Mach CW110F Manuale utente
User manual
CW110F
CW112F
CW112C
1
Please read this manual carefully before attempting to install the product
Every effort has been taken to ensure that these instructions are correct.
Mach Speakers A/S does not accept any liability for loss or damage caused or
alleged to be caused directly or indirectly by these instructions. The contents
of the instructions may be subject to change without notice. Mach Speakers
A/S makes no warranty of any kind with regard to these instructions.
Copyright 2004 Mach Speakers A/S, Denmark.
All rights reserved. No part of these instructions may be reproduced, in any
form or by any means, without permission in writing from Mach Speakers
A/S, Denmark.
Mach Speakers A/S • Perspektivvej 2 • 9900 Frederikshavn • Denmark
Tel: +45 72 15 08 52 • Fax: +45 98 43 14 15 • e−mail: Mach-Service@martin.dk
P/N 35020018,Rev B
2
3
Table of contents
Introduction ...................................................................................................................................................................................... 3
CW Subwoofer series ..................................................................................................................................................................... 4
Placement options.......................................................................................................................................................................... 5
Sub terminal...................................................................................................................................................................................... 6
The CI series terminal..................................................................................................................................................................... 6
Connecting the sub to the speakers ........................................................................................................................................ 7
Painting the subwoofer................................................................................................................................................................. 8
Maintenance of subwoofer.......................................................................................................................................................... 9
How to remove grille........................................................................................................................................................... 9
How to change woofer ....................................................................................................................................................... 9
How to remove terminal module ................................................................................................................................... 9
How to change crossover .................................................................................................................................................. 9
Technical information..................................................................................................................................................................10
Specsheet CW110F.............................................................................................................................................................10
Specsheet CW112F.............................................................................................................................................................11
Specsheet CW112C............................................................................................................................................................12
Warranty ...........................................................................................................................................................................................13
Declaration of conformity..........................................................................................................................................................13
Ordering spare parts.....................................................................................................................................................................14
CI-range overview..........................................................................................................................................................................15
CS-range overview........................................................................................................................................................................16
MIW-range overview....................................................................................................................................................................17
2
3
Introduction
Thank you for purchasing a product from Mach Speakers A/S. Every effort has been made to ensure that our products
meet your requirements and we sincerely hope that we will live up to your expectations.
To get the most out of your Mach speakers and ensure an easy and trouble-free installation please read the manual
carefully and follow the instructions.
If you have any additional questions or comments please do not hesitate to contact our headquarters in Denmark
at the following address:
Mach Speakers A/S
Perspektivvej 2
DK-9900 Frederikshavn
Denmark
Tel: +45 72150852
http://www.mach.dk
Or send an e-mail to: machservice&support@martin.dk
4
5
CW110F
The CW110F subwoofer combines easy installation and
deep bass output due to the unique design. It can be
placed upright or at against walls or under a couch. The
subwoofer has 10 integrated ying points allowing for
multiple ying options on a wall or against the ceiling.
The subwoofer has a 10” double voice coil drive unit
which allows a stereo signal to be applied to the terminals.
The built-in crossover makes it a perfect solution in
combination with the Ci4 and Ci6 speakers.
CW112F
The CW112F subwoofer combines easy installation and
deep bass output due to the unique design. It can be
placed upright or at against walls or under a couch. The
subwoofer has 10 integrated ying points allowing for
multiple ying options on a wall or against the ceiling.
The subwoofer has a 12” double voice coil drive unit
which allows a stereo signal to be applied to the terminals.
The built-in crossover makes it a perfect solution in
combination with the Ci speakers.
CW112C
The CW112C subwoofer combines easy installation and
deep bass output due to the unique design. The subwoofer
is designed to be placed in a corner or mounted on a
standard ceiling. The subwoofer has 12 integrated ying
points allowing for further exibility when mounting the
subwoofer on a wall or against the ceiling. The CW112C
has a 12” double voice coil drive unit which allows a stereo
signal to be applied to the terminals. The built-in crossover
makes it a perfect solution in combination with the Ci
speakers.
