JBL HT1D Manuale utente
HT1F,
HT1D
simple
set-up guide
thank you for choosing JBL. For over 50 years, JBL
has been involved in every aspect of musical and film recording
and reproduction, from live performances to monitoring the
recordings you play in your home, car, or office.
We’re confident that the JBL loudspeakers you have
chosen will provide every note of enjoyment that you expected –
and that when you think about purchasing additional audio
equipment for your home, car, or office, you will once again
choose JBL.
Please take a moment to complete the enclosed profile card.
It enables us to keep you posted on our latest advancements,
and helps us to better understand our customers and build
products that meet your needs and expectations.
JBL Consumer Products
HT1F, HT1D OM 7/22/98 2:39 PM Page 1
one. Speaker Placement
The HT1F and HT1D are THX®
licensed home theater loud-
speakers. When combined with
the HT PS300 powered sub-
woofer, a THX controller, and
THX amplifiers, the
JBL HT Series loudspeaker
system will deliver state-
of-the-art home theater
experience to your home.
The HT Series loudspeakers
also deliver clear accurate
stereo music reproduction.
Introduction
Properly placing your speaker
components is vital to achiev-
ing the maximum sonic per-
formance. Please follow the
recommendations in this
guide, to properly position
your speakers.
Note: Do not attempt to
install any type of mounting
brackets onto your speakers.
Drilling Holes in the product
or improperly installing
mounting brackets may void
your JBL warranty and cause
a safety hazard. Contact JBL
or your dealer/installer for
additional information.
<2 ft.
• The left and right speakers
should be at the exact same
height, with the tweeter’s
height positioned at the
midpoint of the screen.
• The center channel speaker
must be vertically oriented.
Placing the speaker horizon-
tally will result in less precise
center channel performance.
• If necessary, tilt the center
channel so that the tweeters
are aimed at the listening area.
HT1F Front Channel Loudspeakers
Placement Tips
Direct view or rear
projection TV.
Front projection system.
Place center speaker behind
acoustically transparent
screen.
<2 ft.
Alternate front speaker
placement.
HT1F, HT1D OM 7/22/98 2:39 PM Page 2
Preparing the Speaker Cable
1. Determine the length of
wire necessary to connect
your amplifier to the speaker
farthest away. Remember to
allow for extra cable to be
able to conceal it under
baseboards, run it around
corners, etc.
2. Make the cables for both
speakers this length. Keeping
both cable lengths the same
will help maintain proper
signal balance and imaging.
3. Separate the two conduc-
tors that make up each cable,
for about one inch. Then strip
off about 3/8" of insulation.
4. Twist each conductor’s thin
wires into a tightly bunched
spiral.
5. Identify a difference
between the two conductors.
This may be done in various
ways, depending upon the
type and brand of cable you
are using.
• Different color wire
• A strand of thread in one
conductor
• A colored line on one con-
ductor’s outer insulation
• Raised ribs on one conduc-
tor’s outer insulation
• A printed (+) marking on
one of the insulators
Some of the More Common Differentiating Marks Are:
Wire Length Recommended Speaker Cable Size
Up to 20 ft. 16 gauge
Up to 50 ft. 14 gauge
Greater than 50 ft. 12 gauge or heavier
two. Hookup
Connection Tips
– +– +– +
– + – +
Front Speakers
Left Center Right
Left
HT1F
Right
HT1F
– +
Center
HT1F
Receiver/Amplifier
– +– +
– + – +
Surround Speakers
Left Right
Left
HT1D
Right
HT1D
Receiver/Amplifier
HT1D
HT1F
HT1F, HT1D OM 7/22/98 2:39 PM Page 3
2– 3 ft.
HT1D Surround Loudspeakers
• Place the surrounds to the
sides, or slightly behind, the
listening position with the
speaker terminals placed
against the wall.
• Place surround speakers
with the port tubes facing the
screen. (One speaker will
appear “upside-down”. This
will not affect sound quality.)
Placement Tips
Alternate surround
placement.
HT1F, HT1D OM 7/22/98 2:39 PM Page 4
If the sound seems to come
from instead of between
the speakers, check the
following:
• Make sure the polarity
(+ and –) of the speaker
inputs are connected properly.
• The speakers are too far
from the back or side walls or
are too far apart. Experiment
with the speaker placement.
