Quick Start Guide
Commissioning the
Ruggedized 19’’ Gigabit Ethernet Switch with 10G Uplink Ports
4 MICROSENS GmbH & Co. KG, Kueferstr. 16, 59067 Hamm, Germany
5.2 Port Status LEDs
5.2.1 Ethernet (10/100Base-TX, s. Fig. 1, )
lnk (Link)
oOff ‒Link down, no connection.
oGreen ‒Link up
oGreen blinking ‒Port sending or receiving data.
PoE (Power-over-Ethernet, PSE)
oOff –PoE (role “PSE”) disabled.
oOrange –PoE or PoE+ enabled, port supplying power (role “PSE”active)
5.2.2 SFP/SFP+ (1000/10GBase-X, s. Fig. 1, )
lnk (Link)
oOff ‒ Link down, no connection.
oGreen ‒ Link up
oGreen blinking ‒ Port sending or receiving data.
6Reset Button
On the front of the housing there is a reset button (s. Fig. 1, ), which is accessible with a thin object.
Depending on the duration, pressing this button leads to one of the following actions when released:
approx. 1 s –Restarts the switch.
The running configuration (switch and management) remains unchanged.
The reboot takes approx. 90 s.
longer than 10 s –Switch is resetting on factory defaults and renews the SSH default keys
as well as self-signed certificates.
The reboot is extended by approx. 2 minutes.
Note:
Additionally, status messages are issued via the serial port.
7Access for Network Management
7.1 IP Address Assignment
In order for management over the network to function, the switch requires valid IP parameters (IP address,
subnet mask, and default gateway). These are obtained automatically via DHCP (factory-setting, s. section 3). If
you do not use DHCP in your network, you can setup the IP parameters via serial port access.
Note:
Via serial port access it is possible to setup additional management interfaces (Telnet, SSH, SNMP etc.). For
further information please refer to section 7.3 or the reference manual.
7.2 Serial Interface
1. Connect your computer via console cable to the serial port of the switch (s. Fig. 1, ).
2. Open a console program and setup the following connection parameters:
Speed: 115200 bit/s
Data bits: 8
Stop bits: 1
Parity bit: none
Flow control: none
3. Enter the credentials of the preset user (username: admin, password: admin, s. section 4) and click the
button “Enter”.
