JAI GO-5000M-PMCL-UV Manuale utente
Thank you for purchasing this product.
Be sure to read this documentation before use.
This documentation includes important safety precautions and instructions on how to operate the unit. Be sure to read this documentation to ensure
proper operation.
The contents of this documentation are subject to change without notice for the purpose of improvement.
© 2022 JAI
User Manual
GO-5000M-PMCL-UV
CMOS Digital Progressive Scan
Monochrome UV Camera with Mini Camera Link Interface
Document Version: 1.1
GO-5000M-PMCL-UV_Manual_Ver.1.1_2022-11-17
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Table of Contents
- 2 -
Table of Contents
Table of Contents 2
About Technical Note 5
Notice/Warranty 6
Notice 6
Warranty 6
Certifications 6
CE Compliance 6
FCC 6
Warning 7
Supplement 8
Usage Precautions 9
Notes on Cable Configurations 9
Notes on Attaching the Lens 9
Notes on Camera Link Cable Connections 9
Phenomena Specific to CMOS Image Sensors 10
Notes on Exportation 10
Features 11
Feature Overview 11
Parts Identification 13
①Lens Mount (C-Mount) 13
②POWER/TRIG LED 14
③ ④ Camera Link Connector 1 and 2 14
⑤Camera Locking Screw Holes (M3, 3mm depth) 15
Preparation 16
Short ASCII Commands 16
Step 1: Connect Devices 17
①Lens 18
②Direct Mounting (or Use MP-43 Tripod AdapterPlate) 18
③Camera Link Cable 19
④Frame Grabber Board 19
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Table of Contents
- 3 -
Step 2: Verify Camera Operation 19
Step 3: Verify the Connection Between the Camera and PC 20
Step 4: Change the Camera Settings 21
Configure the Output Format 21
Step 5: Adjust the Image Quality 22
Display the Image 22
Adjust the Gain 22
Adjust the Black Level 23
Step 6: Save the Settings 23
Save the User Settings 24
Load the User Settings 24
Main Functions 25
Camera Link Interface 25
Digital IN/OUT Interface 29
Pulse Generator 33
Sensor Layout 37
Camera Output Format (Tap Geometry) 38
Output Timing (Horizontal) 42
1x8-1Y (LVAL Active/Non-Active, HTotal) 43
1x4-1Y (LVAL Active/Non-Active, HTotal) 44
1x3-1Y (LVAL Active/Non-Active, HTotal) 45
1x2-1Y (LVAL Active/Non-Active, HTotal) 46
1x8-1Y (1 LineClock, Horizontal Frequency/Period) 47
1x4-1Y (1 LineClock, Horizontal Frequency/Period) 51
1x3-1Y (1 LineClock, Horizontal Frequency/Period) 54
1x2-1Y (1 LineClock, Horizontal Frequency/Period) 55
Output Timing (Vertical) 58
1x8-1Y (FVAL, DVAL, V-Offset, Exposure Time) 59
1x4-1Y (FVAL, DVAL, V-Offset, Exposure Time) 60
1x3-1Y (FVAL, DVAL, V-Offset, Exposure Time) 61
1x2-1Y (FVAL, DVAL, V-Offset, Exposure Time) 62
1x8-1Y (Frame Period, Exposure Time, Exposure End to FVAL Active Start) 63
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Table of Contents
- 4 -
1x4-1Y (Frame Period, Exposure Time, Exposure End to FVAL Active Start) 64
1x3-1Y (Frame Period, Exposure Time, Exposure End to FVAL Active Start) 65
1x2-1Y (Frame Period, Exposure Time, Exposure End to FVAL Active Start) 66
ROI (Region of Interest) Settings 67
Digital Output Bit Allocation 67
Acquisition Control 68
Exposure Settings 70
Trigger Control 73
Normal Continuous Operation 75
Timed Mode 76
Trigger Width Mode 77
RCT Mode 78
RCT Mode Together with ALC Function 79
Sequence Mode 80
Trigger Sequence Mode Timing 81
Sequence Index Table (Default) 81
Descriptions of Index Table Parameters 82
Multi ROIFunction 83
Operation and Function Matrix 85
Black Level Control 86
Gain Control 87
LUT (Lookup Table) 89
Gamma 90
Shading Correction 91
Blemish Compensation 91
ALC (Automatic Level Control) 92
HDR (High Dynamic Range) 93
Miscellaneous 94
External Appearance and Dimensions 94
Spectral Response 95
Specifications 96
Appendix 100
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Table of Contents
- 5 -
Short ASCII Command Communication Protocol 102
Protocol (Short ASCII Command) 102
GenCP Bootstrap Register 103
Technology Specific Bootstrap Register 104
Device Control 104
Image Format Control 105
Acquisition Control 106
Analog Control 107
Digital IO Control 108
LUT Control 109
Transport Layer Control 109
User Set Control 109
JAI Custom 110
User's Record 121
Revision History 122
About Technical Note
Some additional technical information is provided on the JAI website as Technical Notes. In this
manual, if a technical note is available for a particular topic, the above icon is shown. Please refer to
the following URL for Technical notes.
https://www.jai.com/support-software/technical-notes
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Notice/Warranty
- 6 -
Notice/Warranty
Notice
The material contained in this manual consists of information that is proprietary to JAI Ltd., Japan, and
may only be used by the purchasers of the product. JAI Ltd., Japan makes no warranty for the use of
its product and assumes no responsibility for any errors which may appear or for damages resulting
from the use of the information contained herein. JAI Ltd., Japan reserves the right to make changes
without notice.
