1 Installation Procedure
This guide describes how to attach an Ultra hot swap hard disk drive to a hot
swap tray and install the hard disk drive in your computer. Additionally, this
guide provides the cautions and instructions for removing and storing the hard
disk drive.
Installing the Hot Swap Hard Disk Drive in a Tray
(optional)
If you purchase a hot swap tray accessory (D3349B) separately from the hot swap
hard disk drive, follow these steps to attach the tray accessory:
1. Make sure that the hot swap hard disk drive meets the specifications
written on the hot swap tray label. If the hot swap drive is capable of
running Ultra2 at LVD (low voltage differential) signal levels, a jumper
must be installed on the drive to force the drive into SE (single-ended)
mode. Refer to the drive manual for the location of a “Force SE” jumper.
NOTE Not all Ultra2/LVD drives have this jumper. If the drive does
not have the Force SE jumper, that drive model will probably
not work with HP NetServer Ultra Hot Swap backplanes.
2. Attach the drive to the hot swap tray with the screws provided in the order
shown in Figure 1-1.
Chapter 1 Installation Procedure
2
1
2
3
4
Figure 1-1. Hot Swap Hard Disk Drive and Tray Installation
Unpacking and Shipping
Your system has a shipping plug to ensure that the hot swap hard disk drive is
not damaged while it is being transported. Save this plug. If you plan to transport
your system, reinstall your shipping plug as shown in Figure 1-2.
Chapter 1 Installation Procedure
3
Figure 1-2. Shipping Plug
Installing the Hot Swap Hard Disk Drive
CAUTION Use one of the six (6) vertical shelves in the system. Do not
attempt to install the hot swap hard disk drive in the
horizontal shelves.
Protect the hot swap hard disk drive from static electricity by
leaving it in its antistatic bag until you are ready to install it.
Before handling the hard disk drive, touch any unpainted
metal surface to discharge static electricity. When you remove
the hard disk drive from the antistatic bag, handle it only by
the frame.
Do not touch the electrical components. Place the hard disk
drive on the antistatic bag whenever you set it down.
1. If there is a filler panel in the disk shelf, remove that panel.
2. On the hot swap hard disk drive, press the locking tab down, and lift the
lever up as far as it can go. (See Figure 1-3.) Lifting the lever retracts the
locking pin at the top of the hard disk drive.
Chapter 1 Installation Procedure
4
3. Holding the hard disk drive as shown in Figure 1-3, slide the hot swap
hard disk drive slowly into the shelf until it stops.
4. Press the lever down as far as it will go.
Figure 1-3. Installing the Hot Swap Hard Disk Drive
Removing the Hot Swap Hard Disk Drive
1. To unlock the hot swap hard disk drive, push the tab down and then lift
the front lever.
2. Pull the hard disk drive out about an inch (2.5 cm) to break the power
connection.
3. Wait about 30 seconds for the hard disk drive to stop spinning and the
drive heads to park.
4. Use your hand to support the bottom of the hard disk drive, as shown in
Figure 1-4. Slowly pull the hard disk drive straight out. Do not allow the
hard disk drive to fall.
5. Turn the hard disk drive slowly to its horizontal storage orientation.
6. Place the hard disk drive in an electrostatic protected container. Do not
stack hot swap hard disk drives.
Chapter 1 Installation Procedure
5
Figure 1-4. Removing the Hot Swap Hard Disk Drive
Altri manuali per D7171A - NetServer - LPr
117
Questo manuale è adatto per i seguenti modelli
5
Indice
Altri manuali HP Hardware per computer
HP
HP AF079A Guida all'installazione
HP
HP 381513-B21 - Smart Array P800 Controller... Manuale utente
HP
HP P Class 450/500/550/600/650/700/750 Manuale
HP
HP MicroServe Manuale utente
HP
HP MPIO Manuale di installazione e funzionamento
HP
HP Z Turbo Drive Quad Pro Manuale utente
HP
HP HP-UX 10.20 Manuale utente
HP
HP Smart Array P400 Istruzioni utente
HP
HP QMH2672 Manuale utente
HP
HP 64767 Manuale utente
HP
HP CB001A Manuale utente
HP
HP StoreOnce 2700 Manuale dell'operatore
HP
HP 64782 Manuale utente
HP
HP Adaptec ultra p2280a Manuale utente
HP
HP ProLiant DL140 Manuale utente
HP
HP Integrity rx1600 Manuale utente
HP
HP 5930-4Slot Manuale utente
HP
HP A3550A - High Availability Disk Arrays Model 20 Storage... Manuale utente
HP
HP GbE2c - Blc Layer 2/3 Fiber SFP Option Come usare
HP
HP Kayak XW U3-W3 Manuale utente
Manuali Hardware per computer popolari di altre marche
EMC2
EMC2 VNX Series Manuale del proprietario
Panasonic
Panasonic DV0PM20105 Manuale utente
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuale utente
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuale utente
Raidon
Raidon iT2300 Manuale utente
National Instruments
National Instruments PXI-8186 Manuale utente
