7
Remove the plate, then insert the battery (model CR2450), respecting the polarity.
5. Enrolling the XAS 8000 sensor
The sensor registration can be performed through the AMT 8000 Desktop Programmer software, remote AMT mobile
application, keyboard commands and synchronization button on the alarm center.
Follow the procedure below for registration through the synchronization button on the control panel.
In this type of registration, the address of the sensors follows the registration sequence, Example: First sensor will be
registered in zone 1, the second sensor in zone 2 and so on. For other forms of registration, please consult the complete
manual of the AMT 8000 control panel.
1. Press the alarm control panel synchronization button;
2. LED 3 on the control unit stays on for 3 minutes, indicating that it is waiting for the sensor to register;
3. Insert the battery into the sensor;
4. Press the sensor synchronization key;
5. The status LED will ash green indicating the correct registration. If it ashes red, the registration was not carried out
and the procedure must be repeated.
5.1. Deleting sensor registration
To remove the device from the control panel, two steps are necessary, one directly on the sensor and the other on the
control panel.
» Sensor: press and hold the sensor timing switch for approximately 10 seconds, watching the status LED blink red twice
slowly.
» Alarm control panel: enter the programming mode and type the command below:
01 to 64
Enter71Enter Zone N° +++
For other ways to remove the sensor from the control panel, please consult the complete manual of the AMT 8000 control
panel.
