Makerfarm Prusa i3 Manuale utente
Laser Cut 8” i3 Prusa
This Guide has Hyper links, to use them please click File then Download and open the PDF
in your PDF Viewer, if you view the Guide online the Hyper links will not function
Thank you for purchasing the Laser Cut i3 Kit. To complete your build you will need a
couple other items.
Piece of Glass 215mm X 204mm (2.5mm to 3.5mm Thick, most hardware stores will cut it
to the size you need, Inside the USA Lowes or Home Depot)
Power Supply: http://www.staples.com/Antec-VP-450W-Power-Supply/product_928656 or
similar power supply (Your power supply will need to be able to output minimum 16amps at
12v)
You may also want some filament to print with after you have built your printer.
Makerfarm.com does sell filament and if you purchase it with your kit you will receive a
discount. If you want to purchase your filament somewhere else make sure you get high
quality filament, poor quality filament (Amazon and eBay) will jam and cause problems.
At any time if you have any questions feel free to e-mail or chat via google chat:
elderfarrer@gmail.com
Thanks,
Colin Farrer
Sales@MakerFarm.com
X Axis Assembly
Gather the following parts before watching the X Axis Video
1 x Assembled X Carriage
1 x Assembled X Idler
1 x Assembled X Motor
2 x 15.5” Smooth Rods
1 x X Belt cut to 32” Long, loop the ends and secure with a zip tie, the end result should
be a belt 29 7/8” long
X Axis Assembly Video
Y Bed
Gather the following parts before watching the Y Bed Video
9 x #6 1” Bolt
9 x #6 Lock Nuts
3 x LM8UU Bearings
For newer kits your heat bed mount will look different and have narrow slots for the
bearings, the lower Y bearing holders will also look different and one will be marked “Y
Endstop”, this one will be mounted in the front right corner of the heat bed mount (in the
picture above it will be under the top left bearing hole).
When installing the 1” bolts you will want to have the Nylon lock nuts under the heat bed,
also you will first want to install one bolt getting just one thread onto the locknut, then do
the same with the other bolt before tightening them both down.
Indice
Altri manuali Makerfarm Stampante 3D
