PIPETBOYpro – Operating instructions V00 Introduction
www.integra-biosciences.com 5
1.3 Safety notes
The PIPETBOY pro corresponds to the state of the art, complies to the recognized safety
regulations and is safe to operate. The PIPETBOYpro can be operated only when it is in
perfect conditions and while observing these operating instructions.
The device may be associated with residual risks if it is used or operated improperly by
untrained personnel. Any person charged with the operation of the PIPETBOY pro must
have read and understood these operating instructions, and particularly, the safety notes,
or must have been instructed by supervisors so that safe operation of the device is
guaranteed.
Regardless of the listed safety notes, additionally applicable regulations and guidelines of
trade associations, health authorities, trade supervisory offices, etc. must be observed.
Do not open, convert or alter the PIPETBOY pro in any way. Repairs may only be
performed by INTEGRA Biosciences AG or by an authorised after-sales service member.
Parts may be replaced with original INTEGRA parts only.
WARNING
Do not use or charge the PIPETBOY pro in an atmosphere with danger of
explosion. Also, do not pipette highly flammable liquids such as acetone or
ether.
When handling dangerous substances, comply with the material safety data
sheet (MSDS) and with all safety guidelines such as the use of protective
clothing and safety goggles. Never point a pipette in anyone’s direction.
CAUTION
Avoid pipetting of liquids whose vapours could attack the materials PA
(polyamide), POM (polyoxymethylene), FPM (fluor-rubber), NBR (nitrile-
rubber), CR (chloroprene), silicone. Corrosive vapours could also damage
metallic parts inside the device.
Information on how substances can damage specific materials is given in
“chemical resistance charts” that are available on the internet.
Use an original INTEGRA mains adapter only and protect it from moisture,
otherwise the PIPETBOY pro might be damaged.
NOTE
Prolonged exposure of the PIPETBOY pro to UV-light can cause
discolouration and/or yellowing of the plastic housing. However, this will not
affect the performance of the device in any way.
