R60AFD2-Fall detection module using guide
501, West Block, Phase II, Tian 'an Innovation Technology Plaza, Futian District, Shenzhen
7. Radar Installation Instructions
7.1. Working range of radar module
beam coverage of the R60AFD2 radar module is shown in the figure below.
The radar coverage is a three-dimensional sector of 100 ° horizontally
and 100 ° vertically.
R60AFD2 radar coverage area
7.2. Radar installation direction and detection range
7.2.1 Wall-mounted tilting installation
*To ensure the accuracy of radar detection, please install it at an
angle of 45° !
radar is installed obliquely, and the inclination angle is 45 ° to
ensure that the main beam of the radar covers the detection area; the
recommended installation height of the radar is 2 meters ≤ H ≤ 2.4
meters , and it is recommended to install 2.2 meters by default. There
are no obvious obstructions and coverings in front of the radar.
Affected by the installation height of the radar and the range of the
radar beam, in this installation mode, the maximum radius of moving
human detection is R 3 ≈ 2.5 meters; the maximum radius of human
stationary detection is L2 ≈ 2.5 meters ; the maximum radius of fall
detection is L1 ≈ 2 meters.
Detection range
wall-mounted tilt radar when detecting human activity is about 6 meters
* 10 meters, the detection range when the human body is stationary is 4
meters * 5 meters , and the detection range of human falling is 4 meters
* 4 meters .