CW Subwoofer series
The CW subwoofers have been designed to complement the CI range of speakers. The cabinets have been
shaped to achieve an attractive appearance as well as easy mounting and positioning. All C-range products are
constructed for heavy-duty use in professional environments. Details regarding the subwoofers are listed below.
4
5
CW110F-112F CW112C
Placement options
The subwoofers can be mounted in almost any position depending on the model.
6
7
www.mach.dk
A Professional Product
Made in Denmark
INPUT
OUTPUT
For Satellite Speakers
L+
L -
R+
R -
L+
L -
R+
R -
CAUTION!
RIGGING THIS SYSTEM
SHOULD ONLY BE DONE
BY QUALIFIED PERSONS
Sub terminal
Stereo input/output terminal with screw
connectors.
Input from amplier
Left +/- . Right +/-
Output for satellite speakers.
Left +/- . Right +/-
The CI series terminal
Red (+) Black (-) Input push connectors.
206
120
150
270
200
160
400
290
220
CI4
CI6
CI8
Quality test
label
Serial
number
label
Cable clamp
6
7
Connecting the sub to the speakers
Output
Amplier
Mains
Input
R +/- L +/-
Sub CW110F - CW112F - CW112C
R +/-L +/-
RightLeft
CI4-CI6-CI8 CI4-CI6-CI8
8
9
Painting the subwoofer
The C-range cabinets are made of MDF coated with Mach Safecoat and can easily be painted to match the color
scheme of your venue.
To paint your speaker please follow the procedure below:
1. Remove the front grille
2. Degrease the cabinet on all surfaces with denatured alcohol/methylated spirit
Warning: Use of other types of cleaning chemicals can damage the cabinet and should be avoided
3. Mask all areas that should remain unpainted (tweeter, woofer, switch, terminals, reex port etc)
4. Paint the speaker with Etching primer 2K, P565-713, chromate-free, or a similar product
5. Let the primer dry
6. Apply paint in thin layers using a paint spraying device
7. When spraying the grille be very careful not to ll any holes, as this will have a serious impact on sound
quality
8. Let the paint dry
9. Remove masking
10. Put the grille back in place
8
9
Maintenance of the subwoofer
Although subwoofer systems normally only require very limited maintenance there are several things you can do to
ensure that your Mach system sounds as good 3 years after installation as on the day you bought it:
Never overload your system – stay within the specied limits for power handling.
Always keep the speaker clean and dry.
As with any electrical product, currents will accelerate corrosion of metal surfaces. Therefore, it is recommended to
check the terminals for corrosion at regular intervals, especially if the speaker is mounted in a hostile environment.
How to remove the grille
Remove the screws in the grille and pull the grille out. When replacing the grille do not over-tighten the screws.
How to change the woofer
Remove the grille, then remove the screws in the woofer and pull them out. Carefully disconnect the wires and
connect them to the new transducers, tighten the screws and ret the grille.
How to remove the terminal module
Loosen the six screws and pull the terminal out. Note the positions of the wires, then carefully disconnect the wires
from the transducers.
How to change the crossover
Remove the terminal, note the position of the wires then carefully disconnect the wires from the transducers. Loosen
the two screws on each Speakon socket, undo the four screws from the crossover and remove the crossover from
the terminal.
Questo manuale è adatto per i seguenti modelli
2
Indice
Altri manuali Mach Altoparlanti
Mach
Mach CI4 Manuale utente
Mach
Mach CN12 Manuale utente
Mach
Mach TX112 mk II Manuale utente
Mach
Mach CN7 Manuale utente
Mach
Mach M Flex S Manuale utente
Mach
Mach CI4 Manuale utente
Mach
Mach Shine 420 Manuale utente
Mach
Mach MACH M62i Series Manuale utente
Mach
Mach CM Series Manuale utente
Mach
Mach Alien S51 Manuale utente