If there is very low or no
output from any of the
speakers, check the
following:
• Receiver or processor/
amplifier is on and a source is
playing.
• Review proper operation of
your receiver/processor.
If there is very low or no
output from one or more
speakers, check the
following:
• Check the “Balance” control
on your receiver/processor.
• Check the surround level on
your receiver/processor.
• Check all wires and connec-
tions between the receiver/
amplifier and the speakers.
Make sure all wires are con-
nected and that none of the
speaker wires are frayed, cut,
or punctured.
• Review proper operation of
your receiver/processor.
If the system plays at low
volumes but shuts off as
volume is increased, check
the following:
• Check all wires and con-
nections between receiver/
amplifier and the speakers.
Make sure all wires are con-
nected and that none of the
speaker wires are frayed, cut,
or punctured.
• If more than one pair of
speakers is being used, check
the minimum impedance
requirements of your receiver/
amplifier.
Troubleshooting
HT1F, HT1D OM 7/22/98 2:39 PM Page 5
HT1F
High Frequency Drivers
2 x 1" pure titanium
Midrange Drivers
2 x 5" high polymer laminate
Frequency Response
70Hz – 20kHz
Recommended Amplifier
Power*
10 – 130 watts
Sensitivity
87dB @ 1 watt/1 meter
Impedance
8 ohms
Crossover Frequency
2800Hz
Dimensions (HxWxD)
17-1/2 x 10 x 8-1/2 inches
445 x 254 x 216mm
Weight
21 lbs/9.5 kg
HT1D
High Frequency Drivers
2 x 1" pure titanium
Midrange Drivers
2 x 5" high polymer laminate
Frequency Response
100Hz – 20kHz
Recommended Amplifier
Power*
10 – 130 watts
Sensitivity
87dB @ 1 watt/1 meter
Impedance
6 ohms
Crossover Frequency
2800Hz
Dimensions (HxWxD)
13-7/8 x 9-1/4 x 7-3/4 inches
352 x 235 x 197mm
Weight
15 lbs/6.8 kg
Specifications
Declaration of Conformity
We, JBL Europe A/S
Kongevejen 194B
DK-3460 Birkerød
DENMARK
declare in own responsibility, that the products described
in this owner’s manual are in compliance with technical
standards:
EN 50 081-1/1992
EN 50 082-1/3.1995
Steen Michaelsen
JBL Europe A/S
Birkerød. DENMARK. 8/96
JBL Consumer Products
80 Crossways Park West, Woodbury, NY 11797
8500 Balboa Boulevard, Northridge, CA 91329
1-800-336-4JBL (4525) (USA only)
©1996 JBL, Incorporated.
JBL is a registered trademark of JBL, Incorporated.
THX is a registered trademark of Lucasfilm Ltd.
Manufactured under license of Lucasfilm Ltd.
Printed in USA 10/96 Part No. HTOM
Occasional refinements may be
made to existing products
without notice, but will always
meet or exceed original
specifications unless otherwise
stated.
*Undistorted continuous power
per channel.
A Harman International Company
C
E
L
E
B
R
A
T
I
N
G
5
0
Y
E
A
R
S
HT1F, HT1D OM 7/22/98 2:39 PM Page 6
Altri manuali per HT1D
1
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali JBL Altoparlanti
JBL
JBL LSR6328P Manuale utente
JBL
JBL 4310 Manuale utente
JBL
JBL SoundFactor SF12Mi Manuale utente
JBL
JBL STADIUM GTO620 Manuale utente
JBL
JBL CONTROL 1X Manuale utente
JBL
JBL L60T Manuale utente
JBL
JBL OnBeat aWake Manuale utente
JBL
JBL MI-15a Manuale utente
JBL
JBL ON BEAT VENUE LT Manuale utente
JBL
JBL TLX105 Manuale utente
JBL
JBL GO ESSENTIAL Manuale utente
JBL
JBL 4312MII Manuale utente
JBL
JBL CLIP+ Manuale utente
JBL
JBL NO TOUR IBT Manuale utente
JBL
JBL TR125 Manuale utente
JBL
JBL 250Ti Jubilee Manuale utente
JBL
JBL AEN24 Manuale utente
JBL
JBL Authentics 200 Manuale utente
JBL
JBL FLIP 3 Manuale utente
JBL
JBL DUET Manuale utente