Company and product names mentioned in this manual are trademarks or registered trademarks of
their respective owners.
Warranty
For information about the warranty, please contact your factory representative.
Certifications
CE Compliance
As defined by the Directive 2004/108/EC of the European Parliament and of the Council, EMC
(Electromagnetic compatibility), JAI Ltd., Japan declares that GO-5000M-PMCL-UV complies with the
following provisions applying to their standards.
EN 61000-6-3 (Generic emission standard part 1)
EN 61000-6-2 (Generic immunity standard part 1)
FCC
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment and receiver.
lConnect the equipment into an outlet on a circuit different from that to which the receiver is
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Notice/Warranty
- 7 -
connected.
lConsult the dealer or an experienced radio/TV technician for help.
Warning
Changes or modifications to this unit not expressly approved by the party responsible for FCC
compliance could void the user’s authority to operate the equipment.
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Notice/Warranty
- 8 -
Supplement
The following statement is related to the regulation on “Measures for the Administration of the Control
of Pollution by Electronic Information Products “, known as “China RoHS“. The table shows contained
Hazardous Substances in this camera.
mark shows that the environment-friendly use period of contained Hazardous Substances is 15
years.
重 要 注 意 事 项
有毒，有害物质或元素名称及含量表
根据中华人民共和国信息产业部『电子信息产品污染控制管理办法』， 本产品《 有毒，有害物质或
元素名称及含量表》如下．
部件名称
有毒有害物质或元素
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr (VI))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
电路板 × 〇 〇 〇 〇 〇
螺丝 × 〇 〇 〇 〇 〇
插座 × 〇 〇 〇 〇 〇
..... ..... ..... ..... ..... ..... .....
〇:表示该有毒有害物质在该部件所有均质材料中的含量均在GB/T 26572-2011规定的限量要求以下。
×:表示该有毒有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572-2011规定的限量要求。
环保使用期限
电子信息产品中含有的有毒有害物质或元素在正常使用的条件下不会发生外 泄或突变、
电子信息产品用户使用该电子信息产品不会对环境造成严重污染 或对其人身、财产造成
严重损害的期限。
数字「15」为期限15年。
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Usage Precautions
- 9 -
Usage Precautions
Notes on Cable Configurations
The presence of lighting equipment and television receivers nearby may result in video noise. In such
cases, change the cable configurations or placement.
Notes on Attaching the Lens
How to Clean a Sensor
Avoiding Dust Particles
When attaching the lens to the camera, stray dust and other particles may adhere to the sensor
surface and rear surface of the lens. Be careful of the following when attaching the lens.
lWork in a clean environment.
lDo not remove the caps from the camera and lens until immediately before you attach the lens.
lTo prevent dust from adhering to surfaces, point the camera and lens downward and do not
allow the lens surface to come into contact with your hands or other objects.
lAlways use a blower brush to remove any dust that adheres.
lNever use your hands or cloth, blow with your mouth, or use other methods to remove dust.
Notes on Camera Link Cable Connections
Secure the locking screws on the connector manually, and do
not use a driver. Do not secure the screws too tightly. Doing so
may wear down the screw threads on the camera. (Tightening
torque: 0.15 N·m or less)
Caution: Secure manually. Do not secure too tightly.
GO-5000M-PMCL-UV User Manual (Ver. 1.1) Usage Precautions
- 10 -
Phenomena Specific to CMOS Image Sensors
The following phenomena are known to occur on cameras equipped with CMOS image sensors.
These do not indicate malfunctions.
lAliasing: When shooting straight lines, stripes, and similar patterns, vertical aliasing (zigzag
distortion) may appear on the monitor.
lBlooming: When strong light enters the camera, some pixels on the CMOS image sensor may
receive much more light than they are designed to hold, causing the accumulated signal charge
to overflow into surrounding pixels. This “blooming” phenomenon can be seen in the image but
does not affect the operation of the camera.
lFixed pattern noise: When shooting dark objects in high-temperature conditions, fixed pattern
noise may occur throughout the entire video monitor screen.
lDefective pixels: Defective pixels (white and black pixels) of the CMOS image sensor are
minimized at the factory according to shipping standards. However, as this phenomenon can be
affected by the ambient temperature, camera settings (e.g., high sensitivity and long exposure),
and other factors, be sure to operate within the camera’s specified operating environment.
Notes on Exportation
When exporting this product, please follow the export regulations of your country or region.
Altri manuali per GO-5000M-PMCL-UV
1
Indice
Altri manuali JAI Sistema di visione artificiale
JAI
JAI BM-500 GE Manuale utente
JAI
JAI GO-5000M-PGE Manuale utente
JAI
JAI GO-5000M-PGE-UV Manuale utente
JAI
JAI SW-4010Q-MCL-M52 Manuale utente
JAI
JAI GO-5000M-PGE-1 Manuale utente
JAI
JAI GO-5100MP-USB Manuale utente
JAI
JAI GO-2400M-PGE Manuale utente
JAI
JAI GO-5000M-PGE-UV Manuale utente
JAI
JAI GO-5000M-USB-UV Manuale utente
JAI
JAI GO-5000M-USB-UV Manuale utente
