78
PARKING DEVICE
LEG REST
The stroller is equipped with a parking device (pos.
13, fig. 1), which block simultaneously both rear
wheels and the movement of the stroller.
Press the pedal on the right wheel with your foot (fig.
9) to block the movement of the stroller. Make sure
the parking device is engaged. The stroller should
not move at a light push.
Lift the pedal up with your foot to release the parking
device.
ATTENTION! When the stroller is not in motion,
always use the parking device.
ATTENTION! Always engage the parking device when putting in or taking your
child out of the stroller, as well as when you make adjustments, and when folding
or unfolding the stroller!
The leg rest (pos. 5, fig. 1) can be positioned in
three levels.
To adjust the leg rest, press down both buttons on
both sides of leg rest and move it up or down until
you hear a click (fig. 10).
ADJUSTING THE BACKREST
CHANGING HANDLE HEIGHT
The backrest can be adjusted in 3 positions.
To take the backrest one position down or to set
it in lying position, pull the lever (pas. 15, fig. 1) in
the upper part of the seat (fig. 12-1). At the same
time press the seat back. Release the lever to fix
the position.
To set the seat in a higher position lift the lever up
(fig. 12-2). At the same time press the seat up to the
desired position. Release the lever to fix the chosen position. You must hear a click.
You can adjust the handle of the stroller at 3 posi-
tions. Press the button in the center of the handle
(pas. 9, fig. 1), and set the handle in the desired
position (fig. 13) by moving up or down.
When the position is fixed, the pins of the handle
must be located in the respective openings in the
frame.
Fixing of handle positions is always accompanied
by a click.
ATTACHING AND REMOVING CANOPY
Place the brackets on both sides of the canopy
(pos 1, fig. 1) on to the handle tubes so that the
pins match the openings in the canopy brackets.
Install with pressure until you hear a click and the
pins show through the openings in the brackets (fig.
8). Cover the backrest with the canopy and fix the
canopy with the Velcro straps.
Open the zipper in the rear side of the canopy to
enlarge it. To open or close the canopy you must
pull it out or push it back until the desired position is reached.
To remove the canopy pull the two brackets out, open the Velcro straps and
remove the canopy.
