EN
-6-
Pairing and connecting with a Bluetooth device
Every time the headphone is switched on, it will connect to the last
connected device automatically. When the headphone is in standby mode
and doesn’t connect to any HFP devices, short press MFB button once, it
will connect to last connected source device automatically.
To enter pairing mode, make sure the headphone is powered off then press
and hold the MFB key about 6 seconds until the headphone prompts the
“Power ON” and “Pairing” voice messages and the indicator LED blinks
red and blue alternately. From the Bluetooth function of the device to be
paired search for new device named “M-HPB20”. Select it and if requested
enter “0000” passcode. When pairing is completed successfully the
indicator LED blinks blue and the headphone prompts the “Pairing
Completed” voice message. If the pairing procedure is not successful,
please switch off the headphone and repeat the above steps. The specific
pairing procedure may vary, so please refer to your device user manual for
further information. Multilink technology allows simultaneous connection
of two different devices. To connect the second device simply repeat the
above procedure.
Re-connecting with a Bluetooth device
To adjust the headphone volume during a call
or while listening to music press the volume
up or down keys. When the volume is turned
to maximum or minimal levels, a “BIP” tone
is prompted. Please remember that excessive
sound pressure from headphones can damage
your hearing.
Adjust the Volume
