6
5. Fault product replacement
The iRET module has completed the antenna-related
information configuration before leaving the factory (such as angle
range etc). Before replacing, please check whether the label
information of the new iRET module matches the antenna
information of the module to be replaced.
The steps of replacement are shown below:
Step 1: rotate the screw anti-clockwise to remove the screw. As
shown below:
Step 2: insert the new iRET module along the guide rails into the
antenna, tighten the screws clockwise, and re-connect the AISG
control cable. As shown below:
Note: If the UID of the new iRET module and the UID of the faulted
iRET module are not consistent, you can contact with customer
service (Tel: +86-0755-86186110) and provide the UID array
number (red dotted line as below) on the back of the original
antenna. Our company will arrange technical staff to change the
UID array number though the remote assistance or you can change
the UID array numbers by the tools that we provide. Antenna array
