SID-X1N – Contents i
Contents
1Introduction 1
2Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 About the Power Connect Plus™ Feature 3
2.4 Shielded Twisted Pair/Unshielded Twisted Pair 3
2.5 Recycling Kramer Products 3
3Overview 4
4Defining the SID-X1N Step-in Commander 6
5Connecting the SID-X1N 8
5.1 Connecting the Remote Step-In Switch and LED 9
5.2 Connecting the Remote Select Switch and LED 10
5.3 Connecting the Remote Input Selection LEDs 11
6Principles of Operation 12
6.1 Video Input Selection 12
6.2 Audio Signal Control 13
6.3 Automatic Output Shutdown 13
7Operating the SID-X1N 14
7.1 Manually Selecting an Input 14
7.2 Taking Control of the Switcher Input 15
7.3 Locking the EDID 15
7.4 Adjusting the UXGA Input Phase 15
8Configuring and Maintaining the SID-X1N 16
8.1 Setting the Configuration DIP-switch 16
9Wiring the Twisted Pair RJ-45 Connectors 18
10 Technical Specifications 19
10.1 Supported Resolutions 20
11 Default EDID 22
11.1 HDMI, DisplayPort and DVI 22
11.2 PC-UXGA 24
12 Remote Commands 26
12.1 Kramer Protocol 2000 Syntax 26
12.2 Kramer Protocol 2000 Instruction Codes 27
12.3 RS-232 Hardware Interface 28
Figures
Figure 1: SID-X1N Step-in Commander Front Panel 6
Figure 2: SID-X1N Step-in Commander Rear Panel 7
Figure 3: Connecting the SID-X1N Step-in Commander 8
Figure 4: Remote Step-In Switch and LED Wiring 9
Figure 5: Remote Select Switch and LED Wiring 10
Figure 6: Remote Input Indicator LED Connections 11
Figure 7: Remote Input Indicator LED Wiring 11
Figure 8: The Configuration DIP-switch 16
Figure 9: TP Pinout Wiring 18
